Strain sensing, electrical and mechanical properties of polycarbonate/multiwall carbon nanotube monofilament fibers fabricated by melt spinning

Abstract Polycarbonate (PC)/multiwall carbon nanotube (MWCNT)/composites were prepared by melt mixing and subsequently melt spun to monofilament fibers. Electrical, mechanical and piezoresistive (strain sensing) properties of the fibers were evaluated as a function of the MWCNT weight concentration, which was varied up to 6 wt%. After the incorporation of MWCNTs, a decrease in electrical resistivity of the fibers was found for MWCNT concentrations as low as 2 wt%. Furthermore, an important effect of the draw down ratio (DDR) on the electrical properties of the fibers was observed. While the electrical percolation threshold (φ c ) for the bulk material was c was found to be highly dependent on the DDR. Stiffness and offset yield stress of the MWCNT/PC fibers were increased starting with the addition of 1 wt% of MWCNTs. However, decreased spinnability was observed for fibers with MWCNT concentrations above 4 wt%. The coefficient that relates the electrical resistance changes to the mechanical strain (strain gage factor S GF ) was estimated for fibers with MWCNTs amounts that range from 3.5 to 6 wt%. The highest S GF ∼16 was found at 3.5 wt% and the lowest S GF ∼2.5 at 6 wt% MWCNT. Smart multifunctional textiles, made from such conductive fibers, have wide applications such as structural health monitoring, detection of gases and liquids, sensor arrays and flexible sensors.

[1]  Qiang Fu,et al.  Superior reinforcement in melt-spun polyethylene/multiwalled carbon nanotube fiber through formation of a shish-kebab structure. , 2010, The journal of physical chemistry. B.

[2]  G. Heinrich,et al.  Development of conducting polychloroprene rubber using imidazolium based ionic liquid modified multi-walled carbon nanotubes , 2011 .

[3]  M. Terrones.  Science and Technology of the Twenty-First Century: Synthesis, Properties, and Applications of Carbon Nanotubes , 2003 .

[4]  A. Bhattacharyya,et al.  Morphology and electrical resistivity of melt mixed blends of polyethylene and carbon nanotube filled polycarbonate , 2003 .

[5]  A. May-Pat,et al.  Coupled electro-mechanical properties of multiwall carbon nanotube/polypropylene composites for strain sensing applications , 2013, Journal of Materials Science.

[6]  Satish Nagarajaiah,et al.  Nanotube film based on single-wall carbon nanotubes for strain sensing , 2004 .

[7]  Meifang Zhu,et al.  Vapor sensing properties of thermoplastic polyurethane multifilament covered with carbon nanotube networks , 2011 .

[8]  V. Popov.  Carbon Nanotubes: Properties and Applications , 2006 .

[9]  Zheng Hong Zhu,et al.  Carbon nanotube agglomeration effect on piezoresistivity of polymer nanocomposites , 2014 .

[10]  J. O. Aguilar,et al.  Strain sensing capabilities of a piezoresistive MWCNT-polysulfone film , 2010 .

[11]  Meifang Zhu,et al.  The use of a carbon nanotube layer on a polyurethane multifilament substrate for monitoring strains as large as 400 , 2012 .

[12]  Jinhyeong Kwon,et al.  Carbon nanotube based pressure sensor for flexible electronics , 2013 .

[13]  P. Pötschke,et al.  Liquid sensing: smart polymer/CNT composites , 2011 .

[14]  Tsu-Wei Chou,et al.  Nanocomposites in context , 2005 .

[15]  Frank Clemens,et al.  Comparison of Piezoresistive Monofilament Polymer Sensors , 2014, Sensors.

[16]  W. Blau,et al.  A comparative study of melt spun polyamide-12 fibres reinforced with carbon nanotubes and nanofibres , 2004 .

[17]  Chunyu Li,et al.  Sensors and actuators based on carbon nanotubes and their composites: A review , 2008 .

[18]  N. Kotov,et al.  Tailoring Piezoresistive Sensitivity of Multilayer Carbon Nanotube Composite Strain Sensors , 2008 .

[19]  F. Avilés,et al.  On the contribution of carbon nanotube deformation to piezoresistivity of carbon nanotube/polymer composites , 2013 .

[20]  K. Schulte,et al.  Piezoresistive response of epoxy composites with carbon nanoparticles under tensile load , 2009 .

[21]  G. Tröster,et al.  Sensor for Measuring Strain in Textile , 2008, Sensors.

[22]  Wang Luheng,et al.  Influence of carbon black concentration on piezoresistivity for carbon-black-filled silicone rubber composite , 2009 .

[23]  Sreenivasulu Tadakaluru,et al.  Stretchable and Flexible High-Strain Sensors Made Using Carbon Nanotubes and Graphite Films on Natural Rubber , 2014, Sensors.

[24]  E. Thomas,et al.  Morphology and properties of melt-spun polycarbonate fibers containing single- and multi-wall carbon nanotubes , 2006 .

[25]  R. Baughman,et al.  Carbon Nanotubes: Present and Future Commercial Applications , 2013, Science.

[26]  Ning Hu,et al.  Piezoresistive Strain Sensors Made from Carbon Nanotubes Based Polymer Nanocomposites , 2011, Sensors.

[27]  D. Yoon,et al.  Structural Health Monitoring for Carbon Fiber/Carbon Nanotube (CNT)/Epoxy Composite Sensor , 2006 .

[28]  John Robertson,et al.  Realistic applications of CNTs , 2004 .

[29]  H. Wagner,et al.  Sensors and sensitivity: Carbon nanotube buckypaper films as strain sensing devices , 2011 .

[30]  H. Brünig,et al.  Liquid sensing properties of fibres prepared by melt spinning from poly(lactic acid) containing multi-walled carbon nanotubes , 2010 .

[31]  F. Avilés,et al.  Self-sensing of elastic strain, matrix yielding and plasticity in multiwall carbon nanotube/vinyl ester composites , 2013 .

[32]  H. Brünig,et al.  Orientation of multiwalled carbon nanotubes in composites with polycarbonate by melt spinning , 2005 .

[33]  W. D. de Heer,et al.  Carbon Nanotubes--the Route Toward Applications , 2002, Science.

[34]  G. Heinrich,et al.  Polymer/carbon nanotube composites for liquid sensing: Model for electrical response characteristics , 2011 .

[35]  D. Mainwaring,et al.  Electromechanical response of semiconducting carbon-polyimide nanocomposite thin films , 2009 .

[36]  Myounggu Park,et al.  Strain-dependent electrical resistance of multi-walled carbon nanotube/polymer composite films , 2008, Nanotechnology.

[37]  Chuck Zhang,et al.  Processing and modeling of conductive thermoplastic/carbon nanotube films for strain sensing , 2008 .

[38]  N. Hu,et al.  Investigation on sensitivity of a polymer/carbon nanotube composite strain sensor , 2010 .

[39]  Khalid Lafdi,et al.  Carbon nanotubes grown on glass fiber as a strain sensor for real time structural health monitoring , 2012 .

[40]  Young-Ju Kim,et al.  Preparation of piezoresistive nano smart hybrid material based on graphene , 2011 .

[41]  K. Chandrashekhara,et al.  Smart fiber-reinforced polymer rods featuring improved ductility and health monitoring capabilities , 2001 .

[42]  E. Engeberg,et al.  Force and slip detection with direct-write compliant tactile sensors using multi-walled carbon nanotube/polymer composites , 2013 .

[43]  Jie Zhang,et al.  Glass Fibers with Carbon Nanotube Networks as Multifunctional Sensors , 2010 .

[44]  Xingjiu Huang,et al.  The new age of carbon nanotubes: an updated review of functionalized carbon nanotubes in electrochemical sensors. , 2012, Nanoscale.

[45]  D.D.L. Chung,et al.  TECHNICAL NOTE: A piezoresistive carbon filament polymer-matrix composite strain sensor , 1996 .

[46]  N. Hu,et al.  Tunneling effect in a polymer/carbon nanotube nanocompositestrain sensor , 2008 .

[47]  J. Cauich‐Rodríguez,et al.  Sensing of large strain using multiwall carbon nanotube/segmented polyurethane composites , 2013 .

[48]  A. Andrady,et al.  Chemical sensing using electrospun polymer/carbon nanotube composite nanofibers with printed-on electrodes , 2013 .