New Behavioral Modeling of EMI for DC Motors Applied to EMC Characterization

This paper is dealing with the characterization of the electromagnetic compatibility of the direct current (dc) motors. It acts as the complements of the works achieved recently for the modeling of dc motor impedances. The contact mechanisms between the brushes and the collector blades which cause the electromagnetic interferences (EMIs) are explained and modeled. Knowing the operating conditions of the current intensity, voltage, and speed, EMIs are measured and analyzed in radio frequencies from 100 kHz to 108 MHz. The behavioral model proposed is based on Norton's equivalent circuit where the motor is assumed as a current generator representing the EMI source, associated in parallel with its impedance model. Specific identification methods are used to quantify the EMI model parameters. It is shown that the model is in good correlation with the measurement. The model was applied for estimating the conducted EMI generated by a dc motor with its filters, and then, validations with different dc motors were performed.

[1]  R. Perdriau,et al.  EMC Assessment at Chip and PCB Level: Use of the ICEM Model for Jitter Analysis in an Integrated PLL , 2007, IEEE Transactions on Electromagnetic Compatibility.

[2]  Dushan Boroyevich,et al.  Parasitic Effects of Grounding Paths on Common-Mode EMI Filter's Performance in Power Electronics Systems , 2010, IEEE Transactions on Industrial Electronics.

[3]  Philippe Viarouge,et al.  Collector model for simulation of brush machines , 2010, Math. Comput. Simul..

[4]  Candace Rogers Suriano.  A STUDY OF DC PERMANENT MAGNET MOTOR NOISE RELATED TO LINE CURRENT , 1994 .

[5]  B. Kubicek,et al.  Modeling Moving Electric Arcs: Verification of a Coupled Fluid-Dynamics Magnetostatic Approach , 2008, IEEE Transactions on Magnetics.

[6]  Galina Mirzaeva,et al.  Evaluation of Current Density in DC Motor Brushes for Mining Machines Based on Air-Gap Field Measurement , 2010 .

[7]  Jens Benecke,et al.  Impedance and Emission Optimization of Low-Voltage DC Motors for EMC Compliance , 2011, IEEE Transactions on Industrial Electronics.

[8]  Luis Romeral,et al.  Modeling of Surface-Mounted Permanent Magnet Synchronous Motors With Stator Winding Interturn Faults , 2011, IEEE Transactions on Industrial Electronics.

[9]  Ahmed Faheem Zobaa,et al.  Optimal $C$-Type Passive Filter Based on Minimization of the Voltage Harmonic Distortion for Nonlinear Loads , 2012, IEEE Transactions on Industrial Electronics.

[10]  F. Duval,et al.  Automotive equipments EMC modeling for electrical network disturbances prediction , 2003, 2003 IEEE International Symposium on Electromagnetic Compatibility, 2003. EMC '03..

[11]  P. Viarouge,et al.  Arc Models for Simulation of Brush Motor Commutations , 2008, IEEE Transactions on Magnetics.

[12]  J. Rodgers,et al.  Thirteen ways to look at the correlation coefficient , 1988 .

[13]  Zhaoan Wang,et al.  Analysis of Insertion Loss and Impedance Compatibility of Hybrid EMI Filter Based on Equivalent Circuit Model , 2007, IEEE Transactions on Industrial Electronics.

[14]  Chris Tofallis.  Model Building with Multiple Dependent Variables and Constraints , 1999 .

[15]  J. Roudet,et al.  EMI study of a three phase inverter-fed motor drives , 2004, Conference Record of the 2004 IEEE Industry Applications Conference, 2004. 39th IAS Annual Meeting..

[16]  R.J. Hamilton.  DC motor brush life , 1998, Conference Record of 1998 IEEE Industry Applications Conference. Thirty-Third IAS Annual Meeting (Cat. No.98CH36242).

[17]  T. W. Holmes,et al.  Prediction of radiated emissions from DC motors , 1998, 1998 IEEE EMC Symposium. International Symposium on Electromagnetic Compatibility. Symposium Record (Cat. No.98CH36253).

[18]  Mauro Andriollo,et al.  Design Improvement of a Single-Phase Brushless Permanent Magnet Motor for Small Fan Appliances , 2010, IEEE Transactions on Industrial Electronics.

[19]  Zhaoan Wang,et al.  A Novel Hybrid Common-Mode EMI Filter With Active Impedance Multiplication , 2011, IEEE Transactions on Industrial Electronics.

[20]  Asaf Degani,et al.  Canonical Correlation Analysis: Use of Composite Heliographs for Representing Multiple Patterns , 2006, Diagrams.

[21]  Y Azzouz,et al.  New Behavioral Modeling for DC Motor Armatures Applied to Automotive EMC Characterization , 2010, IEEE Transactions on Electromagnetic Compatibility.