论文信息 - PREDICTION OF CUTTING FORCES IN MACHINING WITH RESTRICTED CONTACT TOOLS

PREDICTION OF CUTTING FORCES IN MACHINING WITH RESTRICTED CONTACT TOOLS

Abstract A semi-empirical method is described for predicting cutting forces in orthogonal machining with restricted contact tools. The method uses a well-established machining theory to predict cutting forces and tool-chip contact length for the corresponding plane face tool, i.e., a tool having the same cutting-edge geometry but no restricted contact. These predicted parameters and a set of empirical relations are then used to calculate the cutting forces for the restricted contact tool. A comparison between predicted and experimental results for two plain carbon steel work materials and a range of tool geometries and cutting conditions shows good agreement.

P.L.B. Oxley | Joseph A. Arsecularatne

[1] Bo Lindström,et al. A simple concept to achieve a rational chip form , 1995 .

[2] I. S. Jawahir,et al. A survey and future predictions for the use of chip breaking in unmanned systems , 1988 .

[3] Bo Lindström,et al. The effect of restricted contact length on tool performance , 1995 .

[4] I. S. Jawahir,et al. A knowledge-based approach for designing effective grooved chip breakers — 2D and 3D chip flow, chip curl and chip breaking , 1995 .

[5] C. Spaans. The fundamentals of three-dimensional chip curl, chip breaking and chip control , 1971 .

[6] M. C. Shaw,et al. Mechanics of Machining: An Analytical Approach to Assessing Machinability , 1989 .

[7] P.L.B. Oxley,et al. The Tool Restricted Contact Effect as a Major Influencing Factor in Chip Breaking: An Experimental Analysis , 1988 .

[8] P.L.B. Oxley,et al. Prediction of Chip Flow Direction and Cutting Forces in Oblique Machining with Nose Radius Tools , 1995 .

[9] Plb Oxley,et al. Efficient Chip Control at Reduced Power Consumption: An Experimental Analysis , 1988 .