Electromagnetic signals in very low frequency range (VLF, below 10kHz) can penetrate rock sufficiently in order to locate a miner with nearly no disturbance of the field structure, if the near field condition is fulfilled. The relevant solutions of Maxwell's equations for a magnetic dipole (transmitting antenna to be carried by the miner) in a dissipative medium then are independent of the medium. From these equations the magnetic field strength at any point of reception can be calculated. The key for the location method is the inverse distance function (locus curve), describing the possible location of the dipole from the measured field strength and direction at a point of reception (performed by the rescue team). At least two of these measurements give locus curves intersecting at two points, the correct solution can be found by means of an additional direction information calculated at the points of interest. A system has been built and successfully tested with miner's transmitters which can be activated by a coded signal from the rescue team, a receiver device measuring the field amplitude and field direction and a software package to calculate the miners's location on a notebook directly in the mine.
[1]
Frederick H. Raab.
Quasi-Static Magnetic-Field Technique for Determining Position And Orientation
,
1981,
IEEE Transactions on Geoscience and Remote Sensing.
[2]
James R. Wait,et al.
Analysis of source location errors for a magnetic dipole buried in a laterally inhomogeneous conducting earth
,
1976
.
[3]
P. K. Bhattacharya,et al.
Vertical Magnetic Dipole Buried Inside a Homogeneous Earth
,
1966
.
[4]
Richard G. Geyer,et al.
Constraints affecting through‐the‐earth electromagnetic signalling and location techniques
,
1976
.
[5]
A. J. Farstad,et al.
Electromagnetic direction finding experiments for location of trapped miners
,
1973
.