Experimental investigation of flow boiling heat transfer in novel oblique-finned microchannels

Abstract Oblique fins are modified from its conventional straight fins counterpart via the introduction of oblique cuts at specific locations, leaving obliquely-shaped fins with secondary microchannels. The benefits of having these secondary microchannels have been conclusively demonstrated in single-phase mode, however, they have yet to be tested in two-phase mode, which forms the motivation behind this study. Flow boiling experiments are conducted in the oblique-finned microchannel heat sink, made from a copper block with a footprint area of 25 × 25 mm 2 . 40 parallel microchannels, each with a nominal width of 0.3 mm are machined with wire-cut electro-discharge machining process. The nominal width of the oblique cuts, on the other hand, is half of that of the parallel microchannels. Tests are performed with FC-72 dielectric fluid with an inlet temperature of 29.5 °C, with a range of mass fluxes from 175 kg/m 2  s to 350 kg/m 2  s and heat fluxes from 6 W/cm 2 to 120 W/cm 2 . Flow boiling results and discussion on its heat transfer performance and pressure drop characteristics are presented in this paper. It is found that nucleate boiling is the dominant heat transfer mechanism at low heat fluxes, with a transition to convective boiling-dominant via thin-film evaporation occurring at medium heat fluxes. A full convective boiling mechanism is observed thereafter prior to CHF. These observations agreed well with high-speed flow visualisation images. Inlet pressure fluctuations within the oblique-finned microchannels are extremely small, indicating that the oblique fins are able to considerably stabilise the flow boiling process.

[1]  Suresh V. Garimella,et al.  Microchannel size effects on local flow boiling heat transfer to a dielectric fluid , 2008 .

[2]  Cheng-Tang Pan,et al.  Convective boiling in a parallel microchannel heat sink with a diverging cross section and artificial nucleation sites , 2011 .

[3]  A. Koşar,et al.  Boiling heat transfer in a hydrofoil-based micro pin fin heat sink , 2007 .

[4]  Siaw Kiang Chou,et al.  Flow boiling heat transfer and pressure drop in stepped fin microchannels , 2013 .

[5]  Yong Chan Kim,et al.  Flow boiling heat transfer coefficients and pressure drop of FC-72 in microchannels , 2012 .

[6]  Min-Soo Kim,et al.  The pressure drop in microtubes and the correlation development. , 2006 .

[7]  P. Lee,et al.  Experimental investigation of local flow boiling heat transfer and pressure drop characteristics in microgap channel , 2012 .

[8]  V. Dhir,et al.  Heat transfer and pressure drop in narrow rectangular channels , 2002 .

[9]  David F. Fletcher,et al.  An experimental study of gas–liquid flow in a narrow conduit , 2000 .

[10]  J. Taylor.  An Introduction to Error Analysis , 1982 .

[11]  S. Chou,et al.  Experimental investigations of flow boiling heat transfer and pressure drop in straight and expanding microchannels – A comparative study , 2011 .

[12]  S. J. Kline,et al.  Describing Uncertainties in Single-Sample Experiments , 1953 .

[13]  A. Agrawal,et al.  Impact of aspect ratio on flow boiling of water in rectangular microchannels , 2008 .

[14]  Xiao Hu,et al.  Experimental study of flow boiling of FC-72 in parallel minichannels under sub-atmospheric pressure , 2011 .

[15]  S. Garimella,et al.  Saturated flow boiling heat transfer and pressure drop in silicon microchannel arrays , 2008 .

[16]  S. Chou,et al.  Enhanced Thermal Transport in Microchannel Using Oblique Fins , 2012 .

[17]  Ibrahim Hassan,et al.  Two-phase pressure drop and flow visualization of FC-72 in a silicon microchannel heat sink , 2009 .

[18]  P. Lee,et al.  Effects of surface roughness on flow boiling in silicon microgap heat sinks , 2013 .

[19]  S. Saha,et al.  Heat transfer characteristics of flow boiling in a single horizontal microchannel , 2010 .

[20]  R. Blevins.  Applied Fluid Dynamics Handbook , 1984 .

[21]  I. Mudawar,et al.  Two-phase flow in high-heat-flux micro-channel heat sink for refrigeration cooling applications: Part II—heat transfer characteristics , 2005 .

[22]  Yongtaek Lee,et al.  Flow boiling heat transfer coefficients and pressure drops of FC-72 in small channel heat sinks , 2008 .

[23]  Siaw Kiang Chou,et al.  Numerical Study of Fluid Flow and Heat Transfer in the Enhanced Microchannel With Oblique Fins , 2013 .

[24]  S. Garimella,et al.  Measurements and High-Speed Visualizations of Flow Boiling of a Dielectric Fluid in a Silicon Microchannel Heat Sink † , 2006 .

[25]  John R. Thome,et al.  A new type of diabatic flow pattern map for boiling heat transfer in microchannels , 2007 .

[26]  Anthony J. Walton,et al.  Experimental investigation of non-uniform heating effect on flow boiling instabilities in a microchannel-based heat sink , 2009 .

[27]  Issam Mudawar,et al.  Transport Phenomena in Two-Phase Micro-Channel Heat Sinks , 2004 .

[28]  I. Mudawar,et al.  Flow boiling heat transfer in two-phase micro-channel heat sinks––I. Experimental investigation and assessment of correlation methods , 2003 .

[29]  W. Qu,et al.  Experimental study of saturated flow boiling heat transfer in an array of staggered micro-pin-fins , 2009 .