Validation of an open source CFD code to simulate natural ventilation for agricultural buildings

An open-source CFD was used to simulate natural ventilation of agricultural buildings.The effect of mesh size and turbulence model on the simulation accuracy was studied.Doubling meshes did not bring a ground-breaking improvement in simulation accuracy.Simulation results from the RNG k- model were dependent on the solution convergence.Simulation results from the low Re k- model were more reliant on the mesh size. To study natural ventilation for agricultural buildings, OpenFOAM, an open source CFD code, enables to develop tools that automate complex simulation procedures for nonprofessional CFD users. Prior to developing such tools, this paper investigates the accuracy of simulated air velocity in three test buildings according to different mesh sizes and turbulence models. The computed results, that were obtained using 13 different mesh sizes and 4 different k- turbulence models, were qualitatively and quantitatively compared to wind tunnel measurements by two validation metrics. The results showed that the smaller mesh size leads to slightly higher simulation accuracy, but an increase in the number of meshes above a certain level did not improve the simulation accuracy due to the problem of solution convergence. The mesh size larger than 0.25m at building walls was appropriate for the standard k- model and the RNG k- model, while a small mesh size of 0.125m was preferable for the low Re k- model. The simulation results, especially obtained from the RNG k- model, were highly influenced by whether the solution converged showing the relative error of on average 6.4% higher in the oscillatory solutions, while those from the low Re k- model were more dependent on the mesh size.

[1]  Simon J. Rees,et al.  Validation of a Detached Eddy Simulation (DES) Model in Complex Urban Environment , 2016 .

[2]  Shaojin Wang,et al.  PA—Precision Agriculture: Convective and Ventilation Transfers in Greenhouses, Part 1: the Greenhouse considered as a Perfectly Stirred Tank , 2002 .

[3]  Da-Wen Sun,et al.  Applications of computational fluid dynamics (CFD) in the modelling and design of ventilation systems in the agricultural industry: a review. , 2007, Bioresource technology.

[4]  Michael A. Sprague,et al.  A spectral-element/finite-element analysis of a ship-like structure subjected to an underwater explosion , 2006 .

[5]  Esam Jassim,et al.  Computational Fluid Dynamics Study for Flow of Natural Gas through High-pressure Supersonic Nozzles: Part 2. Nozzle Geometry and Vorticity , 2008 .

[6]  N. Jekabsons,et al.  Parametric Studies for Vertical Axis Wind Turbine Simulations , 2011 .

[7]  Bert Blocken,et al.  CFD analysis of cross-ventilation of a generic isolated building with asymmetric opening positions : impact of roof angle and opening location , 2015 .

[8]  Vasileios Exadaktylos,et al.  Automating CFD to calculate ventilation rate of a naturally ventilate building , 2014 .

[9]  T. Shih,et al.  A New K-epsilon Eddy Viscosity Model for High Reynolds Number Turbulent Flows: Model Development and Validation , 1994 .

[10]  Thierry Boulard,et al.  Review: Effect of ventilator configuration on the distributed climate of greenhouses: A review of experimental and CFD studies , 2010 .

[11]  Christian Masson,et al.  Turbulence modeling of atmospheric boundary layer flow over complex terrain: a comparison of models at wind tunnel and full scale , 2010 .

[12]  K. Murali,et al.  Application of low-Re turbulence models for flow simulations past underwater vehicle hull forms , 2009 .

[13]  Alvaro Marucci,et al.  Modelling of ammonia emissions from naturally ventilated livestock buildings. Part 1: Ammonia release modelling , 2013 .

[14]  Yoshihide Tominaga,et al.  AIJ guidelines for practical applications of CFD to pedestrian wind environment around buildings , 2008 .

[15]  Werner Berg,et al.  Flow fields within a dairy barn - Measurements, physical modeling and numerical simulation , 2014 .

[16]  P. S. Els,et al.  Validation metric based on relative error , 2012 .

[17]  Hrvoje Jasak,et al.  OpenFOAM: Open source CFD in research and industry , 2009 .

[18]  T. Shih,et al.  A new k-ϵ eddy viscosity model for high reynolds number turbulent flows , 1995 .

[19]  B. Launder,et al.  THE NUMERICAL COMPUTATION OF TURBULENT FLOW , 1974 .

[20]  Jessie P. Bitog,et al.  The past, present and future of CFD for agro-environmental applications , 2013 .

[21]  Bert Blocken,et al.  50 years of Computational Wind Engineering: Past, present and future , 2014 .

[22]  Guoqiang Zhang,et al.  Summary of best guidelines and validation of CFD modeling in livestock buildings to ensure prediction quality , 2016, Comput. Electron. Agric..

[23]  G. Candler,et al.  Convergence improvement of two-equation turbulence model calculations , 1998 .

[24]  Maciej Chmielewski,et al.  Three-zonal Wall Function for k-ε Turbulence Models , 2013 .

[25]  S. Hooman Hoseini,et al.  Determination of Discharge Coefficient of Rectangular Broad-Crested Side Weir in Trapezoidal Channel by CFD , 2013 .

[26]  Alexander Ivchenko.  Incorporation of OpenFOAM software into Computational Fluid Dynamics process in Volvo Technology , 2011 .

[27]  In-Bok Lee,et al.  PIV VERIFICATION OF GREENHOUSE VENTILATION AIR FLOWS TO EVALUATE CFD ACCURACY , 2005 .

[28]  In-Bok Lee,et al.  Evaluation of CFD Accuracy for the Ventilation Study of a Naturally Ventilated Broiler House , 2007 .

[29]  Alessandro Parente,et al.  RANS simulation of ABL flow over complex terrains applying an enhanced k-ε model and wall function formulation , 2012 .

[30]  Eric Furbo.  Evaluation of RANS turbulence models for flow problems with signigicant impact of boundary layers , 2010 .

[31]  In-Bok Lee,et al.  Web-based forecasting system for the airborne spread of livestock infectious disease using computational fluid dynamics , 2014, Biosystems Engineering.

[32]  H. Medina,et al.  Open source Computational Fluid Dynamics using , 2015 .

[33]  Christian Ammon,et al.  Air velocity measurements using ultrasonic anemometers in the animal zone of a naturally ventilated dairy barn , 2013 .

[34]  Bje Bert Blocken,et al.  CFD simulation of cross-ventilation for a generic isolated building : impact of computational parameters , 2012 .

[35]  B. Launder,et al.  The numerical computation of turbulent flows , 1990 .