Acoustic emission study of fatigue crack propagation in extruded AZ31 magnesium alloy

The fatigue crack propagation behavior and corresponding AE characteristics of extruded AZ31 magnesium (Mg) alloy were investigated in this study. The effects of specimen orientation and loading frequency were considered. By combining the AE parameter and waveform analysis with the micro-structural and fractograph observations, the findings of the study showed that crack extension and twinning at the crack tip were two major AE source mechanisms during fatigue crack propagation in the Mg alloy. More twinning events were observed in the transverse direction (TD) specimens than in the extruded direction specimens, which contributed to more cyclic deformation irreversibility and cumulative fatigue damage, leading to worse fatigue performance and higher AE counts in the TD specimens. The results also indicated that increasing the loading frequency could slightly increase the fatigue life, and significantly decrease the AE counts in TD specimens due to the frequency or strain rate dependence of twinning activity. These results suggest that twinning plays an important role in the fatigue process in this Mg alloy, and that the AE technique is capable of detecting crack propagation and twinning events during fatigue.

[1]  R. Reed-hill,et al.  The crystallographic characteristics of fracture in magnesium single crystals , 1957 .

[2]  Z. Zhang,et al.  Fatigue properties of rolled magnesium alloy (AZ31) sheet: Influence of specimen orientation , 2011 .

[3]  Hongyun Luo,et al.  Effects of micro-structure on fatigue crack propagation and acoustic emission behaviors in a micro-alloyed steel , 2013 .

[4]  A. Weidner,et al.  Kinetics of deformation processes in high-alloyed cast transformation-induced plasticity/twinning-induced plasticity steels determined by acoustic emission and scanning electron microscopy: Influence of austenite stability on deformation mechanisms , 2013 .

[5]  Y. Estrin,et al.  Effect of grain size on the mechanisms of plastic deformation in wrought Mg-Zn-Zr alloy revealed by acoustic emission measurements , 2013 .

[6]  E. Han,et al.  A critical discussion on influence of loading frequency on fatigue crack propagation behavior for extruded Mg-Al-Zn alloys , 2012 .

[7]  Hongyun Luo,et al.  Acoustic emission during fatigue crack propagation in a micro-alloyed steel and welds , 2011 .

[8]  Fan Yang,et al.  Crack initiation mechanism of extruded AZ31 magnesium alloy in the very high cycle fatigue regime , 2008 .

[9]  J. Knap,et al.  Army Research Laboratory Aberdeen Proving Ground , MD 21005-5069 ARL-RP-448 July 2013 Phase-Field Analysis of Fracture-Induced Twinning in Single Crystals , 2013 .

[10]  Y. Kawakami,et al.  Fatigue properties of rolled AZ31B magnesium alloy plate , 2010 .

[11]  Ke Wei,et al.  Acoustic emission study of fatigue crack closure of physical short and long cracks for aluminum alloy LY12CZ , 2009 .

[12]  S. Ishihara,et al.  Anisotropy of the fatigue behavior of extruded and rolled magnesium alloys , 2013 .

[13]  Yanyao Jiang,et al.  An experimental study of fatigue crack propagation in extruded AZ31B magnesium alloy , 2013 .

[14]  Lallit Anand,et al.  A constitutive model for hcp materials deforming by slip and twinning: application to magnesium alloy AZ31B , 2003 .

[15]  M. Nakajima,et al.  Fatigue crack propagation and fracture mechanisms of wrought magnesium alloys in different environments , 2009 .

[16]  Y. Mutoh,et al.  Effect of frequency on fatigue crack growth behavior of magnesium alloy AZ61 under immersed 3.5 mass% NaCl environment , 2011 .

[17]  T. M. Roberts,et al.  Fatigue life prediction based on crack propagation and acoustic emission count rates , 2003 .

[18]  Tadanobu Inoue,et al.  Deformation mechanism near crack-tip by finite element analysis and microstructure observation in magnesium alloys , 2010 .

[19]  B. Clausen,et al.  Influence of strain rate on mechanical properties and deformation texture of hot-pressed and rolled beryllium , 2010 .

[20]  Daining Fang,et al.  Study of fatigue crack characteristics by acoustic emission , 1995 .

[21]  C. Davies,et al.  Twinning-induced negative strain rate sensitivity in wrought Mg alloy AZ31 , 2011 .

[22]  Baldev Raj,et al.  Influence of micro structure on acoustic emission behavior during stage 2 fatigue crack growth in solution annealed, thermally aged and weld specimens of AISI type 316 stainless steel , 1996 .

[23]  M. Janeček,et al.  Investigating deformation processes in AM60 magnesium alloy using the acoustic emission technique , 2006 .

[24]  E. Han,et al.  Influence of microstructure on tensile properties and fatigue crack growth in extruded magnesium alloy AM60 , 2010 .

[25]  M. Barnett,et al.  Investigation of deformation twinning in a fine-grained and coarse-grained ZM20 mg alloy : combined in situ neutron diffraction and acoustic emission , 2010 .

[26]  M. Yoo.  The elastic energy of slit cracks in hexagonal crystals , 1979 .

[27]  Y. H. Zhao,et al.  Strain-rate sensitivity of textured Mg–3.0Al–1.0Zn alloy (AZ31) under impact deformation , 2011 .

[28]  K. Ishikawa,et al.  Environmental effect of fatigue crack propagation of magnesium alloy , 1997 .

[29]  P. Liaw,et al.  Twinning–detwinning behavior during the strain-controlled low-cycle fatigue testing of a wrought magnesium alloy, ZK60A , 2008 .

[30]  Y. Estrin,et al.  Cyclic deformation of a magnesium alloy investigated by the acoustic emission technique , 2004 .

[31]  Seong-Gu Hong,et al.  Effect of anisotropy on the low-cycle fatigue behavior of rolled AZ31 magnesium alloy , 2010 .

[32]  K. Masaki,et al.  High Cycle Fatigue Property and Micro Crack Propagation Behavior in Extruded AZ31 Magnesium Alloys , 2006 .

[33]  S. Suresh.  Fatigue of materials , 1991 .

[34]  M. Yoo.  Slip, twinning, and fracture in hexagonal close-packed metals , 1981 .