Experimental and modeling investigation of the effect of air preheat on the formation of NOx in an RQL combustor

The Rich-burn/Quick–mix/Lean-burn (RQL) combustor concept has been proposed to minimize the formation of oxides of nitrogen (NOx) in gas turbine systems. The success of this low-NOx combustor strategy is dependent upon the links between the formation of NOx, inlet air preheat temperature, and the mixing of the jet air and fuel-rich streams. Chemical equilibrium and kinetics modeling calculations and experiments were performed to further understand NOx emissions in an RQL combustor. The results indicate that as the temperature at the inlet to the mixing zone increases (due to preheating and/or operating conditions) the fuel-rich zone equivalence ratio must be increased to achieve minimum NOx formation in the primary zone of the combustor. The chemical kinetics model illustrates that there is sufficient residence time to produce NOx at concentrations that agree well with the NOx measurements. Air preheat was found to have very little effect on mixing, but preheating the air did increase NOx emissions significantly. By understanding the mechanisms governing NOx formation and the temperature dependence of key reactions in the RQL combustor, a strategy can be devised to further reduce NOx emissions using the RQL concept.

[1]  A. F. Bicen,et al.  Combustion characteristics of a model can-type combustor , 1990 .

[2]  C. E. Smith,et al.  Mixing of Multiple Jets With a Confined Subsonic Crossflow: Part I—Cylindrical Duct , 1997 .

[3]  James D. Holdeman,et al.  Spreadsheet calculations of jets in crossflow: opposed rows of inline and staggered round holes , 2012 .

[4]  James D. Holdeman,et al.  Spreadsheet Calculations for Jets in Crossflow: Opposed Rows of Inline and Staggered Holes and Single and Opposed Rows with Alternating Hole Sizes , 2010 .

[5]  G. Samuelsen,et al.  Assessing Jet-Induced Spatial Mixing in a Rich, Reacting Crossflow , 2013 .

[6]  Robert J. Shaw.  Engine technology challenges for a 21st Century High-Speed Civil Transport , 1993 .

[7]  R. Koch,et al.  Study of NOx emission characteristics in pressurized staged combustor concepts , 1994 .

[8]  James A. Miller,et al.  Mechanism and modeling of nitrogen chemistry in combustion , 1989 .

[9]  C. P. Fenimore,et al.  Reactions of fuel-nitrogen in rich flame gases , 1976 .

[10]  K. M. Sundaram,et al.  Kinetics of coke deposition in the thermal cracking of propane , 1979 .

[11]  A. O. Demuren,et al.  Modeling jets in cross flow , 1994 .

[12]  G. Samuelsen,et al.  Mixing of Jet Air with a Fuel-Rich, Reacting Crossflow , 1999 .

[13]  Robert J. Kee,et al.  CHEMKIN-III: A FORTRAN chemical kinetics package for the analysis of gas-phase chemical and plasma kinetics , 1996 .

[14]  G. S. Samuelsen,et al.  Optimization of Jet Mixing into a Rich, Reacting Crossflow , 2000 .

[15]  James A. Miller,et al.  The Chemkin Thermodynamic Data Base , 1990 .

[16]  C. Richards,et al.  The role of primary jet injection on mixing in gas turbine combustion , 1991 .

[17]  James D. Holdeman,et al.  Spreadsheet Calculation of Jets in Crossfl ow: Opposed Rows of Slots Slanted at 45 , 2011 .

[18]  G. Samuelsen,et al.  Optimization of orifice geometry for crossflow mixing in a cylindrical duct , 1994 .

[19]  James R. Clisset,et al.  A Spreadsheet for the Mixing of a Row of Jets with a Confined Crossflow. Supplement , 2005 .

[20]  D. Trimm.  Kinetics of coke deposition in the thermal cracking of propane , 1981 .

[21]  David S. Liscinsky,et al.  Mixing of Multiple Jets With a Confined Subsonic Crossflow: Part II—Opposed Rows of Orifices in Rectangular Ducts , 1999 .

[22]  R. J. Kee,et al.  Chemkin-II : A Fortran Chemical Kinetics Package for the Analysis of Gas Phase Chemical Kinetics , 1991 .

[23]  R. Barat,et al.  Minimization of NO during staged combustion of CH3NH2 , 1996 .

[24]  Sanford Gordon,et al.  Computer program for calculation of complex chemical equilibrium compositions , 1972 .

[25]  James D. Holdeman,et al.  On the Mixing of Single and Opposed Rows of Jets With a Confined Crossflow , 2006 .

[26]  James D Holdeman,et al.  Mixing of multiple jets with a confined subsonic crossflow , 1996 .

[27]  J. D. Holdeman,et al.  Jet mixing into a heated cross flow in a cylindrical duct: Influence of geometry and flow variations , 1992 .

[28]  C. G. W. Sheppard,et al.  Measurements of Mixing and Species Concentrations Within a Gas Turbine Type Combustor , 1981 .

[29]  M. Heitor,et al.  Velocity, temperature, and species characteristics of the flow in a gas-turbine combustor , 1986 .

[30]  Clarence T. Chang,et al.  Mixing of Multiple Jets with a Confined Subsonic Crossflow: Part III--The Effects of Air Preheat and Number of Orifices on Flow and Emissions in an RQL Mixing Section , 2007 .

[31]  A. Lefebvre.  Gas Turbine Combustion , 1983 .

[32]  Richard J. Margason,et al.  Fifty Years of Jet in Cross Flow Research , 1993 .