Plant characteristics of an integrated solid oxide fuel cell cycle and a steam cycle

Plant characteristics of a system containing a solid oxide fuel cell (SOFC) cycle on the top of a Rankine cycle were investigated. A desulfurization reactor removes the sulfur content in the fuel, while a pre-reformer broke down the heavier hydrocarbons in an adiabatic steam reformer (ASR). The pre-treated fuel then entered to the anode side of the SOFC. The remaining fuels after the SOFC stacks entered a catalytic burner for further combusting. The burned gases from the burner were then used to produce steam for the Rankine cycle in a heat recovery steam generator (HRSG). The remaining energy of the off-gases was recycled back to the topping cycle for further utilization. Several parameter studies were carried out to investigate the sensitivity of the suggested plant. It was shown that the operation temperature of the desulfurization and the pre-reformer had no effect on the plant efficiency, which was also true when decreasing the anode temperature. However, increasing the cathode temperature had a significant effect on the plant efficiency. In addition, decreasing the SOFC utilization factor from 0.8 to 0.7, increases the plant efficiency by about 6%. An optimal plant efficiency of about 71% was achieved by optimizing the plant.

[1]  J. Smith,et al.  Introduction to chemical engineering thermodynamics , 1949 .

[2]  Noam Lior,et al.  Combining fuel cells with fuel-fired power plants for improved exergy efficiency , 1991 .

[3]  Francesco Calise,et al.  Single-level optimization of a hybrid SOFC-GT power plant , 2006 .

[4]  Hermann Hofbauer,et al.  Coupling of Biomass Steam Gasification and an SOFC-Gas Turbine Hybrid System for Highly Efficient Electricity Generation , 2004 .

[5]  Dieter Froning,et al.  Clean combined-cycle SOFC power plant — cell modelling and process analysis , 2000 .

[6]  J. Warner,et al.  Combined - Cycle Gas & Steam Turbine Power Plants , 1999 .

[7]  Kevin R. Keegan,et al.  Analysis of a Planar Solid Oxide Fuel Cell Based Automotive Auxiliary Power Unit , 2002 .

[8]  Rory A. Roberts,et al.  Dynamic Simulation of a Pressurized 220kW Solid Oxide Fuel-Cell–Gas-Turbine Hybrid System: Modeled Performance Compared to Measured Results , 2006 .

[9]  Brian Elmegaard,et al.  DNA – A General Energy System Simulation Tool , 2005 .

[10]  Lars Sjunnesson,et al.  Combined solid oxide fuel cell and gas turbine systems for efficient power and heat generation , 2000 .

[11]  Urmila M. Diwekar,et al.  Characterization and quantification of uncertainty in solid oxide fuel cell hybrid power plants , 2005 .

[12]  Jai-Woh Kim,et al.  The Effect of Anode Thickness on the Performance of Anode-Supported Solid Oxide Fuel Cells , 1999 .

[13]  Timo Kivisaari,et al.  Conceptual study of a 250 kW planar SOFC system for CHP application , 2004 .

[14]  Christian Wächter,et al.  Dynamic Model of a Pressurized SOFC/Gas Turbine Hybrid Power Plant for the Development of Control Concepts , 2006 .

[15]  Masoud Rokni,et al.  Thermodynamic analysis of an integrated solid oxide fuel cell cycle with a rankine cycle , 2010 .

[16]  Aristide F. Massardo,et al.  Design and part-load performance of a hybrid system based on a solid oxide fuel cell reactor and a micro gas turbine , 2001 .