Complex Aeroengine Intake Ducts and Dynamic Distortion

For many embedded engine systems, the intake duct geometry introduces flow distortion and unsteadiness, which must be understood when designing the turbomachinery components. The aim of this work i...

[1]  P. Roache.  Perspective: A Method for Uniform Reporting of Grid Refinement Studies , 1994 .

[2]  G. Mitchell.  Effect of inlet ingestion of a wing tip vortex on turbojet stall margin , 1974 .

[3]  Patrick J. Roache,et al.  Verification and Validation in Computational Science and Engineering , 1998 .

[4]  J. Lumley.  Stochastic tools in turbulence , 1970 .

[5]  Thomas Breuer,et al.  Basic Principles – Gas Turbine Compatibility – Intake Aerodynamic Aspects , 2010 .

[6]  E. Garnier.  Flow Control by Pulsed Jet in a Curved S-Duct: A Spectral Analysis , 2015 .

[7]  L. Sirovich.  TURBULENCE AND THE DYNAMICS OF COHERENT STRUCTURES PART I : COHERENT STRUCTURES , 2016 .

[8]  Eric Garnier,et al.  Flow Control in a High-Offset Subsonic Air Intake , 2011 .

[9]  L. Fottner,et al.  The influence of intake swirl distortion on the steady-state performance of a low bypass, twin-spool engine , 1992 .

[10]  William T. Cousins,et al.  HISTORY, PHILOSOPHY, PHYSICS, AND FUTURE DIRECTIONS OF AIRCRAFT PROPULSION SYSTEM / INLET INTEGRATION , 2004 .

[11]  S. Deck.  Recent improvements in the Zonal Detached Eddy Simulation (ZDES) formulation , 2012 .

[12]  Thomas M. Berens,et al.  DES Computations for a Subsonic UAV Configuration with a Highly Integrated S-Shaped Intake Duct , 2014 .

[13]  J. Seddon,et al.  Intake Aerodynamics, Second Edition , 1999 .

[14]  William T. Cousins,et al.  The Dynamics of Stall and Surge Behavior in Axial-Centrifugal Compressors , 1997 .

[15]  Julio Soria,et al.  Particle image velocimetry measurements of a backward-facing step flow , 2002 .

[16]  Anne-Laure Delot,et al.  A Comparison of Several CFD Codes with Experimental Data in a Diffusing S-Duct , 2013 .

[17]  Ramesh K. Agarwal,et al.  Simulation of Secondary and Separated Flow in Diffusing S Ducts , 2015 .

[18]  D. N. Bowditch,et al.  A survey of inlet/engine distortion compatibility , 1983 .

[19]  P. Spalart.  Detached-Eddy Simulation , 2009 .

[20]  Christer Fureby,et al.  Large-Eddy Simulation: Current Capabilities, Recommended Practices, and Future Research , 2009 .

[21]  Roi Gurka,et al.  POD of vorticity fields: A method for spatial characterization of coherent structures , 2006 .

[22]  L. Sirovich.  Turbulence and the dynamics of coherent structures. I. Coherent structures , 1987 .

[23]  Julio Soria,et al.  A comparison between snapshot POD analysis of PIV velocity and vorticity data , 2005 .

[24]  D. MacManus,et al.  Flow Distortion Measurements in Convoluted Aeroengine Intakes , 2016 .

[25]  Theodore H. Okiishi,et al.  A study of the compressible flow through a diffusing S-duct , 1993 .

[26]  P. Holmes,et al.  The Proper Orthogonal Decomposition in the Analysis of Turbulent Flows , 1993 .

[27]  Ramis Örlü,et al.  POD analysis of the turbulent flow downstream a mild and sharp bend , 2015 .

[28]  David G. MacManus,et al.  Computational and experimental study of intake ground vortices , 2010, The Aeronautical Journal (1968).

[29]  Eric Garnier,et al.  Flow Control By Pulsed Jet In A Highly Bended S-Duct , 2012 .

[30]  P. Spalart,et al.  A New Version of Detached-eddy Simulation, Resistant to Ambiguous Grid Densities , 2006 .

[31]  M. Chevalier,et al.  Detached Eddy Simulation of Turbulent Flow in a Highly Offset Intake Diffuser , 2010 .

[32]  Gary J. Harloff,et al.  Navier-Stokes analysis and experimental data comparison of compressible flow in a diffusing S-duct , 1992 .

[33]  P. Holmes,et al.  Turbulence, Coherent Structures, Dynamical Systems and Symmetry , 1996 .

[34]  G. Mitchell.  Effect of inlet ingestion of a wing tip vortex on compressor face flow and turbojet stall margin , 1975 .

[35]  J. van Muijden,et al.  Numerical simulations for high offset intake diffuser flows , 2014 .

[36]  Hao Chen,et al.  A practical guide for using proper orthogonal decomposition in engine research , 2013 .