Power-handling capability for RF filters

A simplified method for evaluating the power-handling capability inside an RF filter has been introduced based on the general cross-coupled prototype network theory, modern EM modeling techniques, and well-established breakdown threshold analysis. The electrical field strength and voltages evaluated using either the single-cavity resonator (eigen mode) model or simply the prototype model have been presented and compared against the direct EM computation of the complete filter structure. Close agreement has been found between the full EM modeling and the scaling of a single resonator or even prototype network analysis only. This procedure is expected to simplify the multipaction and ionization breakdown analysis of filters and filter-based diplexers and multiplexers. The method presented is general and is applicable to all filter types that can be described in a circuit model. Practical issues such as the multicarrier operation, sharp edge condition, design margin, and prevention techniques are also covered.

[1]  R. Woo,et al.  RF voltage breakdown in coaxial transmission lines , 1969 .

[2]  P. T. Lewin,et al.  Thermal Lowering of the Threshold for Microwave Breakdown in Air-Filled Waveguides , 1987 .

[3]  A. D. Macdonald.  Microwave breakdown in gases , 1966 .

[4]  Albert J. Hatch,et al.  MULTIPACTING MODES OF HIGH-FREQUENCY GASEOUS BREAKDOWN , 1958 .

[5]  Paul Burns.  Software Defined Radio for 3G , 2003 .

[6]  Raafat R. Mansour,et al.  Microwave Filters for Communication Systems: Fundamentals, Design and Applications , 2007 .

[7]  Jr. R. Wyndrum.  Microwave filters, impedance-matching networks, and coupling structures , 1965 .

[8]  T. Olsson,et al.  On the effective diffusion length for microwave breakdown , 2006, IEEE Transactions on Plasma Science.

[9]  L. Young,et al.  Peak Internal Fields in Direct-Coupled-Cavity Filters , 1960 .

[10]  G. Rosati,et al.  Minimizing passive intermodulation product generation in high power satellites , 1996, 1996 IEEE Aerospace Applications Conference. Proceedings.

[11]  V. Postoyalko,et al.  Relationship between group delay and stored energy in microwave filters , 2001 .

[12]  K.A. Zaki,et al.  Analysis of power handling capacity of band pass filters , 2001, 2001 IEEE MTT-S International Microwave Sympsoium Digest (Cat. No.01CH37157).

[13]  Richard J. Cameron,et al.  Peak voltage analysis in high power microwave filters , 2000 .

[14]  V. Postoyalko,et al.  Prediction of peak internal fields in direct-coupled-cavity filters , 2003 .

[15]  T. Olsson,et al.  Investigations of time delays in microwave breakdown initiation , 2006 .

[16]  T. Olsson,et al.  Microwave breakdown in air for multi-carrier, modulated or stochastically time varying RF fields , 2003 .

[17]  V. Postoyalko,et al.  Comparison of the stored energy distributions in a QC-type and a TC-type prototype with the same power transfer function , 1999, 1999 IEEE MTT-S International Microwave Symposium Digest (Cat. No.99CH36282).

[18]  T. Olsson,et al.  Microwave Breakdown in RF Devices Containing Sharp Corners , 2006, 2006 IEEE MTT-S International Microwave Symposium Digest.

[19]  Ming Yu,et al.  A simplified analysis for high power microwave bandpass filter structures , 2000, 2000 IEEE MTT-S International Microwave Symposium Digest (Cat. No.00CH37017).

[20]  T. Olsson,et al.  Microwave breakdown in resonators and filters , 1999 .