A computational fluid dynamic model of the heat and moisture transfer during beef chilling

The unsteady heat and mass transfer process during beef carcass chilling was modelled for a three-dimensional beef carcass geometry. A three-step method was used to simulate the simultaneous heat and mass transfer process in order to reduce the computational time. In the first step, a steady state simulation of the flow field was conducted. In the second step, the local heat and mass transfer coefficients were calculated. Finally, the third step consists of the simultaneous heat and mass transfer process simulation on the meat carcass only. A separate 1-D grid was used to calculate the moisture diffusion in the meat. The simulation of a 20-h chilling run takes 5 days on a 2.5 GHz Pentium 4 computer. The model allows calculating and predicting the heat load, temperatures, weight loss and water activity. Local variations in the heat and mass transfer coefficients, temperature and water activity were found around the beef carcass. The CFD model gives temperature predictions that agree with experimental data better than any previous model. The weight loss tends to be over-predicted probably due to neglecting the resistance caused by the fat cover.

[1]  Josse De Baerdemaeker,et al.  The local surface heat transfer coefficient in thermal food process calculations: A CFD approach , 1997 .

[2]  A. C Cleland,et al.  Prediction of chilling times of foods in situations where evaporative cooling is significant—Part 1. Method development , 1998 .

[3]  Q. Pham,et al.  A multi-layered two-dimensional finite element model to calculate dynamic product heat load and weight loss during beef chilling , 2000 .

[4]  Da-Wen Sun,et al.  CFD simulation of heat and moisture transfer for predicting cooling rate and weight loss of cooked ham during air-blast chilling process , 2000 .

[5]  M. Wolfshtein.  The velocity and temperature distribution in one-dimensional flow with turbulence augmentation and pressure gradient , 1969 .

[6]  Pierre-Sylvain Mirade,et al.  Three-dimensional CFD calculations for designing large food chillers , 2002 .

[7]  J. Daudin,et al.  Determination of transfer coefficients by psychrometry , 1993 .

[8]  Jean-Dominique Daudin,et al.  Modelling of temperature and weight loss kinetics during meat chilling for time-variable conditions using an analytical-based method - I. The model and its sensitivity to certain parameters , 1996 .

[9]  A. C Cleland,et al.  A new method of predicting the time-variability of product heat load during food cooling — Part 1: Theoretical considerations , 1993 .

[10]  Q. Pham,et al.  Moisture sorption isotherm of fresh lean beef and external beef fat , 2003 .

[11]  Alain Kondjoyan,et al.  Heat and mass transfer coefficients at the surface of a pork hindquarter , 1997 .

[12]  B. A. Kader.  Temperature and concentration profiles in fully turbulent boundary layers , 1981 .

[13]  Local surface heat transfer coefficients on a model lamb carcass , 2004 .

[14]  Francisco J. Trujillo,et al.  Drying modeling and water diffusivity in beef meat , 2007 .

[15]  Da-Wen Sun,et al.  Predicting local surface heat transfer coefficients by different turbulent k-ϵ models to simulate heat and moisture transfer during air-blast chilling , 2001 .

[16]  Gauri S. Mittal,et al.  Heat and mass transfer during beef carcass chilling — Modelling and simulation , 1994 .

[17]  Q. Pham,et al.  Predicting the dynamic product heat load and weight loss during beef chilling using a multi-region finite difference approach , 1997 .