Microcellular foam is a polymeric foam with bubble sizes of 10 microns or less that is produced by saturating a polymer with gas and then utilizing the thermodynamic instabilities that result when the polymer is heated and the pressure is reduced to nucleate the cells. A model for the nucleation of microcellular foam in amorphous polymers with additives has been developed. The nucleation process depends on the solubility, concentration, and interfacial energy of any additives present. At very low levels, additives in solution act to increase the free volume of the polymer, resulting in homogeneous nucleation within the free volume Well above the solubility limit, heterogeneous nucleation dominates, as it lowers the activation energy for nucleation to levels below that for homogeneous nucleation. In the vicinity of the solubility limit of the additive, these two nucleation mechanisms compete. The polystyrene-zinc stearate system has been chosen for experimental evaluation.
[1]
Jonathan S. Colton,et al.
The nucleation of microcellular thermoplastic foam with additives: Part II: Experimental results and discussion
,
1987
.
[2]
Nam P. Suh,et al.
Processing of microcellular polyester composites
,
1985
.
[3]
F. Frank,et al.
The strength and stiffness of polymers
,
1970,
Proceedings of the Royal Society of London. A. Mathematical and Physical Sciences.
[4]
Frederick R. Eirich,et al.
Rheology : theory and applications
,
1956
.
[5]
K. C. Russell.
Nucleation in solids: The induction and steady state effects
,
1980
.
[6]
W. Sachse,et al.
Effects of high‐pressure CO2 on the glass transition temperature and mechanical properties of polystyrene
,
1982
.