Large-Scale Passive Earth Pressure Load-Displacement Tests and Numerical Simulation

Passive earth pressure is recorded in two different tests, using a 6.7-m long, 2.9-m wide soil container. In these tests, sand with 7% silt content is densely compacted behind a moveable test wall to a supported height of 1.68 m (5.5 ft). Lateral load is applied to the vertical reinforced concrete wall section, which displaces freely along with the adjacent backfill in the horizontal and vertical directions. The recorded passive resistance is found to increase until a peak is reached at a horizontal displacement of 2.7–3% of the supported backfill height, decreasing thereafter to a residual level. In this test configuration, a triangular failure wedge shape is observed, due to the low mobilized wall-soil friction. Backfill strength parameters are estimated based on this observed failure mechanism. From these estimates, along with triaxial and direct shear test data, theoretical predictions are compared with the measured passive resistance. Using the test data, a calibrated finite-element model is employed...

[1]  Bhavik Rameshchandra Shah.  3D finite element analysis of integral abutment bridges subjected to thermal loading , 2007 .

[2]  Adel Hanna,et al.  Determination of plane-strain shear strength of sand from the results of triaxial tests , 2001 .

[3]  F. Jeng,et al.  The deformation of overburden soil induced by thrust faulting and its impact on underground tunnels , 2007 .

[4]  Geoffrey R. Martin,et al.  Modeling Passive Earth Pressure for Bridge Abutments , 1995 .

[5]  Tom Schanz,et al.  Angles of friction and dilatancy of sand , 1996 .

[6]  Azadeh Bozorgzadeh.  Effect of structure backfill on stiffness and capacity of bridge abutments , 2007 .

[7]  J. Michael Duncan,et al.  Passive earth pressures : Theories and tests , 2001 .

[8]  Kyle M. Rollins,et al.  Passive Earth Pressure Mobilization during Cyclic Loading , 2006 .

[9]  Ricardo Dobry,et al.  Lateral Cyclic Loading Centrifuge Tests on Square Embedded Footing , 1998 .

[10]  Yung-Show Fang,et al.  Passive Earth Pressure with Critical State Concept , 2002 .

[11]  Kyle M. Rollins,et al.  Cyclic Lateral Load Behavior of a Pile Cap and Backfill , 2006 .

[12]  Robert D. Holtz,et al.  REDUCTION OF BOUNDARY FRICTION IN MODEL TESTS , 2004 .

[13]  Leon Ru-Liang Wang,et al.  A refined seismic analysis and design of buried pipeline for fault movement , 1985 .

[14]  Stein Sture,et al.  Strain Localization in Sand: Plane Strain versus Triaxial Compression , 2003 .

[15]  Jonathan P. Stewart,et al.  Lateral Performance of Full-Scale Bridge Abutment Wall with Granular Backfill , 2009 .

[16]  H. E. Stewart,et al.  Factors influencing the behavior of buried pipelines subjected to earthquake faulting , 2009 .

[17]  S. Sture,et al.  Shear Band Formation in Plane Strain Experiments of Sand , 2000 .

[18]  Patrick Richard Wilson.  Large scale passive force-displacement and dynamic earth pressure experiments and simulations , 2009 .

[19]  Kyle M. Rollins,et al.  Nonlinear Soil-Abutment-Bridge Structure Interaction for Seismic Performance-Based Design , 2007 .

[20]  Iraj Noorany.  VARIABILITY IN COMPACTION CONTROL , 1990 .

[21]  Jonathan P. Stewart,et al.  Full Scale Cyclic Testing of Foundation Support Systems for Highway Bridges: Part II: Abutment Backwalls , 2007 .

[22]  K. Terzaghi,et al.  Soil mechanics in engineering practice , 1948 .