Inscription and characterization of Bragg gratings in single-crystal sapphire optical fibres for high-temperature sensor applications

We report the fabrication and high-temperature characteristics of Bragg gratings in single-crystal sapphire fibres inscribed by infrared femtosecond laser pulses. For stable read-out of the multimode Bragg reflection signal, the sapphire fibre was illuminated by broadband light from a superluminescent diode applying a long section of a step-index multimode silica fibre. This evenly distributed excitation of many guided modes in the sapphire fibre resulted in the polychromator measurement of stable reflection peak shapes and allowed for multiplexed temperature sensing up to 1745 °C at remote read-out with repeatability better than 1 °C. During the temperature tests an annealing process of the sapphire grating was observed at temperatures above 1400 °C. Possibilities for further improvement of sensors performance are discussed with a view to avoiding instabilities from the lack of a fibre cladding that shields the sapphire waveguide from the environment.

[1]  R O Claus,et al.  Sapphire fibers: optical attenuation and splicing techniques. , 1995, Applied optics.

[2]  J. Gottmann,et al.  Micro- and nanostructures inside sapphire by fs-laser irradiation and selective etching , 2008, 2008 Conference on Lasers and Electro-Optics and 2008 Conference on Quantum Electronics and Laser Science.

[3]  D. Grobnic,et al.  Femtosecond laser inscribed high temperature fiber Bragg grating sensors , 2007, SPIE Optics East.

[4]  Ping Lu,et al.  Fiber bragg gratings made with a phase mask and 800-nm femtosecond radiation. , 2003 .

[5]  M. Fadel,et al.  A study of some optical properties of hafnium dioxide (HfO2) thin films and their applications , 1998 .

[6]  F. Bilodeau,et al.  Single and low order mode interrogation of a multimode sapphire fibre Bragg grating sensor with tapered fibres , 2006 .

[7]  Saulius Juodkazis,et al.  Control over the Crystalline State of Sapphire , 2006 .

[8]  S. Mihailov,et al.  Long-term thermal stability tests at 1000 °C of silica fibre Bragg gratings made with ultrafast laser radiation , 2006 .

[9]  Nicholas Djeu,et al.  Novel implementation of laser heated pedestal growth for the rapid drawing of sapphire fibers , 1994 .

[10]  Limin Tong,et al.  Performance stability of the sapphire fiber and cladding under high temperature , 1999, Optics East.

[11]  S. Mihailov,et al.  Sapphire fiber Bragg grating sensor made using femtosecond laser radiation for ultrahigh temperature applications , 2004, IEEE Photonics Technology Letters.

[12]  Kyriacos Kalli,et al.  Demonstration of inscription and ablation of phase masks for the production of 1st, 2nd, and 3rd order FBG gratings using a femtosecond laser , 2009, MOEMS-MEMS.

[13]  L. Tong,et al.  A zirconia single-crystal fibre-optic sensor for contact measurement of temperatures above 2000 °C , 1999 .

[14]  Robert L. Byer,et al.  Characterization of single‐crystal sapphire fibers for optical power delivery systems , 1989 .

[15]  C. Luo,et al.  High temperature sensing using higher-order-mode rejected sapphire fiber gratings , 2007, Optical Memory and Neural Networks.

[16]  Hartmut Bartelt,et al.  Fiber Bragg grating inscription combining DUV sub-picosecond laser pulses and two-beam interferometry. , 2008, Optics express.

[17]  John Canning,et al.  Extreme Silica Optical Fibre Gratings , 2008, Sensors.

[18]  Daniel Betz,et al.  Faser-Bragg-Gitter für Hochtemperaturanwendungen (Fiber Bragg Gratings for High Temperature Sensing Applications) , 2004 .