A Silicon Monolithic Phase-Inverter Rat-Race Coupler Using Spiral Coplanar Striplines and Its Application in a Broadband Gilbert Mixer

This paper realized a broadband uniplanar phase-inverter rat-race coupler using a standard silicon process, and then analyzed this coupler under a lossy condition. A phase inverter is employed in this coupler, not only to extend the operation bandwidth, but also to generate balanced outputs by providing equal lossy paths, while symmetrical spiral-shaped coplanar striplines (CPSs) are also utilized to shrink the coupler size, as well as to construct a phase inverter in the middle of one of spiral CPSs. The lossy CPS, when designed as a distortionless line, has a real characteristic impedance, and thus, perfect port matching of the coupler can be achieved at the center frequency. The operation frequency of this silicon monolithic rat-race coupler with the size of 0.5 mm2 is extremely wide and ranges from 5 to 23 GHz. The dissipated loss, transmission coefficient, and isolation of the rat- race coupler are approximately 5.5, -8, and below -25 dB, respectively. In addition, a wideband Gilbert micromixer with an integrated uniplanar phase-inverter rat-race coupler at the local oscillator port is demonstrated using 0.35-mum SiGe BiCMOS technology. This mixer works from 2.5 to 13 GHz with 12-dB conversion gain, -16-dBm IP1 dB, -4-dBm IIP3, and 14-dB noise figure. The chip size of the mixer with an integrated coupler is approximately 1.4 mm times 1.4 mm.

[1]  J.R. Long,et al.  A low-voltage 5.1-5.8-GHz image-reject downconverter RF IC , 2000, IEEE Journal of Solid-State Circuits.

[2]  J.R. Long,et al.  Shielded passive devices for silicon-based monolithic microwave and millimeter-wave integrated circuits , 2006, IEEE Journal of Solid-State Circuits.

[3]  Ke Wu,et al.  Size-reduction and band-broadening design technique of uniplanar hybrid ring coupler using phase inverter for M(H)MIC's , 1999 .

[4]  C. Cané,et al.  Improvement of the quality factor of RF integrated inductors by layout optimization , 1998, 1998 IEEE Radio Frequency Integrated Circuits (RFIC) Symposium. Digest of Papers (Cat. No.98CH36182).

[5]  Guo-Wei Huang,et al.  Monolithic Broadband Gilbert Micromixer With an Integrated Marchand Balun Using Standard Silicon IC Process , 2006, IEEE Transactions on Microwave Theory and Techniques.

[6]  Chu-Chen Yang,et al.  A novel broad-band Chebyshev-response rat-race ring coupler , 1999 .

[7]  C.Y. Chang,et al.  Low RF noise and power loss for ion-implanted Si having an improved implantation process , 2003, IEEE Electron Device Letters.

[8]  R.W. Brodersen,et al.  Millimeter-wave CMOS design , 2005, IEEE Journal of Solid-State Circuits.

[9]  W. R. Eisenstadt,et al.  High-speed VLSI interconnect modeling based on S-parameter measurements , 1993 .

[10]  B. Floyd,et al.  Millimeter-Wave Lange and Ring-Hybrid Couplers in a Silicon Technology for E-Band Applications , 2006, 2006 IEEE MTT-S International Microwave Symposium Digest.

[11]  Isabelle Zaquine,et al.  New wideband, 0.67λg circumference 180° hybrid ring coupler , 1994 .

[12]  Kaixue Ma,et al.  800MHz∼2.5GHz miniaturized multi-layer symmetrical stacked baluns for silicon based RF ICs , 2005, IMS 2005.

[13]  C. Nguyen,et al.  Multilayer Design Techniques for Extremely Miniaturized CMOS Microwave and Millimeter-Wave Distributed Passive Circuits , 2006, IEEE Transactions on Microwave Theory and Techniques.

[14]  Hsiao-Chin Chen,et al.  Micromachined CMOS LNA and VCO by CMOS-compatible ICP deep trench technology , 2006, IEEE Transactions on Microwave Theory and Techniques.

[15]  J.R. Long,et al.  Monolithic transformers for silicon RF IC design , 2000, IEEE Journal of Solid-State Circuits.

[16]  C. Yue,et al.  On-chip Spiral Inductors With Patterned Ground Shields For Si-based RF IC's , 1997, Symposium 1997 on VLSI Circuits.

[17]  J. Reed,et al.  A Method of Analysis of Symmetrical Four-Port Networks , 1956 .

[18]  B. Heimer,et al.  Uniplanar hybrid couplers using asymmetrical coplanar strip lines , 1997, 1997 IEEE MTT-S International Microwave Symposium Digest.

[19]  S. March.  A Wideband Stripline Hybrid Ring (Correspondence) , 1968 .

[20]  A. Abidi,et al.  Large suspended inductors on silicon and their use in a 2- mu m CMOS RF amplifier , 1993, IEEE Electron Device Letters.

[21]  Kenichi Okada,et al.  RF Passive Components Using Metal Line on Si CMOS , 2006, IEICE Trans. Electron..

[22]  Meng-Ju Chiang,et al.  Design of Synthetic Quasi-TEM Transmission Line for CMOS Compact Integrated Circuit , 2007, IEEE Transactions on Microwave Theory and Techniques.

[23]  C.H. Huang,et al.  Large Q-factor improvement for spiral inductors on silicon using proton implantation , 2003, IEEE Microwave and Wireless Components Letters.

[24]  Yicheng Lu,et al.  A silicon monolithic spiral transmission line balun with symmetrical design , 1999, IEEE Electron Device Letters.

[25]  B. Gilbert,et al.  The MICROMIXER: a highly linear variant of the Gilbert mixer using a bisymmetric Class-AB input stage , 1997, IEEE J. Solid State Circuits.

[26]  Hong-Yeh Chang,et al.  Design and analysis of CMOS broad-band compact high-linearity modulators for gigabit microwave/millimeter-wave applications , 2006, IEEE Transactions on Microwave Theory and Techniques.