3D modeling of anode-supported planar SOFC with internal reforming of methane

Abstract Deposition of carbon on conventional anode catalysts and formation of large temperature gradients along the cell are the main barriers for implementing internal reforming in solid oxide fuel cell (SOFC) systems. Mathematical modeling is an essential tool to evaluate the effectiveness of the strategies to overcome these problems. In the present work, a three-dimensional model for a planar internal reforming SOFC is developed. A co-flow system with no pre-reforming, methane fuel utilization of 75%, voltage of 0.7 V and current density of 0.65 A cm−2 was used as the base case. The distributions of both temperature and gas composition through the gas channels and PEN (positive electrode/electrolyte/negative electrode) structure were studied using the developed model. The results identified the most susceptible areas for carbon formation and thermal stress according to the methane to steam ratio and temperature gradients, respectively. The effects of changing the inlet gas composition through recycling were also investigated. Recycling of the anode exhaust gas, at an optimum level of 60% for the conditions studied, has the potential to significantly decrease the temperature gradients and reduce the carbon formation at the anode, while maintaining a high current density.

[1]  Hongpeng He,et al.  Carbon deposition on Ni/YSZ composites exposed to humidified methane , 2007 .

[2]  Paola Costamagna,et al.  Modeling of Solid Oxide Heat Exchanger Integrated Stacks and Simulation at High Fuel Utilization , 1998 .

[3]  Werner Lehnert,et al.  Modelling of gas transport phenomena in SOFC anodes , 2000 .

[4]  Frank A. Coutelieris,et al.  Fuel options for solid oxide fuel cells: A thermodynamic analysis , 2003 .

[5]  N. Jaeger,et al.  Evidence for a hydrogen spillover effect in the deposition of coke on a nickel-faujasite catalyst during syngas conversion , 1992 .

[6]  Paola Costamagna,et al.  Electrochemical model of the integrated planar solid oxide fuel cell (IP-SOFC) , 2004 .

[7]  Andrew Murray,et al.  Cell cycle: A snip separates sisters , 1999, Nature.

[8]  C. Adjiman,et al.  Anode-supported intermediate temperature direct internal reforming solid oxide fuel cell. I: model-based steady-state performance , 2004 .

[9]  Robert J. Kee,et al.  Homogeneous kinetics and equilibrium predictions of coking propensity in the anode channels of direct oxidation solid-oxide fuel cells using dry natural gas , 2003 .

[10]  Richard Fellows.  A novel configuration for direct internal reforming stacks , 1998 .

[11]  J. Nørskov,et al.  Steam Reforming and Graphite Formation on Ni Catalysts , 2002 .

[12]  M. Chyu,et al.  Simulation of the chemical/electrochemical reactions and heat/mass transfer for a tubular SOFC in a stack , 2003 .

[13]  Mogens Bjerg Mogensen,et al.  Reaction of CO/CO2 gas mixtures on Ni–YSZ cermet electrodes , 1999 .

[14]  Seungdoo Park,et al.  Direct Oxidation of Hydrocarbons in a Solid Oxide Fuel Cell: I. Methane Oxidation , 1999 .

[15]  C. H. Bartholomew.  Carbon Deposition in Steam Reforming and Methanation , 1982 .

[16]  R. Dittmeyer,et al.  Catalytic modification of conventional SOFC anodes with a view to reducing their activity for direct internal reforming of natural gas , 2006 .

[17]  Toshiaki Mori,et al.  Kinetics of the reverse-Boudouard reaction over supported nickel catalysts , 2006 .

[18]  Andrew Dicks,et al.  Catalytic aspects of the steam reforming of hydrocarbons in internal reforming fuel cells , 1997 .

[19]  E. Riensche,et al.  Methane/steam reforming kinetics for solid oxide fuel cells , 1994 .

[20]  S. A. Barnett,et al.  A direct-methane fuel cell with a ceria-based anode , 1999, Nature.

[21]  Caine M. Finnerty,et al.  Carbon formation on and deactivation of nickel-based/zirconia anodes in solid oxide fuel cells running on methane , 1998 .

[22]  K. Ahmed,et al.  Kinetics of internal steam reforming of methane on Ni/YSZ-based anodes for solid oxide fuel cells , 2000 .

[23]  Y. Yoo,et al.  Thermodynamic Analysis of Carbon Deposition and Electrochemical Oxidation of Methane for SOFC Anodes , 2001 .

[24]  Ryuji Kikuchi,et al.  Fuel flexibility in power generation by solid oxide fuel cells , 2002 .

[25]  M. Khaleel,et al.  A finite element analysis modeling tool for solid oxide fuel cell development: coupled electrochemistry, thermal and flow analysis in MARC® , 2004 .

[26]  S. Cocchi,et al.  A global thermo-electrochemical model for SOFC systems design and engineering , 2003 .

[27]  S. Barnett,et al.  Direct operation of solid oxide fuel cells with methane fuel , 2005 .

[28]  R. Kikuchi,et al.  Internal Reforming of SOFCs Carbon Deposition on Fuel Electrode and Subsequent Deterioration of Cell , 2007 .

[29]  Peter Heidebrecht,et al.  Conceptual design of the integration of the reforming process in high temperature fuel cells , 2004 .

[30]  J. Whitelaw,et al.  Convective heat and mass transfer , 1966 .

[31]  Viktor Hacker,et al.  Usage of biomass gas for fuel cells by the SIR process , 1998 .

[32]  Koichi Yamada,et al.  Oxidation mechanism and effective anode thickness of SOFC for dry methane fuel , 1996 .

[33]  R. Peters,et al.  Internal reforming of methane in solid oxide fuel cell systems , 2002 .