Influence of hydrothermal carbon coating on the properties of CF/ZrB2/SiBCN prepared by slurry injection

[1]  Xinyuan Zhao,et al.  Modelling and experimental investigation of pore-like flaw-strength response in structural ceramics , 2020 .

[2]  N. Ni,et al.  Thermal damage and microstructure evolution mechanisms of Cf/SiBCN composites during plasma ablation , 2020 .

[3]  Xinghong Zhang,et al.  Constructing hydrothermal carbonization coatings on carbon fibers with controllable thickness for achieving tunable sorption of dyes and oils via a simple heat-treated route. , 2020, Journal of colloid and interface science.

[4]  Xinghong Zhang,et al.  Oxidation behavior and ablation mechanism of Cf/ZrB2-SiC composite fabricated by vibration-assisted slurry impregnation combined with low-temperature hot pressing , 2019 .

[5]  J. Kokini,et al.  Effect of contact surface, plasticized and crosslinked zein films are cast on, on the distribution of dispersive and polar surface energy using the Van Oss method of deconvolution , 2019 .

[6]  R. P. K. Ambrose,et al.  Quantifying the influence of surface chemical composition on surface energy during powder flow , 2019, Particulate Science and Technology.

[7]  Xinghong Zhang,et al.  An efficient hydrothermal transformation approach for construction of controllable carbon coating on carbon fiber from renewable carbohydrate , 2019, Applied Surface Science.

[8]  S. Du,et al.  From ferroconcrete to Cf/UHTC-SiC: A totally novel densification method and mechanism at 1300 °C without pressure , 2019, Composites Part B: Engineering.

[9]  Lai-fei Cheng,et al.  Oxidation behavior of C/SiC-SiBCN composites at high temperature , 2019, Journal of the European Ceramic Society.

[10]  Xinghong Zhang,et al.  Design and optimization of the coating thickness on chopped carbon fibers and sintering temperature for ZrB2-SiC-Cf composites prepared by hot pressing , 2019, Journal of the European Ceramic Society.

[11]  Yuan Cheng,et al.  One-step introduction of ZrC-SiC inside carbon fabric to fabricate high homogeneous and damage-tolerant composite inspired by vibration , 2019, Journal of the European Ceramic Society.

[12]  Xinghong Zhang,et al.  Microstructures and mechanical properties of Cf/ZrB2-SiC composite fabricated by nano slurry brushing combined with low-temperature hot pressing , 2019, Journal of Alloys and Compounds.

[13]  D. Sciti,et al.  Arc-jet wind tunnel characterization of ultra-high-temperature ceramic matrix composites , 2019, Corrosion Science.

[14]  Xinghong Zhang,et al.  A novel vibration-assisted slurry impregnation to fabricate Cf/ZrB2-SiC composite with enhanced mechanical properties , 2019, Journal of the European Ceramic Society.

[15]  Shaolin Li,et al.  Evaluation of the effect of PyC coating thickness on the mechanical properties of T700 carbon fiber tows , 2019, Applied Surface Science.

[16]  D. Sciti,et al.  Introduction to H2020 project C3HARME – next generation ceramic composites for combustion harsh environment and space , 2018, Advances in Applied Ceramics.

[17]  Philippe Bussetta,et al.  Numerical forming of continuous fibre reinforced composite material: A review , 2018, Composites Part A: Applied Science and Manufacturing.

[18]  H. Roshan,et al.  Current understanding of shale wettability: A review on contact angle measurements , 2018, Earth-Science Reviews.

[19]  D. Sciti,et al.  Tough salami-inspired C f /ZrB 2 UHTCMCs produced by electrophoretic deposition , 2018 .

[20]  S. Hogan,et al.  Relationships between surface energy analysis and functional characteristics of dairy powders. , 2017, Food chemistry.

[21]  S. Grasso,et al.  Rapid spark plasma sintering to produce dense UHTCs reinforced with undamaged carbon fibres , 2017 .

[22]  Xinghong Zhang,et al.  Microstructure, mechanical properties and thermal shock resistance of ZrB2-SiC-Cf composite with inhibited degradation of carbon fibers , 2017 .

[23]  T. Liu,et al.  Contact Angle Measurement of Small Capillary Length Liquid in Super-repelled State , 2017, Scientific Reports.

[24]  Tingting Xu,et al.  Synthesis, pyrolysis of a novel liquid SiBCN ceramic precursor and its application in ceramic matrix composites , 2017 .

[25]  D. Sciti,et al.  Relationships between carbon fiber type and interfacial domain in ZrB2-based ceramics , 2016 .

[26]  J. Zou,et al.  Soluble and meltable hyperbranched polyborosilazanes toward high-temperature stable SiBCN ceramics. , 2015, ACS applied materials & interfaces.

[27]  Lei Xie,et al.  An Efficient Way To Introduce Hierarchical Structure into Biomass-Based Hydrothermal Carbonaceous Materials , 2014 .

[28]  Yiguang Wang,et al.  C/SiC–ZrB2–ZrC composites fabricated by reactive melt infiltration with ZrSi2 alloy , 2012 .

[29]  Xinghong Zhang,et al.  Gelcasting of complex-shaped ZrB2–SiC ultra high temperature ceramic components , 2012 .

[30]  S. Dong,et al.  Fabrication and Properties of 3‐D Cf/SiC–ZrC Composites, Using ZrC Precursor and Polycarbosilane , 2012 .

[31]  Liping Yu,et al.  Interfacial microstructure and properties of carbon fiber composites modified with graphene oxide. , 2012, ACS applied materials & interfaces.

[32]  Lei Zhai,et al.  Structural Evolution of Polymer-Derived Amorphous SiBCN Ceramics at High Temperature , 2011 .

[33]  Z. Zhang,et al.  Effect of sizing on carbon fiber surface properties and fibers/epoxy interfacial adhesion , 2011 .

[34]  Jenn‐Ming Yang,et al.  Tensile properties of ultrahigh strength PAN-based, ultrahigh modulus pitch-based and high ductility pitch-based carbon fibers , 2008 .

[35]  Xueming Li,et al.  Wettability of carbon fibers modified by acrylic acid and interface properties of carbon fiber/epoxy , 2008 .

[36]  Liu Jie,et al.  Evolution of structure and properties of PAN precursors during their conversion to carbon fibers , 2003 .

[37]  T. Blake,et al.  The influence of solid-liquid interactions on dynamic wetting. , 2002, Advances in colloid and interface science.

[38]  I. Beyerlein,et al.  On the influence of fiber shape in bone-shaped short-fiber composites , 2001 .

[39]  H. Peterlik,et al.  Coating of Carbon Fibers—The Strength of the Fibers , 1995 .

[40]  R. Corriu,et al.  Preparation of Silicon Carbonitrides from an Organosilicon Polymer: I, Thermal Decomposition of the Cross-linked Polysilazane , 1993 .