Experimental characterization of the post-cracking response in Hybrid Steel/Polypropylene Fiber-Reinforced Concrete

Abstract This paper presents and discusses the results of experimental tests performed on concrete specimens internally reinforced with polypropylene and steel fibers. Specifically, samples of five mixtures (plus a reference plain concrete), characterized by the same total volume of fibers, but different fractions of polypropylene and steel fibers, were tested under compression and in bending. This study was aimed to clarify the influence of different combinations of these fibers on the resulting fracture behavior of Hybrid Fiber-Reinforced Concrete (HyFRC). As expected, the results obtained from compression tests highlighted a negligible influence of fibers in terms of strength and, hence, FRC specimens exhibited a post-peak response more ductile than the reference ones. Conversely, the overall shape of the stress-crack-opening-displacement curves of HyFRC tested in bending was highly influenced by the type of fibers. On the one hand, FRC specimens made of only polypropylene fibers exhibited an excellent post-cracking toughness for the small crack opening ranges of relevance for the Serviceability Limit State, while an apparent decay was observed in terms of post-cracking response, especially at wide crack openings. On the other hand, a marked re-hardening response was observed in the post-cracking behavior for specimens with higher percentage of steel fibers; however, at the same time, the corresponding results showed a relevant scatter.

[1]  Kyung-Taek Koh,et al.  Comparative flexural behavior of Hybrid Ultra High Performance Fiber Reinforced Concrete with different macro fibers , 2011 .

[2]  Barzin Mobasher,et al.  Fatigue behavior of sisal fiber reinforced cement composites , 2010 .

[3]  L. Feo.  Guide for the Design and Construction of Fiber-Reinforced Concrete Structures , 2007 .

[4]  A. Meda,et al.  Strengthening and repair of RC beams with fiber reinforced concrete , 2010 .

[5]  J. Barros,et al.  Shear resistance of SFRSCC short-span beams without transversal reinforcements , 2016 .

[6]  C. Lima,et al.  Fracture behavior of concrete beams reinforced with mixed long/short steel fibers , 2012 .

[7]  M. Taşdemi̇r,et al.  Mechanical behaviour and fibre dispersion of hybrid steel fibre reinforced self-compacting concrete , 2012 .

[8]  P. Song,et al.  Mechanical properties of polypropylene hybrid fiber-reinforced concrete , 2008 .

[9]  J. Aguiar,et al.  Study on residual behaviour and flexural toughness of fibre cocktail reinforced self compacting high performance concrete after exposure to high temperature , 2011 .

[10]  M. Şahmaran,et al.  Hybrid fiber reinforced self-compacting concrete with a high-volume coarse fly ash , 2007 .

[11]  Jean-Philippe Charron,et al.  Design of SFRC structural elements: post-cracking tensile strength measurement , 2012 .

[12]  A. Naaman,et al.  Pullout Behavior of High-Strength Steel Fibers Embedded in Ultra-High-Performance Concrete , 2012 .

[13]  R. Christen,et al.  Experimental and numerical investigation on postcracking behavior of steel fiber reinforced concrete , 2013 .

[14]  F. Minelli,et al.  Steel fiber reinforced self-compacting concrete thin slabs – Experimental study and verification against Model Code 2010 provisions , 2016 .

[15]  M. Ramli,et al.  Mechanical properties of high strength flowing concrete with hybrid fibers , 2012 .

[16]  Jie Li,et al.  Mechanical properties of hybrid fiber-reinforced concrete at low fiber volume fraction , 2003 .

[17]  K. Pilakoutas,et al.  Fatigue resistance and cracking mechanism of concrete pavements reinforced with recycled steel fibres recovered from post-consumer tyres , 2012 .

[18]  Giovanni Plizzari,et al.  Influence of concrete strength on crack development in SFRC members , 2014 .

[19]  Lucie Vandewalle,et al.  Fibre reinforced concrete: new design perspectives , 2009 .

[20]  Alberto Meda,et al.  Bending and Uniaxial Tensile Tests on Concrete Reinforced with Hybrid Steel Fibers , 2005 .

[21]  Fatemeh Soltanzadeh,et al.  High performance fiber reinforced concrete for the shear reinforcement: Experimental and numerical research , 2015 .

[22]  Antoine E. Naaman,et al.  Proposed classification of HPFRC composites based on their tensile response , 2007 .

[23]  Enzo Martinelli,et al.  An experimental study on the post-cracking behaviour of Hybrid Industrial/Recycled Steel Fibre-Reinforced Concrete , 2015 .

[24]  Parviz Soroushian,et al.  Mechanical properties of hybrid fiber reinforced lightweight aggregate concrete made with natural pumice , 2011 .

[25]  Günther Meschke,et al.  Experimental, analytical and numerical analysis of the pullout behaviour of steel fibres considering different fibre types, inclinations and concrete strengths , 2014 .

[26]  P. Folino,et al.  Experimental and numerical characterization of the bond behavior of steel fibers recovered from waste tires embedded in cementitious matrices , 2015 .