Modeling, simulation and control of dimethyl ether synthesis in an industrial fixed-bed reactor

Dimethyl ether (DME) as a clean fuel has attracted the interest of many researchers from both industrial communities and academia. The commercially proven process for large scale production of dimethyl ether consists of catalytic dehydration of methanol in an adiabatic fixed-bed reactor. In this study, the industrial reactor of DME synthesis with the accompanying feed preheater has been simulated and controlled in dynamic conditions. The proposed model, consisting of a set of algebraic and partial differential equations, is based on a heterogeneous one-dimensional unsteady state formulation. To verify the proposed model, the simulation results have been compared to available data from an industrial reactor at steady state conditions. A good agreement has been found between the simulation and plant data. A sensitivity analysis has been carried out to evaluate the influence of different possible disturbances on the process. Also, the controllability of the process has been investigated through dynamic simulation of the process under a conventional feedback PID controller. The responses of the system to disturbance and setpoint changes have shown that the control structure can maintain the process at the desired conditions with an appropriate dynamic behavior.

[1]  C. Y. Wen,et al.  Particle attrition phenomena in a fluidized bed , 1987 .

[2]  Allan P. Colburn,et al.  A method of correlating forced convection heat-transfer data and a comparison with fluid friction☆☆☆ , 1964 .

[3]  Alexander S. Poznyak,et al.  Temperature control in catalytic cracking reactors via a robust PID controller , 2002 .

[4]  J. G. Ziegler,et al.  Optimum Settings for Automatic Controllers , 1942, Journal of Fluids Engineering.

[5]  Majid Taghizadeh,et al.  Experimental Study and Modeling of an Adiabatic Fixed-bed Reactor for Methanol Dehydration to Dimethyl Ether , 2009 .

[6]  Sten Bay Jørgensen,et al.  Fixed Bed Reactor Dynamics and Control - A Review , 1986 .

[7]  J. Levec,et al.  Intrinsic and global reaction rate of methanol dehydration over .gamma.-alumina pellets , 1992 .

[8]  J. Dormand,et al.  A family of embedded Runge-Kutta formulae , 1980 .

[9]  C. Bae,et al.  The potential of di-methyl ether (DME) as an alternative fuel for compression-ignition engines: A review , 2008 .

[10]  Wen-de Xiao,et al.  Simulation and experiment study of dimethyl ether synthesis from syngas in a fluidized-bed reactor , 2004 .

[11]  Cláudio Augusto Oller do Nascimento,et al.  Thermal runaway of ethylene oxidation reactors: Prevision through neuronal networks , 1996 .

[12]  Makarand R. Gogate,et al.  A novel single-step dimethyl ether (DME) synthesis in a three-phase slurry reactor from co-rich syngas , 1992 .

[13]  Toshihiko Ozaki,et al.  Optimization of the Temperature Profile of a Temperature Gradient Reactor for DME Synthesis Using a Simple Genetic Algorithm Assisted by a Neural Network , 2003 .

[14]  Aacm Beenackers,et al.  Intra-particle diffusion limitations in low-pressure methanol synthesis , 1990 .

[15]  En Sup Yoon,et al.  Simulation of fixed bed reactor for dimethyl ether synthesis , 2006 .

[16]  Mohammad Shahrokhi,et al.  Modeling, simulation and control of a methanol synthesis fixed-bed reactor , 2005 .

[17]  J. M. Smith.  Chemical Engineering Kinetics , 1980 .

[18]  Vladimir Galvita,et al.  Production of hydrogen from dimethyl ether , 2001 .

[19]  H. S. Fogler,et al.  Elements of Chemical Reaction Engineering , 1986 .

[20]  Reza Eslamloueyan,et al.  Optimal temperature profile in methanol synthesis reactor , 2002 .

[21]  G. Froment,et al.  Chemical Reactor Analysis and Design , 1979 .

[22]  Haim Kalman,et al.  A New Apparatus for Particle Impact Tests , 2003 .

[23]  Daniel R. Parisi,et al.  Modeling steady-state heterogeneous gas–solid reactors using feedforward neural networks , 2001 .

[24]  R. Borup,et al.  Dimethyl ether (DME) as an alternative fuel , 2006 .

[25]  W. Luyben.  Tuning proportional-integral-derivative controllers for integrator/deadtime processes , 1996 .

[26]  Edward L Cussler,et al.  Diffusion: Mass Transfer in Fluid Systems , 1984 .