A High-Dimming-Ratio LED Driver for LCD Backlights

The grayscale resolution of liquid crystal displays (LCDs) can be improved by modulating the grayscale of the pixels in LCDs or by dimming the LCD backlight source. Changing the voltage or turned-on time of a pixel to achieve high-resolution grayscale requires either an accurate digital-to-analog converter or a very high frequency pulsewidth modulation (PWM) signal, which increases hardware cost and power consumption. The fast transient response of light-emitting diodes (LEDs) makes them useful as a backlight source for improving the grayscale resolution of an LCD without additional overhead. This paper presents an eight-channel LED backlight driver that can improve conventional dimming control circuits for LCDs. The proposed design was fabricated in a TSMC 0.25-μm 60-V bipolar-CMOS-DMOS process, and the chip area is 2.7 mm2. A dimming ratio of 50 000:1 is achieved with a 500-Hz PWM signal. The maximum power conversion efficiency, including power consumption of the LED current regulators, is 89.3%, when the load is a 12 × 8 LED array, the input voltage is 20 V, and the LED current is set to 25 mA.

[1]  Ming Liu,et al.  A Single Driver Chip for Gray Scale Passive-Matrix OLED , 2006, 2006 International Conference on Communications, Circuits and Systems.

[2]  Judith M. S. Prewitt,et al.  Digital Picture Archiving and Communication Systems in Medicine - Guest Editors' Introduction , 1983, Computer.

[3]  Regan Zane,et al.  Digital Architecture for Driving Large LED Arrays with Dynamic Bus Voltage Regulation and Phase Shifted PWM , 2007, APEC 07 - Twenty-Second Annual IEEE Applied Power Electronics Conference and Exposition.

[4]  Bin-Juine Huang,et al.  Multivariable Robust Control for a Red–Green–Blue LED Lighting System , 2010, IEEE Transactions on Power Electronics.

[5]  Feng Ran,et al.  A Mixed Drive Method for High Gray Scale TFT-LCD , 2009, 2009 2nd International Congress on Image and Signal Processing.

[6]  J.T.Y. Su.  A material system for high precision embedded polymer resistor , 2004, 9th International Symposium on Advanced Packaging Materials: Processes, Properties and Interfaces (IEEE Cat. No.04TH8742). 2004 Proceedings..

[7]  Shin-Tson Wu,et al.  LED-Lit LCD TVs , 2008 .

[8]  Sang-Hoon Lee,et al.  Improvement of response time and contrast ratio in 42-inch TFT-LCD panel for HDTV , 2005, 2005 Digest of Technical Papers. International Conference on Consumer Electronics, 2005. ICCE..

[9]  Ehsan Samei,et al.  Introduction to Grayscale Calibration and Related Aspects of Medical Imaging Grade Liquid Crystal Displays , 2008, Journal of Digital Imaging.

[10]  Y. B. Acharya,et al.  Response time of light emitting diode-logarithmic electrometer , 1998 .

[11]  Jih-Sheng Lai,et al.  High efficiency DC-DC converter with twin-bus for dimmable LED lighting , 2010, 2010 IEEE Energy Conversion Congress and Exposition.

[12]  S.Y.R. Hui,et al.  Comparative Study on the Structural Designs of LED Devices and Systems Based on the General Photo-Electro-Thermal Theory , 2010, IEEE Transactions on Power Electronics.

[13]  Tsai-Fu Wu,et al.  Sequential Color LED Backlight Driving System for LCD Panels , 2007, IEEE Transactions on Power Electronics.

[14]  R. L. Chao.  Trimming analog circuits with solid-state devices , 1997 .

[15]  Kuo-Ing Hwu,et al.  LED dimming with efficiency considered , 2011 .

[16]  M.M. Jovanovic,et al.  LED Driver With Self-Adaptive Drive Voltage , 2008, IEEE Transactions on Power Electronics.

[17]  Zhijie Tang,et al.  A high gray scale TFT-LCD drive system , 2008, 2008 International Conference on Audio, Language and Image Processing.

[18]  J. Umeda,et al.  Response times of light-emitting diodes , 1972 .

[19]  Xiaobo Wu,et al.  High dimming ratio LED driver with fast transient boost converter , 2008, 2008 IEEE Power Electronics Specialists Conference.

[20]  Hans Burkhardt,et al.  Grayscale medical image annotation using local relational features , 2008, Pattern Recognit. Lett..

[21]  M. Meunier,et al.  Laser-Induced Resistance Fine Tuning of Integrated Polysilicon Thin-Film Resistors , 2011, IEEE Transactions on Electron Devices.

[22]  Young Hwan Kim,et al.  Image integrity-based gray-level error control for low power liquid crystal displays , 2009, IEEE Transactions on Consumer Electronics.

[23]  D. Zinger,et al.  An effective LED dimming approach , 2004, Conference Record of the 2004 IEEE Industry Applications Conference, 2004. 39th IAS Annual Meeting..

[24]  T.C. Hu,et al.  Mis-matching characteristics study of P+-poly-silicon resistor in newly CMOS process technology , 2007, 2007 IEEE Conference on Electron Devices and Solid-State Circuits.

[25]  Ying-Zong Juang,et al.  A High Current Accuracy Boost White LED Driver Based on Offset Calibration Technique , 2011, IEEE Transactions on Circuits and Systems II: Express Briefs.

[26]  Oh-Kyong Kwon,et al.  A double-loop control LED backlight driver IC for medium-sized LCDs , 2010, 2010 IEEE International Solid-State Circuits Conference - (ISSCC).

[27]  Feng Jingyi,et al.  DICOM GSDF Based Calibration Method of General LCD Monitor for Medical Softcopy Image Display , 2007, 2007 1st International Conference on Bioinformatics and Biomedical Engineering.

[28]  Y. Amemiya,et al.  Electrical trimming of heavily doped polycrystalline silicon resistors , 1979, IEEE Transactions on Electron Devices.