论文信息 - FEM Analysis of Turgo Impulse Turbine Blade

FEM Analysis of Turgo Impulse Turbine Blade

The present research work describes the development of Turgo turbine blades on the Solidworks software. Finite element simulation (Ansys V14) has been used for analysis of stress and total deformation produced inside the Turgo impulse turbine. Finite element simulation is effective when it is used to analyze the strain and stress distribution. It has been observed during analysis that the maximum stress occurs at the root of blade suction side.

[1] Kendra V. Sharp,et al. Impulse (Turgo and Pelton) turbine performance characteristics and their impact on pico-hydro installations , 2013 .

[2] Ole Gunnar Dahlhaug,et al. Empirical modelling of sediment erosion in Francis turbines , 2012 .

[3] John S. Anagnostopoulos,et al. Flow Modeling and Runner Design Optimization in Turgo Water Turbines , 2007 .

[4] David V. Hutton,et al. Fundamentals of Finite Element Analysis , 2003 .

[5] Ruchi Khare,et al. CFD APPROACH FOR FLOW CHARACTERISTICS OF HYDRAULIC FRANCIS TURBINE , 2010 .

[6] Yuji Nakanishi,et al. Numerical and Experimental Investigations of the Flow in a Stationary Pelton Bucket , 2009 .

[7] Alexandre Perrig,et al. Hydrodynamics of the free surface flow in Pelton turbine buckets , 2007 .

[8] Ole Gunnar Dahlhaug,et al. ALTERNATIVE DESIGN OF A FRANCIS TURBINE FOR SAND LADEN WATER , 2007 .

[9] John S. Anagnostopoulos,et al. SPH Method used for Flow Predictions at a Turgo Impulse Turbine: Comparison with Fluent , 2011 .