Survey of Validation Data Base for Shockwave Boundary-Layer Interactions in Supersonic Inlets

The performance of supersonic inlets is strongly affected by the boundary-layer development over its internal surfaces. Boundary-layer bleed is used to suppress separation and to provide the desired inlet performance. The gain in pressure recovery and stability is accompanied, however, with a loss in mass flow and an increase in drag that must be minimized by optimizing the amount of bleed and bleed configuration. The purpose of this work is to review and assess the data base for shock boundary-layer interaction that is pertinent to the flow prediction in supersonic inlets. The first part of the review concerns mixed compression supersonic inlets and their bleed system performance at design and off-design conditions. Based on the assessment of this data, specific areas related to shock wave/boundary-layer interaction bleed, for flow-separation control, are identified, the last part of the review addresses this phenomena in various twoand three-dimensional flow configurations. The effect of bleed in the interaction zone is especially emphasized.

[1]  G. G. Mateer,et al.  Mach and Reynolds Number Effects on a Shock-Wave/Boundary-Layer Interaction , 1980 .

[2]  G. Settles,et al.  Incipient separation of a supersonic turbulent boundary layer at moderate to high Reynolds numbers , 1975 .

[3]  T. Coakley.  Impact of turbulence modeling on numerical accuracy and efficiency of compressible flow simulations , 1986 .

[4]  D. M. Kuehn.  Experimental Investigation of the Pressure Rise Required for the Incipient Separation of Turbulent Boundary Layers in Two-Dimensional Supersonic Flow , 1959 .

[5]  D. Dolling,et al.  Unsteadiness of the Separation Shock Wave Structure in a Supersonic Compression Ramp Flowfield , 1983 .

[6]  Theodore A. Reyhner,et al.  Combined Viscous-Inviscid Analysis of Supersonic Inlet Flowfields , 1972 .

[7]  M. Holden,et al.  Shock Wave Turbulent Boundary Layer Interaction in Hypersonic Flow , 1972 .

[8]  Doyle Knight.  Calculation of High Speed Inlet Flows using the Navier-Stokes Equations. Volume II. User's and Programmer's Guide. , 1980 .

[9]  Norman E. Sorensen,et al.  Performance estimates for a supersonic axisymmetric inlet system. , 1972 .

[10]  Dean R. Chapman,et al.  Investigation of separated flows in supersonic and subsonic streams with emphasis on the effect of transition , 1958 .

[11]  W. C. Rose,et al.  Hot-wire anemometry in transonic flow , 1977 .

[12]  W. R. Hingst,et al.  Control of shock-wave boundary-layer interactions by bleed in supersonic mixed compression inlets , 1975 .

[13]  William F. Imfeld.  Development Program for the F-15 Inlet , 1976 .

[14]  D. A. Johnson,et al.  Prediction of Transonic Separated Flows , 1984 .

[15]  J. L. Koncsek,et al.  Transonic and supersonic test of a Mach 2.65 mixed-compression axisymmetric intake , 1972 .

[16]  Jan Syberg,et al.  Bleed System Design Technology for Supersonic Inlets , 1972 .

[17]  and A J Smits,et al.  THE RESPONSE OF TURBULENT BOUNDARY LAYERS TO SUDDEN PERTURBATIONS , 1985 .

[18]  Injection into a turbulent boundary layer through porous surfaces with different surface geometries , 1983 .

[19]  R. W. Cubbison,et al.  Performance characteristics from Mach 2.58 to 1.98 of an axisymmetric mixed-compression inlet system with 60-percent internal contraction , 1969 .

[20]  C. C. Horstman,et al.  Turbulence measurements in hypersonic shock-wave boundary-layer interaction flows , 1976 .

[21]  J. L. Brown,et al.  Two-Component LDV Investigation of Three-Dimensional Shock/Turbulent Boundary-Layer Interactions , 1987 .

[22]  E. Zukoski.  Turbulent Boundary-Layer Separation in Front of aForward-Facing Step , 1967 .

[23]  I. H. Rettie,et al.  Design and development of an air intake for a supersonic transport aircraft. , 1968 .

[24]  Jean Delery,et al.  Shock wave/turbulent boundary layer interaction and its control , 1985 .

[25]  E. Reshotko,et al.  Bleed Effects on ShockA3oundary-layer Interactions in Supersonic Mixed Compression Inlets , 1977 .

[26]  W. R. Hingst,et al.  Glancing shock wave-turbulent boundary layer interaction with boundary layer suction , 1988 .

[27]  D. Knight.  Improved Calculation of High Speed Inlet Flows: Part I. Numerical Algorithm , 1981 .

[28]  T. Bogar,et al.  Confined Normal-Shock/Turbulent-Boundary-Layer Interaction Followed by an Adverse Pressure Gradient , 1989 .

[29]  C. C. Horstman,et al.  Investigation of a Three-Dimensional Shock Wave Separated Turbulent Boundary Layer , 1980 .

[30]  C. Herbert Law,et al.  Supersonic Shock Wave Turbulent Boundary-Layer Interactions , 1976 .

[31]  Victor Zakkay,et al.  Turbulent Boundary-Layer Shock Interaction with and without Injection , 1970 .

[32]  A. Hamed,et al.  J85 Surge Transient Simulation , 1989 .

[33]  D. N. Bowditch.  Some design considerations for supersonic cruise mixed compression inlets , 1973 .

[34]  Norman E. Sorensen,et al.  Advanced supersonic inlet technology. , 1973 .

[35]  Pascal L. Ardonceau,et al.  The Structure of Turbulence in a Supersonic Shock-Wave/Boundary-Layer Interaction , 1984 .

[36]  Alexander Smits,et al.  Turbulence Measurements in a Compressible Reattaching Shear Layer , 1983 .

[37]  Jan Syberg,et al.  Experimental Evaluation of an Analytically Derived Bleed System for a Supersonic Inlet , 1975 .

[38]  Shigeru Aso,et al.  Fluctuation of heat transfer in shock wave/turbulent boundary-layer interaction , 1988 .

[40]  M. J. Smith,et al.  Interaction of a Shock Wave with a Turbulent Boundary Layer Disturbed by Injection , 1980 .

[41]  Gary S. Settles,et al.  Detailed Study of Attached and Separated Compression Corner Flowfields in High Reynolds Number Supersonic Flow , 1979 .

[42]  Dale Evan Berg.  Surface roughness effects on the hypersonic turbulent boundary layer , 1977 .

[43]  E. Reshotko,et al.  Shock-wave boundary layer interactions , 1986 .

[44]  G. G. Mateer,et al.  A normal shock-wave turbulent boundary-layer interaction at transonic speeds , 1976 .

[45]  S. Bogdonoff.  An exploratory study of corner bleed on a fin generated three-dimensional shock wave turbulent boundary layer interaction , 1989 .

[46]  A. Roshko,et al.  Flare-Induced Interaction Lengths in Supersonic, Turbulent Boundary Layers , 1975 .

[47]  Doyle D Knight,et al.  Calculation of high-speed inlet flows using the Navier-Stokes equations. , 1980 .

[48]  A. F. Messiter,et al.  Analysis of Two-Dimensional Interactions Between Shock Waves and Boundary Layers , 1980 .

[49]  G. G. Mateer,et al.  Effect of Mach number and Reynolds number on a normal shock-wave/turbulent boundary-layer interaction , 1979 .

[50]  J. Délery.  Experimental investigation of turbulence properties in transonic shock/boundary-layer interactions , 1983 .

[51]  F. Collier,et al.  Injection into a Turbulent Boundary Layer Through Different Porous Surfaces , 1984 .

[52]  D. B. Smeltzer,et al.  Investigation of a mixed-compression axisymmetric inlet system at Mach numbers 0.6 to 3.5 , 1970 .

[53]  J. R. Szuch,et al.  Propulsion systems technology , 1975 .

[54]  W. R. Seebaugh,et al.  Conical shock-wave turbulent boundary-layer interaction including suction effects , 1970 .

[55]  R. Voisinet.  Combined influence of roughness and mass transfer on turbulent skin friction at Mach 2.9 , 1979 .

[56]  Morris W. Rubesin,et al.  Turbulence modeling for aerodynamic flows , 1989 .

[57]  K. Muck,et al.  The Behaviour of a Compressible Turbulent Boundary Layer Under Incipient Separation Conditions , 1985 .