Aircraft Thermal Management Using Loop Heat Pipes: Experimental Simulation of High Acceleration Environments Using the Centrifuge Table Test Bed

Abstract : The objective of this paper is to describe the design of an experiment that will examine the effects of elevated acceleration environments on a high-temperature, titanium-water loop heat pipe for actuator cooling. An experimental test setup has been designed for mounting a loop heat pipe on an 8-ft-diameter centrifuge table, which is capable of radial accelerations of up to 12-g's. A high-temperature PAO loop will interface the condenser of the loop heat pipe to simulate the rejection of the transported heat to an elevated temperature. In addition to LHP experimentation, a mathematical model has been developed for aerodynamic heating of high-speed aircraft. A flat plate at zero-incidence, used to model an aircraft wing, was subjected to sub- and supersonic flow to examine whether heat will be rejected or absorbed. The results of this analysis will be used to determine the condenser conditions of the loop heat pipe during centrifuge testing.

[1]  Claude Sarno,et al.  Investigation on the Effects of Body Force Environment on Flat Heat Pipes , 2001 .

[2]  Robert V. Brill,et al.  Applied Statistics and Probability for Engineers , 2004, Technometrics.

[3]  Jentung Ku,et al.  Operating Characteristics of Loop Heat Pipes , 1999 .

[4]  Tarik Kaya,et al.  Testing of the Geoscience Laser Altimeter System (GLAS) prototype loop heat pipe , 1999 .

[5]  Kirk L. Yerkes,et al.  Arterial heat pipe performance in a transient heat flux and body force environment , 1992 .

[6]  E. Collings,et al.  Materials Properties Handbook: Titanium Alloys , 1994 .

[7]  K. L. Yerkes,et al.  QUASI-STEADY STATE THERMAL RESISTANCE OF A FLEXIBLE COPPER-WATER HEAT PIPESUBJECTED TO TRANSIENT ACCELERATION LOADINGS , 1996 .

[8]  Jerry E. Beam,et al.  Comparison of hydraulic and thermal performance of PAO and Coolanol 25R liquid coolants , 1994 .

[9]  J. S. Cloyd,et al.  Status of the United States Air Force's More Electric Aircraft initiative , 1998 .

[10]  Jentung Ku,et al.  Testing of A Loop Heat Pipe Subjected to Variable Accelerating Forces, Part 1: Start-up , 2000 .

[11]  John David Anderson,et al.  Introduction to Flight , 1985 .

[12]  M. J. Wheeler.  Heat and Mass Transfer , 1968, Nature.

[13]  Kirk L. Yerkes,et al.  A Thermal Management Concept for More Electric Aircraft Power System Applications , 1998 .

[14]  Paul Rogers,et al.  Testing of A Loop Heat Pipe Subjected to Variable Accelerating Forces, Part 2: Temperature Stability , 2000 .

[15]  R.E.J. Quigley.  More Electric Aircraft , 1993, Proceedings Eighth Annual Applied Power Electronics Conference and Exposition,.

[16]  J. S. Cloyd,et al.  A status of the United States Air Force's More Electric Aircraft initiative , 1997, IECEC-97 Proceedings of the Thirty-Second Intersociety Energy Conversion Engineering Conference (Cat. No.97CH6203).

[17]  Jentung Ku,et al.  Transient Modeling of Loop Heat Pipes , 2003 .

[18]  Shane Hanna,et al.  Study of a loop heat pipe using neutron radiography. , 2001, Applied radiation and isotopes : including data, instrumentation and methods for use in agriculture, industry and medicine.

[19]  Kirk L. Yerkes,et al.  The Effects of Transverse Acceleration-Induced Body Forces on the Capillary Limit of Helically Grooved Heat Pipes , 1998 .

[20]  Jentung Ku,et al.  Mathematical Modeling of Loop Heat Pipes , 1999 .

[21]  Jentung Ku,et al.  Experimental Investigation of Performance Characteristics of Small Loop Heat Pipes , 2003 .

[22]  Amir Faghri,et al.  Heat Pipe Science And Technology , 1995 .