论文信息 - Predicting Material Removal Rate of Electrical Discharge Machining (EDM) using Artificial Neural Network for High Igap current

Predicting Material Removal Rate of Electrical Discharge Machining (EDM) using Artificial Neural Network for High Igap current

This article presents a prediction of Material Removal Rate (MRR) in Electrical Discharge Machining (EDM) using Artificial Neural Network (ANN). Experimental data were gathered from Die sinking EDM process for copper-electrode and steel-workpiece. It is aimed to develop a behavioral model using input-output pattern of raw data from EDM process experiment. The behavioral model is used to predict MRR and than the predicted MRR is compared to actual MRR value. The results show good agreement of predicting MRR between them.

Azli Yahya | Trias Andromeda | Kamal Khalil | Ade Erawan | Nor Hisham

[1] C. L. Lin,et al. Optimisation of the EDM Process Based on the Orthogonal Array with Fuzzy Logic and Grey Relational Analysis Method , 2002 .

[2] S. Hyakin,et al. Neural Networks: A Comprehensive Foundation , 1994 .

[3] C. L. Lin,et al. The use of grey-fuzzy logic for the optimization of the manufacturing process , 2005 .

[4] Yi Wang,et al. A hybrid intelligent method for modelling the EDM process , 2003 .

[5] Azli Yahya. Digital control of an electro discharge machining (EDM) system , 2005 .

[6] Surjya K. Pal,et al. Modeling of electrical discharge machining process using back propagation neural network and multi-objective optimization using non-dominating sorting genetic algorithm-II , 2007 .

[7] Azli Yahya,et al. Determination of material removal rate of an electro-discharge machine using dimensional analysis , 2004 .

[8] Stephen T. Newman,et al. State of the art electrical discharge machining (EDM) , 2003 .

[9] Yang Dayong,et al. The study of high efficiency and intelligent optimization system in EDM sinking process , 2004 .

[10] M. S. Shunmugam,et al. Multi-objective optimization of wire-electro discharge machining process by Non-Dominated Sorting Genetic Algorithm , 2005 .

[11] Y. S. Tarng,et al. Optimisation of the electrical discharge machining process using a GA-based neural network , 2003 .

[12] Ernesto Córdoba Nieto. Manufactura y automatización , 2006 .