Design of a Humidity Sensor Tag for Passive Wireless Applications

This paper presents a wireless humidity sensor tag for low-cost and low-power applications. The proposed humidity sensor tag, based on radio frequency identification (RFID) technology, was fabricated in a standard 0.18 μm complementary metal oxide semiconductor (CMOS) process. The top metal layer was deposited to form the interdigitated electrodes, which were then filled with polyimide as the humidity sensing layer. A two-stage rectifier adopts a dynamic bias-voltage generator to boost the effective gate-source voltage of the switches in differential-drive architecture, resulting in a flat power conversion efficiency curve. The capacitive sensor interface, based on phase-locked loop (PLL) theory, employs a simple architecture and can work with 0.5 V supply voltage. The measurement results show that humidity sensor tag achieves excellent linearity, hysteresis and stability performance. The total power-dissipation of the sensor tag is 2.5 μW, resulting in a maximum operating distance of 23 m under 4 W of radiation power of the RFID reader.

[1]  Peter M. Asbeck,et al.  Near zero turn-on voltage high-efficiency UHF RFID rectifier in silicon-on-sapphire CMOS , 2010, 2010 IEEE Radio Frequency Integrated Circuits Symposium.

[2]  Gwiy-Sang Chung,et al.  Humidity sensing characteristics of Ga-doped zinc oxide film grown on a polycrystalline AlN thin film based on a surface acoustic wave , 2010 .

[3]  Jérôme Courbat,et al.  Temperature, humidity and gas sensors integrated on plastic foil for low power applications , 2009 .

[4]  T. Akin,et al.  A Low-Power Robust Humidity Sensor in a Standard CMOS Process , 2007, IEEE Transactions on Electron Devices.

[5]  Youngcheol Chae,et al.  A 1.2-V 8.3-nJ CMOS Humidity Sensor for RFID Applications , 2013, IEEE Journal of Solid-State Circuits.

[6]  Yigang He,et al.  A Novel Localization Algorithm Based on Isomap and Partial Least Squares for Wireless Sensor Networks , 2013, IEEE Transactions on Instrumentation and Measurement.

[7]  P. Nikitin,et al.  Antenna design for UHF RFID tags: a review and a practical application , 2005, IEEE Transactions on Antennas and Propagation.

[8]  Yigang He,et al.  A CMOS Humidity Sensor for Passive RFID Sensing Applications , 2014, Sensors.

[9]  Philipp Häfliger,et al.  An energy efficient inverter based readout circuit for capacitive sensor , 2013, 2013 IEEE Biomedical Circuits and Systems Conference (BioCAS).

[10]  Sung-Min Hong,et al.  High sensitivity capacitive humidity sensor with a novel polyimide design fabricated by MEMS technology , 2009, 2009 4th IEEE International Conference on Nano/Micro Engineered and Molecular Systems.

[11]  Gerard C. M. Meijer,et al.  An Energy-Efficient 15-Bit Capacitive-Sensor Interface Based on Period Modulation , 2012, IEEE Journal of Solid-State Circuits.

[12]  Shahriar Mirabbasi,et al.  An efficiency enhancement technique for CMOS rectifiers with low start-up voltage for UHF RFID tags , 2013, 2013 International Green Computing Conference Proceedings.

[13]  Paulo S. André,et al.  Optical Fiber Relative Humidity Sensor Based on a FBG with a Di-Ureasil Coating , 2012, Sensors.

[14]  Erkka Laulainen,et al.  A Micropower �-Based Interface ASIC for a Capacitive 3-Axis Micro-Accelerometer , 2009 .

[15]  Soumyajit Mandal,et al.  Low-Power CMOS Rectifier Design for RFID Applications , 2007, IEEE Transactions on Circuits and Systems I: Regular Papers.

[16]  A. Demosthenous,et al.  Humidity-to-Frequency Sensor in CMOS Technology With Wireless Readout , 2013, IEEE Sensors Journal.

[17]  Henry Baltes,et al.  High sensitivity CMOS humidity sensors with on-chip absolute capacitance measurement system , 1993 .

[18]  Roc Berenguer,et al.  A passive UHF RFID pressure sensor tag with a 7.27 bit and 5.47pJ capacitive sensor interface , 2012, 2012 IEEE/MTT-S International Microwave Symposium Digest.

[19]  Sailing He,et al.  Optical fiber relative humidity sensor based on FBG incorporated thin-core fiber modal interferometer. , 2011, Optics express.

[20]  Ching-Liang Dai,et al.  A capacitive humidity sensor integrated with micro heater and ring oscillator circuit fabricated by CMOS–MEMS technique , 2007 .

[21]  Yigang He,et al.  Metric of the Application Environment Impact to the Passive UHF RFID System , 2014, IEEE Transactions on Instrumentation and Measurement.

[22]  Suhwan Kim,et al.  A Delta–Sigma Interface Circuit for Capacitive Sensors With an Automatically Calibrated Zero Point , 2011, IEEE Transactions on Circuits and Systems II: Express Briefs.

[23]  Ming Qin,et al.  A novel capacitive-type humidity sensor using CMOS fabrication technology , 2004 .

[24]  E. Abad,et al.  RFID smart tag for traceability and cold chain monitoring of foods: Demonstration in an intercontinental fresh fish logistic chain , 2009 .

[25]  Georges Gielen,et al.  A novel, PLL-based frequency-to-digital conversion mechanism for sensor interfaces , 2011 .

[26]  Chen Wei,et al.  High-Efficiency Differential RF Front-End for a Gen2 RFID Tag , 2011, IEEE Transactions on Circuits and Systems II: Express Briefs.

[27]  K. Kotani,et al.  High-Efficiency Differential-Drive CMOS Rectifier for UHF RFIDs , 2009, IEEE Journal of Solid-State Circuits.

[28]  Wei-Hung Hsu,et al.  A Capacitance-Ratio-Modulated Current Front-End Circuit With Pulsewidth Modulation Output for a Capacitive Sensor Interface , 2012, IEEE Transactions on Instrumentation and Measurement.

[29]  Erkka Laulainen,et al.  A Micropower $\Delta\Sigma$-Based Interface ASIC for a Capacitive 3-Axis Micro-Accelerometer , 2009, IEEE Journal of Solid-State Circuits.

[30]  Ching-Liang Dai,et al.  Fabrication of a micro humidity sensor with polypyrrole using the CMOS process , 2010, 2010 IEEE 5th International Conference on Nano/Micro Engineered and Molecular Systems.

[31]  Wen Wang,et al.  Optimal Design of a Polyaniline-Coated Surface Acoustic Wave Based Humidity Sensor , 2013, Sensors.

[32]  Ming Qin,et al.  A Fully Packaged CMOS Interdigital Capacitive Humidity Sensor With Polysilicon Heaters , 2011, IEEE Sensors Journal.

[33]  Mikko Saukoski,et al.  A Micropower Interface ASIC for a Capacitive 3-Axis Micro-Accelerometer , 2007, IEEE Journal of Solid-State Circuits.

[34]  Catherine Dehollain,et al.  A passive UHF RFID system with a low-power capacitive sensor interface , 2014, 2014 IEEE RFID Technology and Applications Conference (RFID-TA).

[35]  Kazusuke Maenaka,et al.  Self-Calibrated Humidity Sensor in CMOS without Post-Processing , 2012, Sensors.

[36]  Antonella Macagnano,et al.  Design and optimization of an ultra thin flexible capacitive humidity sensor , 2009 .

[37]  Ahmed Ashry,et al.  A compact low-power UHF RFID tag , 2009, Microelectron. J..

[38]  Shahriar Mirabbasi,et al.  A CMOS rectifier with an extended high-efficiency region of operation , 2013, 2013 IEEE International Conference on RFID-Technologies and Applications (RFID-TA).