Centrifuge Modeling of a Pile-Supported Granular Earth-Platform

AbstractSoil reinforcement by vertical rigid piles is a suitable technique to solve soft-soil foundation problems. This technique consists of transferring the load of a pile-supported structure to a resistant, less compressible soil layer. The loads are transferred on pile heads by arching mechanisms in an earth-platform located between piles and structure. The role of the earth-platform is to distribute the loads among the piles and to minimize the fraction of the load applied on the soft compressible soil. Centrifuge tests are performed at 12 and 20×g levels of acceleration with a specific apparatus containing 63 rigid piles. The behavior of a granular earth-platform with rigid pile reinforcement is studied. The granular earth-platform is simulated with Hostun sand. The physical model is widely instrumented to compare the load-transfer efficiency and the surface settlements for several geometrical configurations. The influence of the height of the earth-platform and the spacing between the piles on load...

[1]  Vedrana Krstić,et al.  Ground Improvement Utilizing Vibro-Concrete Columns , 2004 .

[2]  J. G. Collin,et al.  U. S. State-of-Practice for the Design of the Geosynthetic Reinforced Load Transfer Platform in Column Supported Embankments , 2007 .

[3]  Jie Han,et al.  Numerical Analysis of Geosynthetic-Reinforced and Pile-Supported Earth Platforms over Soft Soil , 2002 .

[4]  L. Briançon,et al.  Performance of pile-supported embankment over soft soil: full-scale experiment. , 2012 .

[5]  Jie Han,et al.  Column-Supported Embankment Solves Time Constraint for New Road Construction , 2005 .

[6]  George M. Filz,et al.  Analysis of a Column-Supported Test Embankment at the I-95/Route 1 Interchange , 2004 .

[7]  Luc Thorel,et al.  3D load transfer in pile-supported earth platforms over soft soils : centrifuge modeling , 2010 .

[8]  E Ellis,et al.  Arching in piled embankments: comparison of centrifuge tests and predictive methods - part 1 of 2 , 2009 .

[9]  Mark Randolph,et al.  Catalogue of scaling laws and similitude questions in geotechnical centrifuge modelling , 2007 .

[10]  V. Choa,et al.  Arching in Piled Embankments , 1994 .

[11]  P. Simonini,et al.  Safeguarding Venice from high tides: site characterization & geotechnical problems , 2009 .

[12]  A. Pecker,et al.  Use of Centrifuge Tests for the Validation of Innovative Concepts in Foundation Engineering , 1998 .

[13]  Luc Thorel,et al.  Centrifuge investigation of load transfer mechanisms in a granular mattress above a rigid inclusions network , 2013 .

[14]  Luc Thorel,et al.  Mobile tray for simulation of 3D load transfer in pile-supported earth platforms , 2010 .

[15]  U. S. Okyay.  Etude expérimentale et numérique des transferts de charge dans un massif renforcé par inclusions rigides : application à des cas de chargements statiques et dynamiques , 2010 .

[16]  V. Fioravante.  Load transfer from a raft to a pile with an interposed layer , 2011 .

[17]  Alain Pecker.  DESIGN AND CONSTRUCTION OF THE RION ANTIRION BRIDGE , 2004 .

[18]  Jie Han,et al.  SIMPLIFIED METHOD FOR CONSOLIDATION RATE OF STONE COLUMN REINFORCED FOUNDATIONS , 2001 .

[19]  Andrew Schofield,et al.  Cambridge Geotechnical Centrifuge Operations , 1980 .

[20]  K. Terzaghi.  Theoretical Soil Mechanics , 1943 .

[21]  G. M. Filz,et al.  Net Vertical Loads on Geosynthetic Reinforcement in Column-Supported Embankments , 2007 .

[22]  Y. K. Chow,et al.  Performance of Oil Tank Foundation , 2005 .