Abstract A field trial was conducted at the University of Wales Bangor Research Centre, Gwynedd using five varieties of hemp, sown at two seed rates: 150 and 300 seeds m −2 to determine the optimum time to cut hemp to maximise fibre yield and quality. Three cutting times were imposed from mid-August to mid-September, corresponding to start of flowering, mid-point of flowering and end of flowering, and following dew-retting in the field fibre from the stems was extracted to determine fibre yield and quality. A wide variation was found in fibre yields between the five varieties, although the first cut in mid-August resulted in the highest yields in all varieties except for Beniko. A decline in fibre yield was recorded from the first to the third cut and it is suggested that this is a result of lignification of the fibres occurring after mid-August. The importance of cutting hemp early in autumn to avoid lignification of the fibres is discussed, and it is suggested that varieties with reduced or delayed onset of lignification are important in the prevailing colder, wetter climates of the more northerly latitudes. The higher seed rate led to better weed suppression and higher fibre yields in all varieties. The monoecious varieties performed better than the dioecious and hybrid varieties in the northern climate where the trial was conducted. It is suggested that further research is required to develop a more accurate method of monitoring retting in the field.
[1]
Rowan Reid,et al.
The Australian Master Tree Grower Program
,
2001,
Australian Journal of Environmental Education.
[2]
Hannele S Sankari,et al.
Comparison of bast fibre yield and mechanical fibre properties of hemp (Cannabis sativa L.) cultivars
,
2000
.
[3]
H.T.H Cromack,et al.
The effect of cultivar and seed density on the production and fibre content of Cannabis sativa in southern England
,
1998
.
[4]
H. V. D. Werf,et al.
Plant density and self-thinning affect yield and quality of fibre hemp (Cannabis sativa L.).
,
1995
.
[5]
A. J. Haverkort,et al.
The potential of hemp (Cannabis sativa L.) for sustainable fibre production: a crop physiological appraisal
,
1996
.
[6]
P. Cappelletto,et al.
Italy-grown hemp: yield, composition and cannabinoid content
,
2001
.
[7]
I. Bócsa,et al.
The Cultivation of Hemp: Botany, Varieties, Cultivation and Harvesting
,
1998
.
[8]
H. V. D. Werf,et al.
Quality of hemp (Cannabis sativa L.) stems as a raw material for paper.
,
1994
.
[9]
Bo Smeder,et al.
Market oriented identification of important properties in developing flax fibres for technical uses
,
1996
.
[10]
P. Struik,et al.
Agronomy of fibre hemp (Cannabis sativa L.) in Europe.
,
2000
.