Quantitative planar laser-induced fluorescence imaging of multi-component fuel/air mixing in a firing gasoline-direct-injection engine: Effects of residual exhaust gas on quantitative PLIF

Abstract A study of in-cylinder fuel–air mixing distributions in a firing gasoline-direct-injection engine is reported using planar laser-induced fluorescence (PLIF) imaging. A multi-component fuel synthesised from three pairs of components chosen to simulate light, medium and heavy fractions was seeded with one of three tracers, each chosen to co-evaporate with and thus follow one of the fractions, in order to account for differential volatility of such components in typical gasoline fuels. In order to make quantitative measurements of fuel–air ratio from PLIF images, initial calibration was by recording PLIF images of homogeneous fuel–air mixtures under similar conditions of in-cylinder temperature and pressure using a re-circulation loop and a motored engine. This calibration method was found to be affected by two significant factors. Firstly, calibration was affected by variation of signal collection efficiency arising from build-up of absorbing deposits on the windows during firing cycles, which are not present under motored conditions. Secondly, the effects of residual exhaust gas present in the firing engine were not accounted for using a calibration loop with a motored engine. In order to account for these factors a novel method of PLIF calibration is presented whereby ‘bookend’ calibration measurements for each tracer separately are performed under firing conditions, utilising injection into a large upstream heated plenum to promote the formation of homogeneous in-cylinder mixtures. These calibration datasets contain sufficient information to not only characterise the quantum efficiency of each tracer during a typical engine cycle, but also monitor imaging efficiency, and, importantly, account for the impact of exhaust gas residuals (EGR). By use of this method EGR is identified as a significant factor in quantitative PLIF for fuel mixing diagnostics in firing engines. The effects of cyclic variation in fuel concentration on burn rate are analysed for different fuel injection strategies. Finally, mixture distributions for late injection obtained using quantitative PLIF are compared to predictions of computational fluid dynamics calculations.

[1]  Chung King Law,et al.  Recent advances in droplet vaporization and combustion , 1982 .

[2]  Hua Zhao,et al.  Engine combustion instrumentation and diagnostics , 2001 .

[3]  R. Hanson,et al.  UV absorption of CO2 for temperature diagnostics of hydrocarbon combustion applications , 2004 .

[4]  N. Tait,et al.  2D laser induced fluorescence imaging of parent fuel fraction in nonpremixed combustion , 1992 .

[6]  J. E. Peters,et al.  Pressure dependence of laser-induced fluorescence from acetone. , 1997, Applied optics.

[7]  Investigation of toluene LIF at high pressure and high temperature in an optical engine , 2009 .

[8]  Simone Hochgreb,et al.  Effects of fuel volatility and operating conditions on fuel sprays in Disi engines: (1) imaging investigation , 2000 .

[9]  Nick Collings,et al.  The fast-response flame ionization detector , 1998 .

[10]  V. Sick,et al.  Multi-Component Fuel Imaging in a Spray-Guided Spark-Ignition Direct-Injection Engine , 2007 .

[11]  Ronald K. Hanson,et al.  Simultaneous Imaging of Exhaust Gas Residuals and Temperature During HCCI Combustion , 2009 .

[12]  R. Hanson,et al.  Oxygen quenching of toluene fluorescence at elevated temperatures , 2005 .

[13]  A. A. Amsden,et al.  KIVA-3V: A Block-Structured KIVA Program for Engines with Vertical or Canted Valves , 1997 .

[14]  Jaal Ghandhi,et al.  On the fluorescent behavior of ketones at high temperatures , 1996 .

[15]  Robert T. Hahn,et al.  IN-CYLINDER CHARGE HOMOGENEITY DURING COLD-START STUDIED WITH FLUORESCENT TRACERS SIMULATING DIFFERENT FUEL DISTILLATION TEMPERATURES , 1995 .

[16]  Richard R. Steeper,et al.  An LIF equivalence ratio imaging technique for multicomponent fuels in an IC engine , 2002 .

[17]  Jun Qiao,et al.  Multi-Component Quantitative PLIF: Robust Engineering Measurements of Cyclic Variation in a Firing Spray-Guided Gasoline Direct Injection Engine , 2008 .

[18]  Domenic A. Santavicca,et al.  Fuel Volatility Effects on Mixture Preparation and Performance in a GDI Engine During Cold Start , 2001 .

[19]  W. Sirignano.  Fuel droplet vaporization and spray combustion theory , 1983 .

[20]  A. Donkerbroek,et al.  Attenuation corrections for in-cylinder NO LIF measurements in a heavy-duty Diesel engine , 2006 .

[21]  Volker Sick,et al.  Quantitative, Dynamic Fuel Distribution Measurements in Combustion-Related Devices Using Laser-Induced Fluorescence Imaging of Biacetyl in Iso-Octane , 2007 .

[22]  Volker Sick,et al.  Tracer-LIF diagnostics: quantitative measurement of fuel concentration, temperature and fuel/air ratio in practical combustion systems , 2005 .

[23]  Ronald K. Hanson,et al.  Predicting LIF signal strength for toluene and 3-pentanone under engine-related temperature and pressure conditions , 2004 .

[24]  R. Cracknell,et al.  On planar laser-induced fluorescence with multi-component fuel and tracer design for quantitative determination of fuel concentration in internal combustion engines , 2007 .

[25]  J. J. ter Meulen,et al.  Quantitative laser-induced fluorescence measurements of nitric oxide in a heavy-duty Diesel engine , 2006 .

[26]  R. A. White,et al.  Multicomponent liquid and vapor fuel measurements in the cylinder of a port-injected, spark ignition engine , 1998 .

[27]  Andrew McIlroy,et al.  Research needs for future internal combustion engines , 2008 .

[28]  R. Hanson,et al.  Measurements and modeling of acetone laser-induced fluorescence with implications for temperature-imaging diagnostics. , 1998, Applied optics.

[29]  D. A. Greenhalgh.  Laser imaging of fuel injection systems and combustors , 2000 .

[30]  Pavlos Aleiferis,et al.  Effect of Fuel Properties on Spray Development from a Multi-Hole DISI Engine Injector , 2007 .

[31]  A. Eckbreth.  Laser Diagnostics for Combustion Temperature and Species , 1988 .

[32]  KoHse-HoingHaus.  Applied Combustion Diagnostics , 2002 .

[33]  K. Kikuchi,et al.  New aspects of fluorescence quenching by molecular oxygen , 1993 .

[34]  D. Kearns,et al.  Role of Singlet Excited States of Molecular Oxygen in the Quenching of Organic Triplet States , 1967 .

[35]  Steven Wooldridge,et al.  Modeling of DISI Engine Sprays with Comparison to Experimental In-Cylinder Spray Images , 2001 .