CFD modelling of an entire synchronous generator for improved thermal management

This paper is the first in a series dedicated to investigating the airflow and thermal management of electrical machines. Due to the temperature dependent resistive losses in the machine's windings any improvement in cooling provides a direct reduction in losses and an increase in efficiency. This paper focuses on the airflow which is intrinsically linked to the thermal behaviour of the machine as well as the windage power consumed to drive the air through the machine. A full CFD model has been used to analyse the airflow around all major components of the machine. Results have been experimentally validated and investigated. At synchronous speed the experimentally tested mass flow rate and torque were under predicted by 4% and 30% respectively by the CFD. A break-down of torque by component shows that the fan consumes approximately 87% of the windage torque. (6 pages)

[1]  Andrea Cavagnino,et al.  Experimental assessment of end region cooling arrangements in induction motor endwindings , 2011 .

[2]  R. G. Kenny,et al.  Simulation of airflow and heat transfer in small alternators using CFD , 2003 .

[3]  D. A. Howey,et al.  Measurement and CFD Prediction of Heat Transfer in Air-Cooled Disc-Type Electrical Machines , 2011, IEEE Transactions on Industry Applications.

[4]  C. Gerada,et al.  A combined electromagnetic and thermal optimisation of an aerospace electric motor , 2010, The XIX International Conference on Electrical Machines - ICEM 2010.

[5]  A. Boglietti,et al.  Determination of Critical Parameters in Electrical Machine Thermal Models , 2007 .

[6]  Rafal Wrobel,et al.  Thermal Performance of an Open-Slot Modular-Wound Machine With External Rotor , 2010, IEEE Transactions on Energy Conversion.

[7]  Stephen Pickering,et al.  Recent Advancement in the Thermal Design of Electric Motors , 2001 .

[8]  Stephen J. Pickering,et al.  Improved Cooling in the End Region of a Strip-Wound Totally Enclosed Fan-Cooled Induction Electric Machine , 2008, IEEE Transactions on Industrial Electronics.

[9]  M. Shanel,et al.  Ventilation and heat transfer in a symmetrically ventilated salient pole synchronous machine , 2002 .

[10]  A. Mebarki,et al.  Improved synchronous machine thermal modelling , 2008, 2008 18th International Conference on Electrical Machines.

[11]  Wu Mei,et al.  Determination of thermal performance of small electric motors , 2001, 4th IEEE International Conference on Power Electronics and Drive Systems. IEEE PEDS 2001 - Indonesia. Proceedings (Cat. No.01TH8594).

[12]  C. Gerada,et al.  Analysis of the end winding heat transfer variation with altitude in electric motors , 2009, 2009 35th Annual Conference of IEEE Industrial Electronics.

[13]  Andrea Cavagnino,et al.  Evolution and Modern Approaches for Thermal Analysis of Electrical Machines , 2009, IEEE Transactions on Industrial Electronics.

[14]  Christopher Micallef,et al.  End winding cooling in electric machines , 2006 .

[15]  S. J. Kline,et al.  Describing Uncertainties in Single-Sample Experiments , 1953 .