Experiments and discrete element method simulations of distribution of static load of grain bedding at bottom of shallow model silo

The influences of a filling method, seed size and seed aspect ratio on the radial distribution of the vertical pressure at the bottom of a shallow model silo were studied. Two filling methods were applied: central and circumferential. Seeds of five varieties were used: horse bean (Vicia faba), field pea (Pisum sativum), wheat (Triticum), vetch (Vicia) and rapeseed (Brassica napus). The vertical pressure at the bottom was influenced by the filling methods and seed size. A significant dip in the vertical pressure near the centre of the silo radius was observed in each experimental case except the rapeseed case. Discrete element method (DEM) simulations confirmed the impact of the filling methods on the pressure distribution. The pressure increased with increasing radius for central filling and decreased with increasing radius for circumferential filling. DEM simulations of filling with higher particle kinetic energies produced the greatest vertical pressures near the centre of the silo radius, whereas the lowest values were located close to the silo centre and wall.

[1]  I. J. Ross,et al.  Wheat Loads and Vertical Pressure Distribution in a Full-scale bin Part II – Detention , 1996 .

[2]  William McBride,et al.  Base Pressure Measurements under a Scale Model Stockpile , 2006 .

[3]  J. M. Huntley,et al.  Contact Force Distribution Beneath a Three-Dimensional Granular Pile , 1997 .

[4]  Asae Ep.  Loads Exerted by Irish Potatoes in Shallow Bulk Storage Structures , 1998 .

[5]  Józef Horabik,et al.  Effects of Spatial Orientation on Grain Load Distribution , 1988 .

[6]  C. González-Montellano,et al.  Three dimensional discrete element models for simulating the filling and emptying of silos: Analysis of numerical results , 2012, Comput. Chem. Eng..

[7]  Paul W. Cleary,et al.  Forces in piles of granular material: an analytic and 3D DEM study , 2001 .

[8]  T. Pöschel,et al.  The microscopic structure of mono-disperse granular heaps and sediments of particles on inclined surfaces. , 2016, Soft matter.

[9]  S. Antony.  Link between single-particle properties and macroscopic properties in particulate assemblies: role of structures within structures , 2007, Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences.

[10]  S. Masson,et al.  Effect of particle mechanical properties on silo flow and stresses from distinct element simulations , 2000 .

[11]  F. Maio,et al.  Comparison of contact-force models for the simulation of collisions in DEM-based granular flow codes , 2004 .

[12]  Aibing Yu,et al.  Angle of repose and stress distribution of sandpiles formed with ellipsoidal particles , 2014 .

[13]  G. M. White,et al.  Wheat Loads and Vertical Pressure Distribution in a Full-scale Bin Part I — Filling , 1994 .

[14]  M. Kraume,et al.  Influence of the wall structure on the void fraction distribution in packed beds , 2012 .

[15]  Stephen C. Cowin,et al.  The Theory of Static Loads in Bins , 1977 .

[16]  Ja.B. Lvin,et al.  Analytical evaluation of pressures of granular materials on silo walls , 1971 .

[17]  M. Molenda,et al.  Parameters and contact models for DEM simulations of agricultural granular materials: A review , 2016 .

[18]  Yutaka Tsuji,et al.  Lagrangian numerical simulation of plug flow of cohesionless particles in a horizontal pipe , 1992 .

[19]  R. Behringer,et al.  Force networks and elasticity in granular silos , 2008, The European physical journal. E, Soft matter.

[20]  Zenon Mróz,et al.  Investigation of wall stress and outflow rate in a flat-bottomed bin: A comparison of the DEM model results with the experimental measurements , 2011 .

[21]  Alan W. Roberts,et al.  Particle Technology—Reflections and Horizons , 1998 .

[22]  Heald,et al.  Granule-by-granule reconstruction of a sandpile from x-ray microtomography data , 2000, Physical review. E, Statistical physics, plasmas, fluids, and related interdisciplinary topics.

[23]  Jin Y. Ooi,et al.  Numerical investigation of progressive development of granular pile with spherical and non-spherical particles , 2009 .

[24]  Marek Molenda,et al.  EFFECT OF FILLING METHOD ON LOAD DISTRIBUTION IN MODEL GRAIN BINS , 1996 .

[25]  Jørgen Nielsen,et al.  Pressures from flowing granular solids in silos , 1998, Philosophical Transactions of the Royal Society of London. Series A: Mathematical, Physical and Engineering Sciences.

[26]  Marek Molenda,et al.  DEM simulation of the packing structure and wall load in a 2-dimensional silo , 2008 .

[27]  S. A. Thompson,et al.  The Effect of Floor Flexibility on the Vertical Pressures in a Model Grain Bin , 1994 .

[28]  I Zuriguel,et al.  Effect of particle shape on the stress dip under a sandpile. , 2007, Physical review letters.