论文信息 - A New On-Line Dead-Time Compensator for Single-Phase PV Inverter

A New On-Line Dead-Time Compensator for Single-Phase PV Inverter

This paper presents a new software-based on-line dead-time compensation technique for single-phase grid-connected photovoltaic (PV) inverter system. To improve the mitigation of dead-time effect around the zero-crossing point of phase current, a selective harmonic elimination of instantaneous feedback current is used as an additional part of conventional current control scheme. Simulation and experimental results are shown to verify the effectiveness of proposed compensation method in the gridconnected power distributed generation systems.

[1] Tomonobu Senjyu,et al. An Adaptive Dead-time Compensation Strategy for a Permanent Magnet Synchronous Motor Drive Using Neural Network , 2006 .

[2] Hyun-Soo Kim,et al. On-line dead-time compensation method using disturbance observer , 2003 .

[3] Seung-Gi Jeong,et al. The analysis and compensation of dead-time effects in PWM inverters , 1991 .

[4] Seung-Ki Sul,et al. A new compensation strategy reducing voltage/current distortion in PWM VSI systems operating with low output voltages , 1995 .

[5] Karl Johan Åström,et al. Adaptive Control , 1989, Embedded Digital Control with Microcontrollers.

[6] Bernard Widrow,et al. Adaptive Signal Processing , 1985 .

[7] K. Uezato,et al. An adaptive dead-time compensation strategy for voltage source inverter fed motor drives , 2005, IEEE Transactions on Power Electronics.

[8] V. Blasko,et al. A Novel Method for Selective Harmonic Elimination in Power Electronic Equipment , 2007, IEEE Transactions on Power Electronics.

[9] Thomas A. Lipo,et al. On-line dead-time compensation technique for open-loop PWM-VSI drives , 1999 .

[10] R. Ueda,et al. Stability problem in induction motor drive system , 1988, Conference Record of the 1988 IEEE Industry Applications Society Annual Meeting.