Design of an 87% Fractional Bandwidth Doherty Power Amplifier Supported by a Simplified Bandwidth Estimation Method

This paper presents a novel technique for the design of broadband Doherty power amplifiers (DPAs), supported by a simplified approach for the initial bandwidth estimation that requires linear simulations only. The equivalent impedance of the Doherty inverter is determined by the value of the output capacitance of the power device, and the Doherty combiner is designed following this initial choice and using a microstrip network. A GaN-based single-input DPA designed adopting this method exhibits, on a state-of-the-art bandwidth of 87% (1.5–3.8 GHz), a measured output power of around 20 W with 6 dB back-off efficiency between 33% and 55%, with a gain higher than 10 dB. System-level measurements prove the linearizability of the designed Doherty amplifier when a modulated signal is applied.

[1]  Franco Giannini,et al.  An Ultra-Broadband GaN Doherty Amplifier with 83% of Fractional Bandwidth , 2014, IEEE Microwave and Wireless Components Letters.

[2]  Renato Negra,et al.  Broadband Sequential Power Amplifier With Doherty-Type Active Load Modulation , 2015, IEEE Transactions on Microwave Theory and Techniques.

[3]  Bumman Kim,et al.  The Doherty Power Amplifier: Review of Recent Solutions and Trends , 2015, IEEE Transactions on Microwave Theory and Techniques.

[4]  Franco Giannini,et al.  Effect of Load Modulation on Phase Distortion in Doherty Power Amplifiers , 2014, IEEE Microwave and Wireless Components Letters.

[5]  S. Boumaiza,et al.  A Modified Doherty Configuration for Broadband Amplification Using Symmetrical Devices , 2012, IEEE Transactions on Microwave Theory and Techniques.

[6]  Christian Fager,et al.  A 1–3-GHz Digitally Controlled Dual-RF Input Power-Amplifier Design Based on a Doherty-Outphasing Continuum Analysis , 2013, IEEE Transactions on Microwave Theory and Techniques.

[7]  L.C.N. de Vreede,et al.  A wide-band 20W LMOS Doherty power amplifier , 2010, 2010 IEEE MTT-S International Microwave Symposium.

[8]  Jun Peng,et al.  A Post-Matching Doherty Power Amplifier Employing Low-Order Impedance Inverters for Broadband Applications , 2015, IEEE Transactions on Microwave Theory and Techniques.

[9]  F. Giannini,et al.  A Doherty Architecture With High Feasibility and Defined Bandwidth Behavior , 2013, IEEE Transactions on Microwave Theory and Techniques.

[10]  Marco Pirola,et al.  A 0.6–3.8 GHz GaN Power Amplifier Designed Through a Simple Strategy , 2016, IEEE Microwave and Wireless Components Letters.

[11]  Franco Giannini,et al.  The AB-C Doherty power amplifier. Part II: Validation , 2009 .

[12]  M. Pirola,et al.  Offset Lines in Doherty Power Amplifiers: Analytical Demonstration and Design , 2013, IEEE Microwave and Wireless Components Letters.

[13]  J. Lees,et al.  On the Continuity of High Efficiency Modes in Linear RF Power Amplifiers , 2009, IEEE Microwave and Wireless Components Letters.

[14]  Steve Cripps,et al.  New General Formulation and Experimental Verification of Harmonic Clipping Contours in High-Frequency Power Devices , 2017, IEEE Transactions on Microwave Theory and Techniques.

[15]  S.C. Cripps,et al.  A Theory for the Prediction of GaAs FET Load-Pull Power Contours , 1983, 1983 IEEE MTT-S International Microwave Symposium Digest.

[16]  A. Z. Markos,et al.  Frequency Response Analysis and Bandwidth Extension of the Doherty Amplifier , 2011, IEEE Transactions on Microwave Theory and Techniques.

[17]  Jose C. Pedro,et al.  AM/PM distortion in GaN Doherty power amplifiers , 2014, 2014 IEEE MTT-S International Microwave Symposium (IMS2014).

[18]  F. M. Ghannouchi,et al.  Mitigation of Bandwidth Limitation in Wireless Doherty Amplifiers With Substantial Bandwidth Enhancement Using Digital Techniques , 2012, IEEE Transactions on Microwave Theory and Techniques.

[19]  G. Ghione,et al.  3–3.6-GHz Wideband GaN Doherty Power Amplifier Exploiting Output Compensation Stages , 2012, IEEE Transactions on Microwave Theory and Techniques.

[20]  P. Asbeck,et al.  An extended Doherty amplifier with high efficiency over a wide power range , 2001, 2001 IEEE MTT-S International Microwave Sympsoium Digest (Cat. No.01CH37157).

[21]  Rolf H. Jansen,et al.  Broadband Doherty Power Amplifier via Real Frequency Technique , 2012, IEEE Transactions on Microwave Theory and Techniques.

[22]  Jose C. Pedro,et al.  A physical model of power amplifiers AM/AM and AM/PM distortions and their internal relationship , 2013, 2013 IEEE MTT-S International Microwave Symposium Digest (MTT).

[23]  Andrei Grebennikov,et al.  High-Efficiency Doherty Power Amplifiers: Historical Aspect and Modern Trends , 2012, Proceedings of the IEEE.

[24]  Fadhel M. Ghannouchi,et al.  A Broadband Doherty Power Amplifier Based on Continuous-Mode Technology , 2016, IEEE Transactions on Microwave Theory and Techniques.

[25]  Kwok-Keung M. Cheng,et al.  Improving Power Utilization Factor of Broadband Doherty Amplifier by Using Bandpass Auxiliary Transformer , 2015, IEEE Transactions on Microwave Theory and Techniques.