A fuzzy-logic-based controller for active rectifier

This paper presents a current-sensorless active rectifier specifically designed for low-cost applications. Both the control and the modulation use fuzzy logic. A simple model of the system is given in order to explain the current feedforward control using fuzzy logic and the fuzzy-logic-based modulation, then, the new algorithm is analyzed looking for high performance even using small passive elements and low switching frequency. Performance are compared with those of a closed-loop proportional-plus-integral (PI)-based rectifier with space-vector modulation (SVM). This comparison has been carried out either considering the whole systems or a combination of their components (PI control + fuzzy modulation or fuzzy feedforward control + SVM). The results show that even without current sensors, the low-frequency distortion of the line currents and the DC voltage oscillations produced by the proposed system are very limited, ensuring performance similar to those of PI-based closed loop active rectifiers.

[1]  Mariusz Malinowski,et al.  Virtual flux based direct power control of three-phase PWM rectifiers , 2000, Conference Record of the 2000 IEEE Industry Applications Conference. Thirty-Fifth IAS Annual Meeting and World Conference on Industrial Applications of Electrical Energy (Cat. No.00CH37129).

[2]  Mutsuo Nakaoka,et al.  Current-fed three-phase and voltage-fed three-phase active converters with optimum PWM pattern scheme and their performance evaluations , 1999, IEEE Trans. Ind. Electron..

[3]  Johan Enslin,et al.  New simplified control algorithm for synchronous rectifiers , 1995, Proceedings of IECON '95 - 21st Annual Conference on IEEE Industrial Electronics.

[4]  M. Liserre,et al.  A fuzzy logic CC-PWM three-phase AC/DC converter , 2000, Conference Record of the 2000 IEEE Industry Applications Conference. Thirty-Fifth IAS Annual Meeting and World Conference on Industrial Applications of Electrical Energy (Cat. No.00CH37129).

[5]  Karel Jezernik VSS control of unity power factor , 1999, IEEE Trans. Ind. Electron..

[6]  M. Liserre,et al.  A fuzzy logic feed-forward current controller for PWM rectifiers , 2000, ISIE'2000. Proceedings of the 2000 IEEE International Symposium on Industrial Electronics (Cat. No.00TH8543).

[7]  R. Wu,et al.  Analysis of an AC to DC voltage source converter using PWM with phase and amplitude control , 1989, Conference Record of the IEEE Industry Applications Society Annual Meeting,.

[8]  J. Fernando A. da Silva,et al.  Sliding-mode control of boost-type unity-power-factor PWM rectifiers , 1999, IEEE Trans. Ind. Electron..

[9]  F. Blaabjerg,et al.  Sensorless control strategies for PWM rectifier , 2000, APEC 2000. Fifteenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.00CH37058).

[10]  Toshihiko Noguchi,et al.  Direct power control of PWM converter without power source voltage sensors , 1996, IAS '96. Conference Record of the 1996 IEEE Industry Applications Conference Thirty-First IAS Annual Meeting.

[11]  J.H.R. Enslin,et al.  Sensorless current control for active rectifiers , 1996, IAS '96. Conference Record of the 1996 IEEE Industry Applications Conference Thirty-First IAS Annual Meeting.

[12]  Wen-Inne Tsai,et al.  Analysis and design of three-phase AC-to-DC converters with high power factor and near-optimum feedforward , 1999, IEEE Trans. Ind. Electron..

[13]  T. Lipo,et al.  Vector Control and Dynamics of AC Drives , 1996 .