Solid-state tap-changer of transformers: Design, control and implementation

This paper presents the implementation of a prototype electronic tap-changer of transformer. Mechanical tap-changer has many problems such as low operating speed, short lifetime and heavy size. In order to solve these problems a fully solid-state tap-changer with a new control strategy and optimal configuration is proposed. The design of tap-changer is discussed and bi-directional solid-state power electronics switches are implemented. Following the realization of the tap-changer controller, developed software for such precise control is introduced. To verify the design procedure and optimal configuration and apply the developed software, a prototype low-power tap-changer has been built and tested.

[1]  David A. Torrey,et al.  A new approach to solid-state on load tap changing transformers , 1998 .

[2]  P.W. Wheeler,et al.  Matrix converters , 2004, IEEE Industry Applications Magazine.

[3]  Dawei Gao,et al.  A new scheme for on-load tap-changer of transformers , 2002, Proceedings. International Conference on Power System Technology.

[4]  Roger Shuttleworth,et al.  New tap changing scheme , 1996 .

[5]  G. H. Cooke,et al.  Thyristor assisted on-load tap changers for transformers , 1990 .

[6]  J. Faiz,et al.  Differences between conventional and electronic tap-changers and modifications of controller , 2006, IEEE Transactions on Power Delivery.

[7]  G. H. Cooke,et al.  New thyristor assisted diverter switch for on load transformer tap changers , 1992 .

[8]  Frank Jay,et al.  IEEE standard dictionary of electrical and electronics terms , 1984 .

[9]  D. L. Bassett.  Control of tap change under load transformers through the use of programmable logic controllers , 1993 .

[10]  J. Faiz,et al.  New Controller for an Electronic Tap Changer—Part II: Measurement Algorithm and Test Results , 2007, IEEE Transactions on Power Delivery.

[11]  Florin Capitanescu,et al.  Decentralized tap changer blocking and load shedding against voltage instability: prospective tests on the RTE system , 2009 .

[12]  P. Bauer,et al.  Electronic tap changer for 500 kVA/10 kV distribution transformers: design, experimental results and impact in distribution networks , 1998, Conference Record of 1998 IEEE Industry Applications Conference. Thirty-Third IAS Annual Meeting (Cat. No.98CH36242).

[13]  J. Faiz,et al.  New Solid-State on-Load Tap-Changer Topology for Distribution Transformers , 2002, IEEE Power Engineering Review.

[14]  R. C. Degeneff.  A new concept for a solid-state on-load tap changers , 1997 .

[15]  J. Faiz,et al.  New Controller for an Electronic Tap Changer—Part I: Design Procedure and Simulation Results , 2007, IEEE Transactions on Power Delivery.

[16]  Hao Jiang,et al.  A novel thyristor-assisted tap changer scheme , 1997 .

[17]  D. O'Kelly,et al.  Solid-state on-load transformer tap changer , 1996 .

[18]  Jawad Faiz,et al.  New solid-state onload tap-changers topology for distribution transformers , 2003 .

[19]  Jawad Faiz,et al.  Implementation of a low-power electronic tap-changer in transformers , 2008 .