论文信息 - Static rigid force model for 3-axis ball-end milling of sculptured surfaces

Static rigid force model for 3-axis ball-end milling of sculptured surfaces

Abstract Static rigid force model is used to estimate cutting forces of sculptured surface in a straightforward way, without considering tool deflection, machine tool dynamic behavior and any vibration effects. Two programs were used for calculations, “ACIS” the 3-D geometric modeler and “VISUAL BASIC”. Two programs were edited and used to perform the calculations, the scheme program to model the work piece, tool and cutting edge and to obtain the geometric data and the VISUAL BASIC program design to use ACIS geometric data to calculate the cutting forces. The engaged part of the cutting edge and work piece is divided into small differential oblique cutting edge segments. Friction, shear angles and shear stresses are identified from orthogonal cutting database available in literature. The cutting force components, for each tool rotational position, are calculated by summing up the differential cutting forces. Laboratory tests were conducted to verify the predictions of the model. The work pieces were prepared from CK45 steel using an insert-type ball-end cutter. No coolant was used in any of the experimental works. The cutting forces predicted have shown good agreement with experimental results.

[1] Chia-Hsiang Menq,et al. The prediction of dimensional error for sculptured surface productions using the ball-end milling process. Part 2: Surface generation model and experimental verification , 1995 .

[2] Hsi-Yung Feng,et al. The prediction of dimensional error for sculptured surface productions using the ball-end milling process. Part 1: Chip geometry analysis and cutting force prediction , 1995 .

[3] Yusuf Altintas,et al. Prediction of Milling Force Coefficients From Orthogonal Cutting Data , 1996 .

[4] Mohamed A. Elbestawi,et al. Closed form formulation of cutting forces for ball and flat end mills , 1997 .

[5] Yusuf Altintas,et al. Prediction of Ball End Milling Forces , 1996 .

[6] Behnam Moetakef Imani,et al. An improved process simulation system for ball-end milling of sculptured surfaces , 1998 .

[7] M H Sadeghi,et al. MODELLING OF CUTTING FORCES IN BALL-END MILLING PROCESS , 2000 .

[8] Min-Yang Yang,et al. The prediction of cutting force in ball-end milling , 1991 .

[9] Hsi-Yung Feng,et al. The prediction of cutting forces in the ball-end milling process—I. Model formulation and model building procedure , 1994 .

[10] Yusuf Altintas,et al. Prediction of ball-end milling forces from orthogonal cutting data , 1996 .