Experimental study on air/steam gasification of leather scraps using U-type catalytic gasification for producing hydrogen-enriched syngas

Abstract The development of clean and low-cost hydrogen production method is of great research interests and environmental benefits. In this paper, a U-type gasification system which consisted of a downdraft gasifier, a cyclone separator and a catalytic tar cracking bed was delicately designed for producing hydrogen-enriched syngas from artificial leather scrap, typical industrial solid waste (ISW) discharged from shoes and suitcase manufactures. The influences of air/fuel equivalence ratio (ER), gasifying agent, catalyst, and reaction temperature were experimentally studied to achieve the optimal hydrogen yield and carbon conversion rate. Results showed that when saturated air was used as gasifying agent, H 2 yield reached a highest value of 74.75 g per kg ISW at ER = 0.3 and further increasing ER would decrease the yield of H 2 and deteriorated the syngas quality due to the promoted oxidation reaction and the dilution of N 2 . Compared with the pure air gasification, the addition of water vapor could significantly enhance the yield of hydrogen from 37.67 g/kg to 74.58 g/kg. Moreover, lower heat value (LHV) of syngas and carbon conversion efficiency increased by 22.5% and 17.9% at the gasification temperature of 700 °C, respectively, when replacing air with air/steam as the gasifying agent. The use of calcined dolomite could not only crack tar species in the syngas into light components efficiently, but also could reduce the concentration of CO 2 due to the recarbonation effect of CaO. Higher gasification temperature could promote H 2 yield, but the heat value of syngas would decrease. For ISW sample investigated in this study, the highest energy conversion efficiency of 84.4% was obtained at the gasification temperature of 700 °C and the ER of 0.2 when air/steam and calcined dolomite were used as gasifying agent and catalyst.

[1]  Y. Chi,et al.  Quantitative Model of Interactions in the Thermal Decomposition of Key Refuse-Derived Fuel Components , 2014 .

[2]  Bo Xiao,et al.  Syngas production from catalytic gasification of waste polyethylene: Influence of temperature on gas yield and composition , 2009 .

[3]  B. Xiao,et al.  Hydrogen-rich gas production by steam gasification of municipal solid waste (MSW) using NiO supported on modified dolomite , 2012 .

[4]  Paul Kruger,et al.  Electric power requirement for large-scale production of hydrogen fuel for the world vehicle fleet , 2001 .

[5]  C. M. Kinoshita,et al.  An experimental investigation of hydrogen production from biomass gasification , 1998 .

[6]  Jerry D. Murphy,et al.  Technical, economic and environmental analysis of energy production from municipal solid waste , 2004 .

[7]  Zhiquan Hu,et al.  Hydrogen-rich gas production by steam gasification of char derived from cyanobacterial blooms (CDCB) in a fixed-bed reactor: Influence of particle size and residence time on gas yield and syngas composition , 2010 .

[8]  Huang Hao,et al.  Hydrogen rich fuel gas production by gasification of wet biomass using a CO2 sorbent , 2009 .

[9]  Shaoping Xu,et al.  Steam gasification of apricot stones with olivine and dolomite as downstream catalysts , 2006 .

[10]  Bo Xiao,et al.  Hydrogen-rich gas production by steam gasification of char from biomass fast pyrolysis in a fixed-bed reactor: influence of temperature and steam on hydrogen yield and syngas composition. , 2010, Bioresource technology.

[11]  M. Horio,et al.  Axial gas profiles in a bubbling fluidised bed biomass gasifier , 2007 .

[12]  Wlodzimierz Blasiak,et al.  Effect of calcium oxide on high-temperature steam gasification of municipal solid waste , 2014 .

[13]  Hermann Hofbauer,et al.  H2 rich product gas by steam gasification of biomass with in situ CO2 absorption in a dual fluidized bed system of 8 MW fuel input , 2009 .

[14]  B. Feng,et al.  Variation of the pore structure of coal chars during gasification , 2003 .

[15]  Prabir Basu,et al.  An investigation into steam gasification of biomass for hydrogen enriched gas production in presence of CaO , 2010 .

[16]  O. Bičáková,et al.  Hydrogen-rich gas as a product of two-stage co-gasification of lignite/waste plastics mixtures , 2014 .

[17]  Fan Yang,et al.  Hydrogen-rich gas from catalytic steam gasification of municipal solid waste (MSW): Influence of catalyst and temperature on yield and product composition , 2009 .

[18]  Sumita Dixit,et al.  Toxic hazards of leather industry and technologies to combat threat: a review , 2015 .

[19]  U. Arena,et al.  Gasification of a solid recovered fuel in a pilot scale fluidized bed reactor , 2014 .

[20]  Bo Xiao,et al.  Hydrogen-rich gas from catalytic steam gasification of municipal solid waste (MSW): Influence of steam to MSW ratios and weight hourly space velocity on gas production and composition , 2009 .

[21]  Xiu-li Yin,et al.  Modeling biomass gasification in circulating fluidized beds , 2013 .

[22]  Baosheng Jin,et al.  Oxygen Gasification of Municipal Solid Waste in a Fixed-bed Gasifier , 2014 .

[23]  Jian-fen Li,et al.  Experimental study on catalytic steam gasification of municipal solid waste for bioenergy production in a combined fixed bed reactor. , 2012 .

[24]  Chuang-zhi Wu,et al.  Hydrogen-rich gas production from biomass air and oxygen/steam gasification in a downdraft gasifier , 2007 .

[25]  R. Yan,et al.  Hydrogen-rich gas production by steam gasification of palm oil wastes over supported tri-metallic catalyst , 2009 .

[26]  Isabel Cabrita,et al.  The study of reactions influencing the biomass steam gasification process , 2003 .

[27]  Rong Yan,et al.  Hydrogen-rich gas production by air–steam gasification of rice husk using supported nano-NiO/γ-Al2O3 catalyst , 2010 .

[28]  Zhiquan Hu,et al.  Hydrogen-rich gas from catalytic steam gasification of biomass in a fixed bed reactor: Influence of particle size on gasification performance , 2009 .

[29]  Masayuki Horio,et al.  Effects of gasifying conditions and bed materials on fluidized bed steam gasification of wood biomass. , 2009, Bioresource technology.

[30]  G. Sekaran,et al.  Safe disposal of toxic chrome buffing dust generated from leather industries. , 2008, Journal of hazardous materials.

[31]  Toshiyuki Suda,et al.  Distinctive effects of CaO additive on atmospheric gasification of biomass at different temperatures , 2005 .

[32]  Zhiquan Hu,et al.  Hydrogen-rich gas from catalytic steam gasification of biomass in a fixed bed reactor : Influence of temperature and steam on gasification performance , 2009 .

[33]  Jin Won Kim,et al.  Air gasification of mixed plastic wastes using a two-stage gasifier for the production of producer gas with low tar and a high caloric value , 2011 .

[34]  Fehmi Akgün,et al.  Experimental results of gasification of waste tire with air&CO2, air&steam and steam in a bubbling fluidized bed gasifier , 2012 .

[35]  G. Aranda,et al.  Effect of steam content in the air–steam flow on biomass entrained flow gasification , 2012 .

[36]  G De Feo,et al.  Energy from gasification of solid wastes. , 2003, Waste management.

[37]  Paul Kruger,et al.  Electric power requirement in the United States for large-scale production of hydrogen fuel , 2000 .

[38]  P. Foscolo,et al.  CO2 capture by means of dolomite in hydrogen production from syn gas , 2008 .

[39]  Chuijie Yi,et al.  Syngas production by catalytic steam gasification of municipal solid waste in fixed-bed reactor , 2012 .

[40]  B. Xiao,et al.  Steam catalytic gasification of municipal solid waste for producing tar-free fuel gas , 2009 .

[41]  Pedro Ollero,et al.  Gasification of wastes in a pilot fluidized bed gasifier , 2014 .

[42]  Lei Cai,et al.  Influence of particle size on pyrolysis and gasification performance of municipal solid waste in a fixed bed reactor. , 2010, Bioresource technology.

[43]  Jae Ik Na,et al.  Characteristics of oxygen-blown gasification for combustible waste in a fixed-bed gasifier , 2003 .