A method of in-flight surface flow visualization similar to wind-tunnel-model oil flows is described for cases where photo-chase planes or onboard photography are not practical. This method, used on an F-18 aircraft in flight at high angles of attack, clearly showed surface flow streamlines in the fuselage forebody. Vortex separation and reattachment lines were identified with this method and documented using postflight photography. Surface flow angles measured at the 90 and 270 degrees meridians show excellent agreement with the wind tunnel data for a pointed tangent ogive with an aspect ratio of 3.5. The separation and reattachment line locations were qualitatively similar to the F-18 wind-tunnel-model oil flows but neither the laminar separation bubble nor the boundary-layer transition on the wind tunnel model were evident in the flight surface flows. The separation and reattachment line locations were in fair agreement with the wind tunnel data for the 3.5 ogive. The elliptical forebody shape of the F-18 caused the primary separation lines to move toward the leeward meridian. Little effect of angle of attack on the separation locations was noted for the range reported.
[1]
James Crowder,et al.
Flow visualization techniques applied to full-scale vehicles
,
1987
.
[2]
D. J. Peake,et al.
The obstacle block as a device to measure turbulent skin friction in compressible flow
,
1982
.
[3]
R. E. Curry,et al.
The use of oil for in-flight flow visualization
,
1984
.
[4]
G. E. Erickson.
Water tunnel flow visualization and wind tunnel data analysis of the F/A-18. [leading edge extension vortex effects
,
1982
.
[5]
E. R. Keener,et al.
Flow-separation patterns on symmetric forebodies
,
1986
.
[6]
D. S. Mcrae,et al.
Flight experiments with a slender cone at angle of attack
,
1981
.