Experimental study on evaporation, condensation and production of a new Tubular Solar Still

This paper describes a comparison between our first model of a Tubular Solar Still (TSS) and a second one. The first model was designed by our research group using a vinyl chloride sheet as a transparent tubular cover. Since then, we have designed the second model that has improved the assembly, economy and maintenance over the first model. In the second model, a polythene film was adopted as the cover. As a result, the cover weight and cost of the second model were noticeably reduced and the durability was distinctly increased. A set of laboratory experiments was carried out using a special technique to investigate the evaporation, condensation and distilled water production performance independently and simultaneously on the second model. It was revealed that the hourly evaporation, condensation and production fluxes were proportional to the humid air temperature and relative humidity fraction. Consequently, an empirical equation was proposed based on this relation to predict the hourly production flux. The applicability of this equation was examined from the comparison with field experiments in Fukui, Japan and in Ras Al Khaimah, UAE. It was seen that the calculated results had a good agreement with the field data.

[1]  S. Das,et al.  Performance of a solar collector with different glazing materials and their degradation under the condition prevailing in a solar collector , 1991 .

[2]  Eli Korin,et al.  Water desalination by pervaporation with hollow fiber membranes , 1996 .

[3]  Hiroshi Tanaka,et al.  A highly productive basin-type-multiple-effect coupled solar still , 2000 .

[4]  W. E. Alnaser,et al.  Performances of single and double basin solar-stills , 2004 .

[5]  G. N. Tiwari,et al.  CHARACTERISATION OF SOLAR STILLS , 1996 .

[6]  Zhang Xiaoyan,et al.  A group of improved heat and mass transfer correlations in solar stills , 2002 .

[7]  Amimul Ahsan,et al.  Production model of new tubular solar still and its productivity characteristics , 2009 .

[8]  Bassam Abu-Hijleh,et al.  Enhanced solar still performance using water film cooling of the glass cover , 1996 .

[9]  Arvind Tiwari,et al.  Solar Distillation Practice For Water Desalination Systems , 2008 .

[10]  A. S. Nafey,et al.  Parameters affecting solar still productivity , 2000 .

[11]  M. T. Chaibi,et al.  Analysis by simulation of a solar still integrated in a greenhouse roof , 2000 .

[12]  Irene De Paul.  New Model of a Basin-Type Solar Still , 2002 .

[13]  Badawi W. Tleimat,et al.  Nocturnal production of solar distillers , 1966 .

[14]  Teruyuki Fukuhara,et al.  Tubular solar desalination and improvement of soil moisture retention by date palm , 2006 .

[15]  G. N. Tiwari,et al.  Nocturnal water production by tubular solar stills using waste heat to preheat brine , 1988 .

[16]  Design philosophy and operating experience for Australian solar stills , 1974 .

[17]  Ashok Kumar,et al.  Modelling and performance of a tubular multiwick solar still , 1992 .

[18]  G. N. Tiwari,et al.  Optimization of collector and basin areas for a higher yield for active solar stills , 1998 .

[19]  Mousa K. Abu-Arabi,et al.  Modeling and performance analysis of a solar desalination unit with double-glass cover cooling , 2001 .

[20]  Hassan E.S. Fath,et al.  Solar distillation: a promising alternative for water provision with free energy, simple technology and a clean environment , 1998 .

[21]  Shigeki Toyama,et al.  Experimental and numerical analysis of a tube-type networked solar still for desert technology , 2006 .