Experimental configuration for isentropic compression of solids using pulsed magnetic loading

A capability to produce quasi-isentropic compression of solids using pulsed magnetic loading on the Z accelerator has recently been developed and demonstrated [C. A. Hall, Phys. Plasmas 7, 2069 (2000)]. This technique allows planar, continuous compression of materials to stresses approaching 1.5 Mbar. In initial stages of development, the experimental configuration used a magnetically loaded material cup or disk as the sample of interest pressed into a conductor. This installation caused distortions that limited the ability to attach interferometer windows or other materials to the rear of the sample. In addition, magnetic pressure was not completely uniform over sample dimensions of interest. A new modular configuration is described that improves the uniformity of loading over the sample surface, allows materials to be easily attached to the magnetically loaded sample, and improves the quality of data obtained. Electromagnetic simulations of the magnetic field uniformity for this new configuration will also be presented. Comparisons between data on copper to ∼300 kbar using the old and new experimental configurations will also be made. Results indicate that to within experimental error, the configurations produce similar results in the pressure-volume plane.