论文信息 - The study of EDM hole-drilling method for measuring residual stress in SKD11 tool steel

The study of EDM hole-drilling method for measuring residual stress in SKD11 tool steel

Abstract This study develops the EDM drilling process to measure the residual stress in high-performance materials, whose stress state is difficult to obtain by a widely used technology called high-speed (HS) hole-drilling method (ASTM Standard E837). SKD11 (JIS) tool steels were prepared in different pre-stressed levels in order to simulate any possible residual stress existing in the workpieces. The experimental results reveal that the stress measurement curves of both EDM conditions, which have the same EDM energy, are parallel with the ideal curve. Therefore the results of EDM hole-drilling method can be positively calibrated by a constant, and it depicts the feasibility of residual stress measurement on materials with high hardness and wear resistance.

[1] Gary S. Schajer,et al. Measurement of Non-Uniform Residual Stresses Using the Hole-Drilling Method. Part I—Stress Calculation Procedures , 1988 .

[2] J. Lebrun,et al. Influence of EDM pulse energy on the surface integrity of martensitic steels , 1998 .

[3] M. Merdan,et al. The Surface Integrity of a Die Steel after Electrodischarge Machining: 2 Residual Stress Distribution , 1991 .

[4] M. T. Flaman,et al. Brief investigation of induced drilling stresses in the center-hole method of residual-stress measurement , 1982 .

[5] Woei-Shyan Lee,et al. Plastic deformation and fracture response of 304 stainless steel subjected to dynamic shear loading , 2003 .

[6] Hwa-Teng Lee,et al. Study of surface integrity using the small area EDM process with a copper–tungsten electrode , 2004 .

[7] Gary S. Schajer,et al. Application of Finite Element Calculations to Residual Stress Measurements , 1981 .

[8] Hwa-Teng Lee,et al. Relationship between EDM parameters and surface crack formation , 2003 .

[9] M. T. Flaman,et al. Comparison of Four Hole-Producing Techniques for the Center-Hole Residual-Stress Measurement Method , 2008 .

[10] Jiahn-Piring Yur,et al. Characteristic Analysis of EDMed Surfaces Using the Taguchi Approach , 2000 .

[11] A. Mamalis,et al. Residual Stress Distribution and Structural Phenomena of High-Strength Steel Surfaces Due to EDM and Ball-Drop Forming , 1988 .