Assembly Process

Revolute joints are frequently used in articulated structures. Traditionally, such a joint is formed by assembling two components. As an alternative, revolute joints can be created inside the mold using an in-mold assembly process. This process eliminates the need for post-molding assembly, thus significantly reducing the cycle time and part count. The functional performance of a revolute joint depends on the clearance in the joint. The clearance in turn depends on the part shrinkage and the mold deformation during the molding process. The presence of a polymer part during the second molding stage makes an inmold assembly process significantly different from the traditional molding process due to the difference in heat transfer and deformation characteristics. This paper presents experimental data and a preliminary model to explain the differences in clearance produced by an Aluminum mold and an Aluminum mold with an Acrylonitrile butadiene styrene (ABS) insert. Our data indicates that there is a significant difference between the clearances observed from these two different types of molds. We believe that clearances produced depend strongly on the thermal history of the parts.

[1]  Diane K. Michelson,et al.  Applied Statistics for Engineers and Scientists , 2001, Technometrics.

[2]  C. J. Donahue,et al.  Thermal Analysis of Plastics. , 2008 .

[3]  Florian Krebs,et al.  Manufacturing multi-material articulated plastic products using in-mold assembly , 2007 .

[4]  K. Jansen,et al.  Effect of processing conditions on shrinkage in injection molding , 1998 .

[5]  Avraam Isayev,et al.  Toward a viscoelastic modeling of anisotropic shrinkage in injection molding of amorphous polymers , 2005 .

[6]  D. Birchall,et al.  Computational Fluid Dynamics , 2020, Radial Flow Turbocompressors.

[7]  Avraam Isayev,et al.  Injection and Compression Molding Fundamentals , 1987 .

[8]  Gilles Régnier,et al.  Nature of contact between polymer and mold in injection molding. Part II: Influence of mold deflection on pressure history and shrinkage , 2000 .

[9]  Giuseppe Titomanlio,et al.  Effect of pressure history on shrinkage and residual stresses—injection molding with constrained shrinkage , 1996 .

[10]  Satyandra K. Gupta,et al.  Incorporating manufacturability considerations during design of injection molded multi-material objects , 2007 .

[11]  B. Sędłak,et al.  Parametric Study of Heat Transfer in Injection Molding—Effect of Thermal Contact Resistance , 2000 .

[12]  Giuseppe Titomanlio,et al.  In‐mold shrinkage and stress prediction in injection molding , 1996 .

[13]  A. Isayev,et al.  Volumetric effects in the injection molding of polymers , 1985 .

[14]  Vijay K. Stokes,et al.  Solidification of thermoviscoelastic melts. Part 4: Effects of boundary conditions on shrinkage and residual stresses , 1995 .