CMOS-compatible traction stress sensor for use in high-resolution tactile imaging

Abstract A microstructure capable of resolving the three independent components of a point traction stress has been developed. The sensor exhibits an independent, linear response to each of the three components of an applied traction stress with measurement sensitivities of 51 mV kPa −1 in the normal stress mode and 12 mV kPa −1 in the two shear stress modes. The sensor is realized using a fabrication process that is fully CMOS compatible to allow for the future integration of local processing and control circuitry. High spatial resolution robotic tactile sensing should be possible with the sensor structure, since each element is less than 300 μm × 300 μm in size. A description of the sensor structure, the required signal processing and mechanical characterization data is presented.

[1]  R. Johansson,et al.  Tactile sensory coding in the glabrous skin of the human hand , 1983, Trends in Neurosciences.

[2]  R. S. Fearing,et al.  Tactile Sensing Mechanisms , 1990, Int. J. Robotics Res..

[3]  Ronald S. Fearing,et al.  Using a cylindrical tactile sensor for determining curvature , 1988, IEEE Trans. Robotics Autom..

[4]  D. De Rossi,et al.  A stress-component-selective tactile sensor array , 1992 .

[5]  Mark R. Cutkosky,et al.  Sensing skin acceleration for slip and texture perception , 1989, Proceedings, 1989 International Conference on Robotics and Automation.

[6]  Robert D. Howe.  A tactile stress rate sensor for perception of fine surface features , 1991, TRANSDUCERS '91: 1991 International Conference on Solid-State Sensors and Actuators. Digest of Technical Papers.

[7]  Dominiek Reynaerts,et al.  Tactile sensing data interpretation for object manipulation , 1992 .

[8]  U. Schnakenberg,et al.  TMAHW etchants for silicon micromachining , 1991, TRANSDUCERS '91: 1991 International Conference on Solid-State Sensors and Actuators. Digest of Technical Papers.