The potential of catalysed exhaust gas recirculation to improve high-load operation in spark ignition engines

Within the literature, there are a number of studies investigating the benefits of exhaust gas recirculation, and as a result it has become established as a promising technology for combustion control to allow engine downsizing technology to be advanced. Aside from the dilution effect of exhaust gas recirculation, some of the components, such as NO, CO, and hydrocarbons, can have significant chemical effects. The literature shows that the component within exhaust gas recirculation which has the largest chemical effect on combustion is NO, which can promote or inhibit the onset of autoignition causing reactions within the end gas at high load. The reduction in NOx gases in catalysed exhaust gas recirculation can increase the knock limit at high load, with some authors reporting up to a 5∘ crank angle improvement in combustion phasing. There is conflicting evidence on whether this translates to an improvement in fuel consumption, with one study finding a decrease of up to 2% comparing to another finding an increase of 1.5%-3.5%. Crude calculations on the emissions of a 2.0-L direct injection spark ignition engine operating at high load show that in an extreme case the reduction in the calorific value of the inlet charge due to catalysis of the recirculated gases can be up to 4.5%. Despite the potential benefits, the literature on catalysed exhaust gas recirculation is fairly limited and the evidence seems so far inconclusive as to whether this technology may have the potential to further enhance the benefits of exhaust gas recirculation. This article uses current literature to ascertain the potential benefits of catalysed exhaust gas recirculation, compare to pre-catalyst exhaust gas recirculation, and investigates its individual components in more detail to explain how chemical interactions can either promote or inhibit ignition depending on their concentration and temperature.

[1]  Michele Kaiser,et al.  EBDI® - Application of a Fully Flexible High BMEP Downsized Spark Ignited Engine , 2010 .

[2]  Richard Pearson,et al.  The Turboexpansion Concept - Initial Dynamometer Results , 2005 .

[3]  T. Amano,et al.  The Effect of NOx on Knock in Spark-ignition Engines , 1999 .

[4]  Michele Kaiser,et al.  “Doing More with Less” - The Fuel Economy Benefits of Cooled EGR on a Direct Injected Spark Ignited Boosted Engine , 2010 .

[5]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[6]  Alberto A. Boretti,et al.  Water injection in directly injected turbocharged spark ignition engines , 2013 .

[7]  John Malcolm,et al.  Combining Unthrottled Operation with Internal EGR under Port and Central Direct Fuel Injection Conditions in a Single Cylinder SI Engine , 2009 .

[8]  Fabian Mauss,et al.  Heat release in the end-gas prior to knock in lean, rich and stochiometric mixtures with and without EGR , 2002 .

[9]  Fabian Mauss,et al.  The Influence of Nitric Oxide on the Occurrence of Autoignition in the End Gas of Spark Ignition Engines , 2002 .

[10]  John E. Dec,et al.  Thermodynamic and Chemical Effects of EGR and Its Constituents on HCCI Autoignition. , 2007 .

[11]  Andrew Smallbone,et al.  The Influence of Simulated Residual and NO Concentrations on Knock Onset for PRFs and Gasolines , 2004 .

[12]  Emmanuel P Kasseris,et al.  EGR Effects on Boosted SI Engine Operation and Knock Integral Correlation , 2012 .

[13]  John B. Heywood,et al.  Knock Behavior of a Lean-Burn, H2 and CO Enhanced, SI Gasoline Engine Concept , 2004 .

[14]  Richard Pearson,et al.  Effects of Cooled EGR Routing on a Second-Generation DISI Turbocharged Engine Employing an Integrated Exhaust Manifold , 2009 .

[15]  Robert Hoekstra,et al.  Engine Knock, A Renewed Concern In Motorsports - A Literature Review , 1998 .

[16]  Xiaoguo Tang,et al.  Ford P2000 Hydrogen Engine Dynamometer Development , 2002 .

[17]  J. Macek,et al.  Comparison of Different EGR Solutions , 2008 .

[18]  P. Glaude,et al.  Temperature dependence of NO to NO2 conversion by n-butane and n-pentane oxidation , 2002 .

[19]  Tiziano Faravelli,et al.  Kinetic modeling of the interactions between NO and hydrocarbons in the oxidation of hydrocarbons at low temperatures , 2003 .

[20]  Alasdair Cairns,et al.  Burn Rate Implications of Alternative Knock Reduction Strategies for Turbocharged SI Engines , 2006 .

[21]  Bengt Johansson,et al.  Measurement of Knock and Ion Current in a Spark Ignition Engine with and without NO Addition to the Intake Air , 2003 .

[22]  F. Dryer,et al.  The Interaction Between Nitric Oxide and Hydrocarbon Oxidation Chemistry in a Spark Ignition Engine , 1997 .

[23]  C. Sheppard,et al.  The Influence of Residual Gas NO Content on Knock Onset of Iso-Octane, PRF, TRF and ULG Mixtures in SI Engines , 2013 .

[24]  E. Galloni,et al.  Numerical analyses of EGR techniques in a turbocharged spark-ignition engine , 2012 .

[25]  Alasdair Cairns,et al.  Pre Versus Post Compressor Supply of Cooled EGR for Full Load Fuel Economy in Turbocharged Gasoline Engines , 2008 .

[26]  G. Fontana,et al.  Experimental analysis of a spark-ignition engine using exhaust gas recycle at WOT operation , 2010 .

[27]  Hans-Erik Ångström,et al.  Replacing Fuel Enrichment in a Turbo Charged SI Engine: Lean Burn or Cooled EGR , 1999 .

[28]  Hongming Xu,et al.  GDI Engine Performance and Emissions with Reformed Exhaust Gas Recirculation (REGR) , 2013 .

[29]  P. Lutz,et al.  Cooled EGR for a Turbo SI Engine to Reduce Knocking and Fuel Consumption , 2007 .

[30]  Jonathan Chauvin,et al.  LP EGR and IGR Compromise on a GDI Engine at Middle Load , 2013 .

[31]  Per Stalhammar,et al.  Knock Suppression in a Turbocharged SI Engine by Using Cooled EGR , 1998 .

[32]  John Stokes,et al.  A Gasoline Engine Concept for Improved Fuel Economy -The Lean Boost System , 2000 .

[33]  E. Meeks,et al.  Modeling the Detailed Chemical Kinetics of NOx Sensitization for the Oxidation of a Model fuel for Gasoline , 2010 .

[34]  Robert W. Dibble,et al.  Combustion: Physical and Chemical Fundamentals, Modelling and Simulation, Experiments, Pollutant Formation , 1996 .

[35]  D. L. Miller,et al.  The Effect of Nitric Oxide on Autoignition of a Primary Reference Fuel Blend in a Motored Engine , 1993 .

[36]  V. Giglio,et al.  Evaluation of the Effect of EGR on Engine Knock , 1998 .

[37]  Hugh Blaxill,et al.  A New 3 Cylinder 1.2l Advanced Downsizing Technology Demonstrator Engine , 2008 .

[38]  Michael Becker,et al.  Requirements of External EGR Systems for Dual Cam Phaser Turbo GDI Engines , 2010 .

[39]  G. Adomeit,et al.  Self-ignition of S.I. engine model fuels: A shock tube investigation at high pressure ☆ , 1997 .

[40]  Hans-Erik Ångström,et al.  The Influence of NO on the Combustion Phasing in an HCCI Engine , 2006 .

[41]  Alasdair Cairns,et al.  Exhaust Gas Recirculation for Improved Part and Full Load Fuel Economy in a Turbocharged Gasoline Engine , 2006 .

[42]  Fabian Mauss,et al.  CARE – CAtalytic Reformated Exhaust Gases in Turbocharged DISI-Engines , 2009 .

[43]  Alasdair Cairns,et al.  Lean Boost and External Exhaust Gas Recirculation for High Load Controlled Auto-Ignition , 2005 .

[44]  Andrew Lewis,et al.  Observations on the Measurement and Performance Impact of Catalyzed vs. Non Catalyzed EGR on a Heavily Downsized DISI Engine , 2014 .

[45]  John B. Heywood,et al.  Phenomena that Determine Knock Onset in Spark-Ignition Engines , 2007 .

[46]  Kyoungdoug Min,et al.  Laminar Flame Speed Characteristics and Combustion Simulation of Synthetic Gas Fueled SI Engine , 2008 .

[47]  Imad A. Khalek,et al.  Effect of EGR on Particle Emissions from a GDI Engine , 2011 .

[48]  Fabrice Foucher,et al.  Effect of EGR Chemical Components and Intake Temperature on HCCI Combustion Development , 2006 .

[49]  Charles K. Westbrook,et al.  Chemical kinetics of hydrocarbon ignition in practical combustion systems , 2000 .

[50]  Zlatina Dimitrova,et al.  Synergies between High EGR Operation and GDI Systems , 2008 .