Improving the performance of solar still by using PCM as a thermal storage medium under Egyptian conditions

Abstract The objective of the present work is to improve the performance of a solar still through increasing the productivity of freshwater. In order to improve the performance of a solar still, a phase change material (PCM) was added as a heat storage medium. Two solar stills were designed, constructed and tested in the present experimental study to compare the productivity of the solar desalination system. One of them is a solar still with PCM and the other is the conventional solar still. The experimental results show that, the daily freshwater productivity for solar still with PCM is higher than that of conventional solar still. The daily freshwater productivity approximately reached 7.54 L/m2 day for solar still with PCM, while its value is recorded 4.51 L/m2 day for the conventional solar still. The results show that the daily freshwater productivity for solar still with PCM is 67.18% higher than that of the conventional solar still. Also, the solar still with PCM is superior in daily freshwater productivity (67%–68.8% improvement) compared to a conventional solar still in the period from June to July 2015 under the ambient conditions of Tanta city (Egypt). In this case study the estimated cost of 1 L of distillate water reached approximately 0.24 LE (0.03 $) and 0.252 LE (0.032 $) for solar still with PCM and conventional solar still, respectively.

[1]  A. Haji-Sheikh,et al.  Some Thermophysical Properties of Paraffin Wax as a Thermal Storage Medium , 1982 .

[2]  Farshad Farshchi Tabrizi,et al.  Thermal analysis of a weir-type cascade solar still integrated with PCM storage , 2011 .

[3]  A. Abhat.  Low temperature latent heat thermal energy storage: Heat storage materials , 1983 .

[4]  Amar M. Khudhair,et al.  A review on phase change energy storage: materials and applications , 2004 .

[5]  Vassilis Belessiotis,et al.  Solar stills coupled with solar collectors and storage tank––analytical simulation and experimental validation of energy behavior , 2003 .

[6]  Ahmed A. Al-Ghamdi,et al.  Thermal performance of a single basin solar still with PCM as a storage medium , 2009 .

[7]  K. Sampathkumar,et al.  Utilization of solar water heater in a single basin solar still—An experimental study , 2012 .

[8]  Yasuhito Nakatake,et al.  Parametric study on a vertical multiple-effect diffusion-typesolar still coupled with a heat-pipe solar collector , 2005 .

[9]  K. Srithar,et al.  Desalination of effluent using fin type solar still , 2008 .

[10]  Thirugnanasambantham Arunkumar,et al.  The augmentation of distillate yield by using concentrator coupled solar still with phase change material , 2013 .

[11]  Hiroshi Tanaka,et al.  Factors influencing the productivity of a multiple-effect diffusion-type solar still coupled with a flat plate reflector , 2005 .

[12]  H. Ben Bacha,et al.  Desalination unit coupled with solar collectors and a storage tank : modelling and simulation , 2007 .

[13]  Gang Xiao,et al.  A review on solar stills for brine desalination , 2013 .

[14]  A. E. Kabeel,et al.  Performance of solar still with a concave wick evaporation surface , 2009 .

[15]  N. C. Barford.  Experimental Measurements: Precision, Error and Truth , 1967 .

[16]  A. E. Kabeel,et al.  Performance evaluation of a continuous flow inclined solar still desalination system , 2015 .

[17]  Hiroshi Tanaka,et al.  A vertical multiple-effect diffusion-type solar still coupled with a heat-pipe solar collector , 2004 .

[18]  A.M.I. Mohamed,et al.  Theoretical investigation of solar humidification-dehumidification desalination system using parabolic trough concentrators , 2011 .

[19]  Hassan E.S. Fath,et al.  Technical assessment of solar thermal energy storage technologies , 1998 .

[20]  Abdulhaiy M. Radhwan,et al.  Transient performance of a stepped solar still withbuilt-in latent heat thermal energy storage , 2005 .

[21]  A. E. Kabeel,et al.  Theoretical and experimental parametric study of modified stepped solar still , 2012 .

[22]  K. Srithar,et al.  SINGLE BASIN SOLAR STILL WITH FIN FOR ENHANCING PRODUCTIVITY , 2008 .

[23]  Farshad Farshchi Tabrizi,et al.  Experimental study of an integrated basin solar still with a sandy heat reservoir , 2010 .

[24]  K Abu-Hijleh,et al.  Experimental study of a solar still with sponge cubes in basin , 2003 .

[25]  K. Srithar,et al.  Performance analysis in stepped solar still for effluent desalination , 2009 .

[26]  A. S. Nafey,et al.  Parameters affecting solar still productivity , 2000 .

[27]  Hiroshi Tanaka,et al.  Indoor experiments of the vertical multiple-effect diffusion-type solar still coupled with a heat-pipe solar collector , 2005 .