Numerical and experimental investigation on the influence of inlet contraction ratio for a rocket-based combined cycle engine

Abstract The influences of inlet contraction ratio on both the inlet and combustor of the rocket-based combined cycle engine are investigated in this paper by experimental and numerical approaches. A translating spike was employed to simulate the inlet counter pressure in the wind tunnel experiment. Steady-state pressure distributions were recorded and schlieren photos were obtained simultaneously. The combined numerical-experimental results show that the increased inlet contraction ratio always results in the increasing of the compression ratio and capability of anti-counter pressure, while its impact on the mass flow coefficient is negligible. Besides, the reactive numerical results show that the coefficients of inlet drag and combustor thrust increase with the increasing of the inlet contraction ratio, while the nozzle thrust coefficient demonstrates an opposite trend. These suggest that the selection of an appropriate inlet contraction ratio can effectively improve the total thrust coefficient of the engine, while the appropriate inlet contraction ratio is to be set to the minimum that satisfies the robust combustion requirement.

[1]  J. Anderson,et al.  Hypersonic and High-Temperature Gas Dynamics , 2019 .

[2]  Rui Xue,et al.  Research on shock wave characteristics in the isolator of central strut rocket-based combined cycle engine under Ma5.5 , 2017 .

[3]  Timothy H. Cox,et al.  Flight Testing the Linear Aerospike SR-71 Experiment (LASRE) , 1998 .

[4]  Birgit Reinartz,et al.  Aerodynamic Performance Analysis of a Hypersonic Inlet Isolator Using Computation and Experiment , 2003 .

[5]  O. Dessornes,et al.  Tests of the JAPHAR dual mode ramjet engine , 2005 .

[6]  Liu Xiao-wei,et al.  Design and numerical investigation of RBCC prototype inlet , 2011 .

[7]  Michael K. Smart,et al.  How much compression should a scramjet inlet Do , 2012 .

[8]  Nickolay Smirnov,et al.  Numerical investigations of hybrid rocket engines , 2018 .

[9]  Piao-Ping Tang,et al.  Control of pseudo-shock oscillation in scramjet inlet-isolator using periodical excitation , 2018 .

[10]  M. Farahani,et al.  Effects of Bleed Position on the Stability of a Supersonic Inlet , 2016 .

[11]  G. Chorkawy,et al.  Exchange inlet optimization by genetic algorithm for improved RBCC performance , 2017 .

[12]  J. Etele,et al.  Equivalence ratio and constriction effects on RBCC thrust augmentation , 2011 .

[13]  Corin Segal,et al.  Combined Rocket and Airbreathing Propulsion Systems for Space-Launch Applications , 1998 .

[14]  Xianggeng Wei,et al.  Large eddy simulation of combustion characteristics in a kerosene fueled rocket-based combined-cycle engine combustor , 2016 .

[15]  Sean M. Torrez,et al.  Performance Analysis of Variable-Geometry Scramjet Inlets Using a Low-Order Model , 2011 .

[16]  Nickolay Smirnov,et al.  Evaporation and ignition of droplets in combustion chambers modeling and simulation , 2012 .

[17]  Chi-bing Shen,et al.  Computational investigation on combustion instabilities in a rocket combustor , 2016 .

[18]  Chengpeng Wang,et al.  Experimental characteristics of oblique shock train upstream propagation , 2017 .

[19]  Richard W. Foster.  A review of findings of a study of rocket based combined cycle engines applied to extensively axisymmetric single stage to orbit vehicles , 1992 .

[20]  Hiroaki Kobayashi,et al.  DEVELOPMENT STUDY OF THE ATREX ENGINE FOR TSTO SPACEPLANE , 2001 .

[21]  Mel Bulman,et al.  The strutjet engine - Exploding the myths surrounding high speed airbreathing propulsion , 1995 .

[22]  Daren Yu,et al.  Unstart margin control of hypersonic inlets , 2010 .

[23]  Laurent Serre,et al.  Promethee - The French Military Hypersonic Propulsion Program , 2003 .

[24]  William H. Heiser,et al.  Hypersonic Airbreathing Propulsion , 1994 .

[25]  Uwe Hueter,et al.  NASA's Integrated Space Transportation Plan — 3rd generation reusable launch vehicle technology update , 2003 .

[26]  Daren Yu,et al.  Numerical study on dynamic characteristics for sharp opening procedure of boundary-layer suction slot , 2017 .

[27]  Daren Yu,et al.  Hysteresis phenomenon of hypersonic inlet at high Mach number , 2016 .

[28]  Jie Liu,et al.  A rocket-based combined-cycle engine prototype demonstrating comprehensive component compatibility and effective mode transition , 2016 .

[29]  Garry Lyles,et al.  Integrated System Test of an Airbreathing Rocket (ISTAR) , 2001 .

[30]  Wang Yajun,et al.  Study of thermal throat of RBCC combustor based on one-dimensional analysis , 2015 .

[31]  Qinghua Hu,et al.  Classifier utility modeling and analysis of hypersonic inlet start/unstart considering training data costs , 2011 .

[32]  Laurent Serre,et al.  French Flight Testing Program LEA Status in 2009 , 2009 .

[33]  Nickolay Smirnov,et al.  Analytical solution for a single droplet diffusion combustion problem accounting for several chain reaction stages , 2013 .

[34]  J. R. DeBonis,et al.  Supersonic Wind Tunnel Tests of a Half-axisymmetric 12 Deg-spike Inlet to a Rocket-based Combined-cycle Propulsion System , 2001 .

[35]  Nickolay Smirnov,et al.  Ignition of fuel sprays by shock wave mathematical modeling and numerical simulation , 2013 .

[36]  Zhenguo Wang,et al.  Effects of fuel cracking on combustion characteristics of a supersonic model combustor , 2015 .

[37]  G. Masuya,et al.  A study of air breathing rockets—Subsonic mode combustion , 1981 .

[38]  Jie Liu,et al.  Numerical analysis of flow features and operation characteristics of a rocket-based combined-cycle inlet in ejector mode , 2016 .

[39]  Jeong-Yeol Choi,et al.  A Quasi Global Mechanism of Kerosene Combustion for Propulsion Applications , 2011 .