Accurate Strain Gauge Limits Through Geometry Mistuning Modeling

Safe engine operation is ensured by setting safety limits on rotor airfoil-mounted strain gauges that monitor the dynamic response of the component. Traditionally, strain gauge limits are generated...

[1]  B. A. Cowles,et al.  High cycle fatigue in aircraft gas turbines—an industry perspective , 1996 .

[2]  Bogdan I. Epureanu,et al.  Reduced-order modeling approach for blisks with large mass, stiffness, and geometric mistuning , 2012 .

[3]  M. D. Sensmeier,et al.  OPTIMUM PLACEMENT OF SENSORS FOR VIBRATION MEASUREMENTS ON TURBINE ENGINE BLADES , 1998 .

[4]  S. Aksoy,et al.  Structural Evaluation and Testing of Swept Compressor Rotor , 1994 .

[5]  Luca di Mare,et al.  Forced Response of Mistuned Bladed Discs in Gas Flow: A Comparative Study of Predictions and Full-Scale Experimental Results , 2009 .

[6]  Joseph A. Beck,et al.  Uncertainties of an Automated Optical 3D Geometry Measurement, Modeling, and Analysis Process for Mistuned Integrally Bladed Rotor Reverse Engineering , 2013 .

[7]  J. H. Griffin,et al.  A Fundamental Model of Mistuning for a Single Family of Modes , 2002 .

[8]  Matthew P. Castanier,et al.  Testing and Calibration Procedures for Mistuning Identification and Traveling Wave Excitation of Blisks , 2009 .

[9]  J. H. Griffin,et al.  Mistuning Identification of Bladed Disks Using a Fundamental Mistuning Model-Part II: Application (2003-GT-38953) , 2004 .

[10]  Ramana V. Grandhi,et al.  Reduced-Order Model Development for Airfoil Forced Response , 2008 .

[11]  T. Nicholas,et al.  On the use of the Goodman diagram for high cycle fatigue design , 1996 .

[12]  Chao Liu,et al.  Improved Blade Tip Timing in Blade Vibration Monitoring with Torsional Vibration of the Rotor , 2012 .

[13]  Nicole L. Key,et al.  Mistuned Forced Response Predictions of an Embedded Rotor in a Multistage Compressor , 2016 .

[14]  Steven L. Puterbaugh,et al.  Unsteady Aerodynamic Flow Phenomena in a Transonic Compressor Stage , 1997 .

[15]  Kurt L. Nichol.  Reasons for Missing HCF Problems During Test , 2002 .

[16]  Kurt Nichol,et al.  Numerical strain gage representation , 1998 .

[17]  Rainer Schnell,et al.  On the Impact of Geometric Variability on Fan Aerodynamic Performance, Unsteady Blade Row Interaction, and Its Mechanical Characteristics , 2014 .

[18]  Christophe Pierre,et al.  Compact, Generalized Component Mode Mistuning Representation for Modeling Bladed Disk Vibration , 2003 .

[19]  J. H. Griffin,et al.  Mistuning Identification of Bladed Disks Using a Fundamental Mistuning Model-Part I: Theory (2003-GT-38952) , 2004 .

[20]  Matthew P. Castanier,et al.  Modeling and Analysis of Mistuned Bladed Disk Vibration: Status and Emerging Directions , 2006 .

[21]  The effect of work-hardening on plane strain crack growth under small scale yielding conditions , 1983 .