Modified equilibrium modelling of coal gasification with in situ CO2 capture using sorbent CaO: Assessment of approach temperature

Abstract Gasification process has become more attractive around the globe due to the energy crisis and environmental issues. An equilibrium model based on minimization of Gibbs energy is developed to predict the product gas composition of an air-blown coal gasifier. This paper further proposes a method for modifying the thermodynamic equilibrium model. The presented method includes the introduction of an approach temperature which corresponds to the deviation from equilibrium condition. The major components in produced gas, H2, H2O, CH4, CO, CO2, and N2 have been determined and compared with the pure equilibrium modelling as well as the experimental data. Comparison with experimental measurements revealed that the modification of the equilibrium model has significantly reduced the error in predicting the product gas composition. In situ CO2 capture using sorbent (CaO) is also investigated in order to enhance the hydrogen production and also to address the environmental regulations on Green House Gas (GHG) emissions. The effect of important process parameters on the product gas composition is studied and the temperature of 1200 K, pressure of 1 bar, air ratio of 0.4, and sorbent to feed ratio of 2.2 have been predicted as the optimum operating conditions for the purpose of maximum hydrogen production.

[1]  J. R. Kim,et al.  Biomass gasification in a circulating fluidized bed , 2004 .

[2]  N. Mahinpey,et al.  Simulation of biomass gasification in fluidized bed reactor using ASPEN PLUS. , 2008 .

[3]  Andrew T. Harris,et al.  Hydrogen production from biomass coupled with carbon dioxide capture: The implications of thermodynamic equilibrium , 2007 .

[4]  N. Ellis,et al.  Mapping of the Operating Conditions for an Interconnected Fluidized Bed Reactor for CO2 Separation by Chemical Looping Combustion , 2009 .

[5]  M. Vaezi,et al.  Gasification of heavy fuel oils: A thermochemical equilibrium approach , 2009 .

[6]  W. Prins,et al.  Combustion Kinetics of Char Obtained by Flash Pyrolysis of Pine Wood , 1998 .

[7]  Herbert Baumann,et al.  Formation and reduction of NO x in pressurized fluidized bed combustion of coal , 1995 .

[8]  Paul S. Fennell,et al.  The calcium looping cycle for large-scale CO2 capture , 2010 .

[9]  Ehsan Esmaili,et al.  Adjustment of drag coefficient correlations in three dimensional CFD simulation of gas-solid bubbling fluidized bed , 2011, Adv. Eng. Softw..

[10]  W.P.M. van Swaaij,et al.  Wood Pyrolysis and Carbon Dioxide Char Gasification Kinetics in a Fluidized Bed , 1985 .

[11]  J. Corella,et al.  Steam Gasification of Coal at Low−Medium (600−800 °C) Temperature with Simultaneous CO2 Capture in a Bubbling Fluidized Bed at Atmospheric Pressure. 2. Results and Recommendations for Scaling Up , 2008 .

[12]  William R. Smith,et al.  Chemical Reaction Equilibrium Analysis: Theory and Algorithms , 1982 .

[13]  C. Chen,et al.  Coal gasification in a low pressure, low residence time, entrained flow reactor , 1976 .

[14]  Robin W. Hughes,et al.  Ca-based sorbent looping combustion for CO2 capture in pilot-scale dual fluidized beds , 2008 .

[15]  R. P. Gaikwad,et al.  Steam gasification in a pressurized spouted bed reactor , 1991 .

[16]  Marcio L. de Souza-Santos,et al.  Solid Fuels Combustion and Gasification: Modeling, Simulation, and Equipment Operations , 2004 .