Analysis of the Method for Determining Changes in the Airways from the Spirometric Curve Evolution

The severity of chronic respiratory diseases is evaluated performing spirometry, and particularly the forced expiration maneuvers before and after bronchodilation or challenge tests. However, no method has yet been proposed for the quantitative assessment of changes in airway mechanics following such tests. Just recently, a reduced model for forced expiration with 6 free parameters was derived and used to estimate the parameters by fitting it to a spirometric curve. The aim of this work was to perform comprehensive research on the method for quantifying the changes in airway mechanics by fitting the above model to two spirometric curves, representing the states of the respiratory system before and after bronchodilation or bronchoconstriction. To this end, a set of pairs of spirometric curves were generated from randomly drawn parameters, and 2,400 of them were used for testing purposes. The proposed method for spirometric data analysis consisted of two stages: the estimation of 6 parameters from the pre-test data using the inverse neural network and the Levenberg-Marquardt (LM) algorithm, and then the estimation of 2 parameters describing airway properties from the post-test curve with the LM procedure. The results show that this approach allows the quantification of changes in the airway mechanics with the accuracy of about 6-7 % of the parameter ranges. These outcomes encourage further analysis of the method using more reliable spirometric data.

[2]  D L Vawter.  Stress-free equilibrium volume of the lung. , 1977, Journal of applied physiology: respiratory, environmental and exercise physiology.

[3]  R W Mann,et al.  An electrohydraulic knee-torque controller for a prosthesis simulator. , 1977, Journal of biomechanical engineering.

[4]  T. Evans,et al.  Progress in ARDS research: a protection racket? , 2001, Thorax.

[5]  R. Lambert.  Sensitivity and specificity of the computational model for maximal expiratory flow. , 1984, Journal of applied physiology: respiratory, environmental and exercise physiology.

[6]  Alys R. Clark,et al.  Comparison of generic and subject-specific models for simulation of pulmonary perfusion and forced expiration , 2015, Interface Focus.

[7]  P. Sterk,et al.  Pressure-volume analysis of the lung with an exponential and linear-exponential model in asthma and COPD. Dutch CNSLD Study Group. , 1995, The European respiratory journal.

[8]  A. Shapiro.  Steady Flow in Collapsible Tubes , 1977 .

[9]  Adam G. Polak,et al.  An Error-Minimizing Approach to Regularization in Indirect Measurements , 2010, IEEE Transactions on Instrumentation and Measurement.

[10]  S V Dawson,et al.  Wave-speed limitation on expiratory flow-a unifying concept. , 1977, Journal of applied physiology: respiratory, environmental and exercise physiology.

[11]  C. Carrington,et al.  Morphometry of the Human Lung , 1965, The Yale Journal of Biology and Medicine.

[12]  Janusz Mroczka,et al.  Solving the Inverse Problem in Spirometry with the Methods of Global and Local Estimation , 2019, 2019 IEEE International Symposium on Medical Measurements and Applications (MeMeA).

[13]  A. G. Polak,et al.  A forward model for maximum expiration , 1998, Comput. Biol. Medicine.

[14]  H. H. Mitchell,et al.  Shivering and heat production in men exposed to intense cold. , 1967, Journal of applied physiology.

[15]  T A Wilson,et al.  A computational model for expiratory flow. , 1982, Journal of applied physiology: respiratory, environmental and exercise physiology.

[16]  R. Castile,et al.  Model of forced expiratory flows and airway geometry in infants. , 2004, Journal of applied physiology.

[17]  J. Vestbo,et al.  Airway hyperresponsiveness and COPD mortality. , 2001, Thorax.

[18]  Janusz Mroczka,et al.  Effects of homogeneous and heterogeneous changes in the lung periphery on spirometry results , 2019, Comput. Methods Programs Biomed..

[19]  K. Beck,et al.  Airway area distribution from the forced expiration maneuver. , 2004, Journal of applied physiology.

[20]  A. G. Polak,et al.  Computational Model for Forced Expiration from Asymmetric Normal Lungs , 2003, Annals of Biomedical Engineering.

[21]  J. Hankinson,et al.  Interpretative strategies for lung function tests , 2005, European Respiratory Journal.

[22]  N. Pride,et al.  Determinants of maximal expiratory flow from the lungs. , 1967, Journal of applied physiology.

[24]  P. Macklem,et al.  Significance of the relationship between lung recoil and maximum expiratory flow. , 1967, Journal of applied physiology.

[25]  Janusz Mroczka,et al.  Estimation of Lung Properties Using ANN-Based Inverse Modeling of Spirometric Data , 2019, IWBBIO.

[26]  D. Cockcroft.  Direct challenge tests: Airway hyperresponsiveness in asthma: its measurement and clinical significance. , 2010, Chest.

[27]  Adam G. Polak,et al.  Simulation of lung function evolution after heart-lung transplantation using a numerical model , 2005, IEEE Transactions on Biomedical Engineering.

[28]  Felipe Alonso Atienza,et al.  Avoiding the inverse crime in the Inverse Problem of electrocardiography: estimating the shape and location of cardiac ischemia , 2013, Computing in Cardiology 2013.