Energy efficient DC-grids for commercial buildings

Modern power electronics enable the efficient supply of almost all kinds of electric applications in commercial buildings, e. g. lighting, IT- and telecommunication equipment, as well as speed-controlled drives in heating, cooling and ventilation applications. This potential can be used more effectively using a 380 VDC Grid compared to a traditional AC Grid in commercial buildings. The European ENIAC R&D project consortium DC Components and Grid (DCC+G) is developing suitable, highly efficient components and sub systems for 380 VDC grid to show the benefits of DC grid concept on test site in an office environment. The newly developed DC Grid components and their integration into a generic system are presented in this paper. The targeted overall efficiency saving compared to AC grid is 5% and the energy conversion from PV is calculated to be 7% higher compared to traditional PV inverter conversion. This paper also shows the layout of the office demonstrator at Fraunhofer Institute in Erlangen, Germany, and describes general benefits of a DC Grid system.

[1]  P. Gammon,et al.  Silicon and the wide bandgap semiconductors, shaping the future power electronic device market , 2013, 2013 14th International Conference on Ultimate Integration on Silicon (ULIS).

[2]  Dustin J. Becker,et al.  400Vdc power distribution: Overcoming the challenges , 2010, Intelec 2010.

[3]  Stefan Zeltner,et al.  Converter impedance characterization for stability analysis of low-voltage DC-grids , 2014, ISGT 2014.

[4]  Leo Lorenz.  Fast switching power semiconductor devices and Smart Power IC´s: An enabling technology for future high efficient electronic system , 2010, Proceedings of 2010 International Symposium on VLSI Technology, System and Application.

[5]  Ulrich Boeke.  Impact of a ±380 V DC Power Grid Infrastructure on Commercial Building Energy Profiles , 2014 .

[6]  Christian Strobl.  Arc Fault Detection - a Model-based Approach , 2014 .

[8]  Johan Strydom,et al.  Design and evaluation of a 10 MHz gallium nitride based 42 V DC-DC converter , 2014, 2014 IEEE Applied Power Electronics Conference and Exposition - APEC 2014.

[9]  S. Waffler,et al.  Performance trends and limitations of power electronic systems , 2010, 2010 6th International Conference on Integrated Power Electronics Systems.

[10]  Krishna Shenai,et al.  Optimized trench MOSFET technologies for power devices , 1992 .

[11]  U. Boeke,et al.  Voltage stability assessment in semi-autonomous DC-grids with multiple power modules , 2013, 2013 15th European Conference on Power Electronics and Applications (EPE).

[12]  Anton Mauder,et al.  Hybrid switches in protective devices for low-voltage DC grids at commercial used buildings , 2014 .

[13]  U. Drofenik,et al.  PWM Converter Power Density Barriers , 2007 .

[14]  E. Carvou,et al.  Magnetic Blowing of Break Arcs up to 360 VDC , 2010, 2010 Proceedings of the 56th IEEE Holm Conference on Electrical Contacts.

[15]  Bantval J. Baliga,et al.  The future of power semiconductor device technology , 2001, Proc. IEEE.

[16]  J. Strydom,et al.  Understanding the effect of PCB layout on circuit performance in a high frequency gallium nitride based point of load converter , 2013, 2013 Twenty-Eighth Annual IEEE Applied Power Electronics Conference and Exposition (APEC).

[17]  Johan Strydom,et al.  Improving Performance of High Speed GaN Transistors Operating in Parallel for High Current Applications , 2014 .

[18]  David J. Perreault,et al.  Active EMI filters for automotive motor drives , 2002, Power Electronics in Transportation, 2002.